☆ 4.7 Article

Optimal design and performance improvement of an electric submersible pump impeller based on Taguchi approach

ENERGY (2022)

Related references

Note: Only part of the references are listed.

Article Energy & Fuels

Interstage difference of pressure pulsation in a three-stage electrical submersible pump

Yang Yang et al.

Summary: This study investigated the pressure pulsation characteristics inside a typical three-stage ESP based on numerical simulation and experiment measurement. The results showed good agreement between numerical predictions and experiment results. It was found that the dynamic and static interference between impeller and diffuser is the direct cause of pressure pulsations within the ESP.

JOURNAL OF PETROLEUM SCIENCE AND ENGINEERING (2021)

Add to Collection

Article Energy & Fuels

Experimental investigation of pressure drop in failed Electrical Submersible Pump (ESP) under liquid single-phase and gas-liquid two-phase flow

William Monte Verde et al.

Summary: This study focuses on estimating the pressure drop in a damaged ESP in deep offshore fields, using experimental measurements and adjusted empirical correlations. The results show a decreasing dependence between loss coefficient and Reynolds number, and the homogeneous model is suitable for predicting pressure drop at the ESP within the experimental matrix, with gas fractions up to 35%.

JOURNAL OF PETROLEUM SCIENCE AND ENGINEERING (2021)

Add to Collection

Article Mechanics

Comparison and validation of various turbulence models for U-bend flow with a magnetic resonance velocimetry experiment

Yong Han et al.

Summary: Turbulence modeling is essential for accurate prediction of turbulent fluid motion, and a new one-equation Wray-Agarwal (WA) turbulence model has been developed to improve predictions for turbulent flows with large separation and curvature. Comparison with other commonly used turbulence models shows that the WA model gives the highest accuracy in predicting the complex three-dimensional turbulent characteristics of flow with large curvature in a U-bend.

PHYSICS OF FLUIDS (2021)

Add to Collection

Article Energy & Fuels

The influence of waves propagating with the current on the wake of a tidal stream turbine

Yuquan Zhang et al.

Summary: The presence of wind-waves significantly influences the performance and wake structure of tidal-stream turbines, particularly in terms of swirl numbers and turbulence intensities in the near field. The analysis reveals that wave effects are more pronounced at the top-tip and rotor-centerline water depth levels, indicating axisymmetric turbulent conditions dominated by the axial turbulence component.

APPLIED ENERGY (2021)

Add to Collection

Review Computer Science, Interdisciplinary Applications

Theories and Applications of CFD-DEM Coupling Approach for Granular Flow: A Review

Mahmoud A. El-Emam et al.

Summary: This paper reviews the recent strategies and applications of the CFD-DEM coupling approach in aerodynamic systems of bio-particles, covering the definition of aerodynamic systems, modeling of particle motion, CFD-DEM coupling methodologies, drag correlation models, and applications in agriculture. The study indicates that CFD-DEM is a promising approach to study the behavior of bio-particulate matter in fluid flow, with potential benefits for optimizing device geometry and operations. Further developments and challenges in this field are also highlighted.

ARCHIVES OF COMPUTATIONAL METHODS IN ENGINEERING (2021)

Add to Collection

Article Green & Sustainable Science & Technology

Energy characteristics and optimal design of diffuser meridian in an electrical submersible pump

Yang Yang et al.

Summary: This study aimed to improve the energy performance of a typical three-stage ESP using Taguchi methods and numerical simulations. The optimization of the meridian within ESP diffuser was guided by analyzing the influence priority of different factors. Comparison before and after optimization showed the significant helpfulness of Taguchi test in optimizing the meridian within ESP diffuser.

RENEWABLE ENERGY (2021)

Add to Collection

Article Materials Science, Multidisciplinary

Incorporation of Taguchi approach with CFD simulations on laser welding of spacer grid fuel rod assembly

G. Satyanarayana et al.

Summary: This paper discusses the use of CFD simulations and Taguchi approach to identify optimal laser beam welding parameters for spacer grid fuel rod assembly. Empirical relations for weld-bead geometry based on process parameters are developed and validated with numerical simulations.

MATERIALS SCIENCE AND ENGINEERING B-ADVANCED FUNCTIONAL SOLID-STATE MATERIALS (2021)

Add to Collection

Article Engineering, Marine

Smoothing and expansion of the experimental mode shapes of an electrical submersible pump

R. H. R. Gutierrez et al.

Summary: The proposed methodology optimizes sets of finite element modes and experimental degrees of freedom to maximize the modal assurance criteria (MAC).

OCEAN ENGINEERING (2021)

Add to Collection

Article Thermodynamics

Optimization design of hydraulic performance in vaned mixed-flow pump

Di Zhu et al.

PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART A-JOURNAL OF POWER AND ENERGY (2020)

Add to Collection

Article Engineering, Mechanical

Numerical Study of Rotor-Stator Interaction of a Centrifugal Pump at Part Load With Special Emphasis on Unsteady Blade Load

Nicolas Casimir et al.

JOURNAL OF FLUIDS ENGINEERING-TRANSACTIONS OF THE ASME (2020)

Add to Collection

Article Engineering, Mechanical

Design optimization for mixed-flow pump impeller by improved suction performance and efficiency with variables of specific speeds

Sung Kim et al.

JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY (2020)

Add to Collection

Article Engineering, Mechanical

Solid-liquid two-phase flow and wear analysis in a large-scale centrifugal slurry pump

Guangjie Peng et al.

ENGINEERING FAILURE ANALYSIS (2020)

Add to Collection

Article Thermodynamics

Optimization of the hydrodynamic performance of a vertical Axis tidal (VAT) turbine using CFD-Taguchi approach

Mohammad Hassan Khanjanpour et al.

ENERGY CONVERSION AND MANAGEMENT (2020)

Add to Collection

Article Thermodynamics

Energy performance prediction of the centrifugal pumps by using a hybrid neural network

Renfang Huang et al.

ENERGY (2020)

Add to Collection

Article Thermodynamics

Design and optimization of power hubs for Brazilian off-shore oil production units

Jorge A. Vidoza et al.

ENERGY (2019)

Add to Collection

Article Engineering, Mechanical

Multiparameter and multiobjective optimization design of centrifugal pump based on orthogonal method

Yun Xu et al.

PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART C-JOURNAL OF MECHANICAL ENGINEERING SCIENCE (2017)

Add to Collection

Article Mechanics

Optimization design of multiphase pump impeller based on combined genetic algorithm and boundary vortex flux diagnosis

Jin-ya Zhang et al.

JOURNAL OF HYDRODYNAMICS (2017)

Add to Collection

Article Engineering, Mechanical

Investigation of Separation Phenomena in a Radial Pump at Reduced Flow Rate by Large-Eddy Simulation

Antonio Posa et al.

JOURNAL OF FLUIDS ENGINEERING-TRANSACTIONS OF THE ASME (2016)

Add to Collection

Article Energy & Fuels

Numerical investigation of the flow in a multistage electric submersible pump

H. Stel et al.

JOURNAL OF PETROLEUM SCIENCE AND ENGINEERING (2015)

Add to Collection

Article Engineering, Mechanical

Multiobjective Optimization Design of a Pump-Turbine Impeller Based on an Inverse Design Using a Combination Optimization Strategy

Wei Yang et al.

JOURNAL OF FLUIDS ENGINEERING-TRANSACTIONS OF THE ASME (2014)

Add to Collection

Article Energy & Fuels

Production Modeling in the Oil and Natural Gas Industry: An Application of Trend Analysis

G. Aydin

PETROLEUM SCIENCE AND TECHNOLOGY (2014)

Add to Collection

Article Computer Science, Interdisciplinary Applications

Numerical shape optimization of a centrifugal pump impeller using artificial bee colony algorithm

Shahram Derakhshan et al.

COMPUTERS & FLUIDS (2013)

Add to Collection

Article Thermodynamics

Performance Optimization in a Centrifugal Pump Impeller by Orthogonal Experiment and Numerical Simulation

Ling Zhou et al.

ADVANCES IN MECHANICAL ENGINEERING (2013)

Add to Collection

Article Energy & Fuels

Analysis and Mitigation Opportunities of Methane Emissions from the Energy Sector

G. Aydin et al.

ENERGY SOURCES PART A-RECOVERY UTILIZATION AND ENVIRONMENTAL EFFECTS (2012)

Add to Collection

Article Engineering, Mechanical

High-speed stereoscopic PIV study of rotating instabilities in a radial vaneless diffuser

A. Dazin et al.

EXPERIMENTS IN FLUIDS (2011)

Add to Collection

Article Engineering, Mechanical

Numerical Simulation and Evaluation of Velocity Fluctuations During Rotating Stall of a Centrifugal Pump

Andreas Lucius et al.

JOURNAL OF FLUIDS ENGINEERING-TRANSACTIONS OF THE ASME (2011)

Add to Collection

Article Computer Science, Interdisciplinary Applications

A CFD parametric study of geometrical variations on the pressure pulsations and performance characteristics of a centrifugal pump

R. Spence et al.

COMPUTERS & FLUIDS (2009)

Add to Collection

Article Economics

Integration of genetic algorithm, computer simulation and design of experiments for forecasting electrical energy consumption

A. Azadeh et al.

ENERGY POLICY (2007)

Add to Collection

Article Thermodynamics

Investigation of heat transfer and pressure drop in a concentric heat exchanger with snail entrance

A Durmus et al.

APPLIED THERMAL ENGINEERING (2002)

Add to Collection

© Peeref 2019-2024. All rights reserved.