4.7 Article

Hydrothermal cocarbonization of cellulose and organic matter of municipal sewage sludge for the preparation of supercapacitor carbon materials

Journal

BIOMASS & BIOENERGY
Volume 163, Issue -, Pages -

Publisher

PERGAMON-ELSEVIER SCIENCE LTD
DOI: 10.1016/j.biombioe.2022.106526

Keywords

Sewage sludge; Hydrolysis; Aqueous phase; Hydrothermal carbonization; Electrode material

Funding

  1. Foundation of State Key Laboratory of Biobased Material and Green Papermaking, Qilu University of Technology, Shandong Academy of Sciences [CZKF2020034]
  2. National Natural Science Foundation of China [21776063]

Ask authors/readers for more resources

Two types of aqueous phases prepared from hydrothermal carbonization of sewage sludge were cocarbonized with cellulose at different temperatures. The N content of the hydrochars was promoted by the N-heterocyclic compounds in the aqueous phase, while the O content was reduced. Increasing the temperature improved the incorporation of N into the aromatic rings. The derived N-doped carbons exhibited different properties depending on the O/N ratio. NC230280 showed the best performance in terms of specific capacitance, internal resistance, and time constant. The type of precursor and the elemental composition influenced the capacitance performance.
Two kinds of aqueous phases (AQ230 and AQAm230) prepared from hydrothermal carbonization of sewage sludge in pure water and aqueous ammonia, respectively, were separately hydrothermally cocarbonized with cellulose at 260, 280 and 300 ?. The N-heterocyclic compounds in the aqueous phase promoted the N content of the hydrochars while reducing their O content through a possible conversion of -C=O into -C=N-/C-N. With both AQ230 or AQAm230, increasing the temperature improved the incorporation of N into the aromatic rings, while the fluctuation in total N content in the hydrochars from each aqueous phase was not as remarkable. After KOH-activation of the hydrochars, the average pore diameter of the derived N-doped carbons (NCs) exhibited an increasing trend with increasing O/N ratio, especially at lower N-doping. A three-dimensional approximation confirmed that the specific surface area decreased when the C, N, and O content were high. In a three-electrode system, NC230280 exhibited the best performance, with a specific capacitance of 219.91 F g(-1) at 0.25 A g(-1) (63.64% retention at 20 A g(-1)), the lowest internal resistance (0.51 omega), and a small time constant (0.49 s). In a two-electrode system, NC230280 exhibited 176.72 F g(-1) at 0.25 A g(-1) (59.08% retention at 20 A g(-1)), and a maximum energy density of 6.14 Wh.kg(-1) was reached at a power density of 64 W kg(-1) (5.86 Wh.kg(-1) was still maintained at 518.07 W kg(-1)). The results reveal that, in addition to the surface properties, the type of precursor and the elemental composition of the NCs also influence the capacitance performance.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available