4.6 Article

The effect of pre-oxidation on the hot corrosion behavior of CoNiCrAlHf alloy in Na2SO4 environment at elevated temperature

Related references

Note: Only part of the references are listed.
Article Materials Science, Ceramics

Tribological performance and phase transition of MAX-phase/YSZ abradable seal coating produced by air plasma spraying

Rawaid Ali et al.

Summary: The addition of MAX-phase Ti3AlC2 can enhance the hardness and reduce the wear rate of the coating. The formation of tiny TiC and Al2O3 phases during plasma spraying contributes to the reduction of wear rate.

CERAMICS INTERNATIONAL (2022)

Article Materials Science, Coatings & Films

Experimental and modelling study on the β-phase depletion behaviour under the growth of spinel oxides and alumina in a CoNiCrAlY coating

H. Chen et al.

Summary: This paper presents an experimental and modeling study on the beta-phase depletion behavior in a vacuum plasma sprayed CoNiCrAlY coating during isothermal oxidation. The as-deposited coating retained the gamma + beta two-phase structure and formed a dual oxide layer during oxidation. The beta-phase depletion behavior was accurately modeled using software, showing good agreement with experimental measurements.

SURFACE & COATINGS TECHNOLOGY (2022)

Article Materials Science, Multidisciplinary

Physiochemical evaluations, mechanical attenuations and thermal stability of graphene nanosheets and functionalized nanodiamonds loaded pitch derived carbon foam composites

Muhammad Khan et al.

Summary: This work investigates the synergistic effects of graphene nanosheets and functionalized nanodiamonds on the properties of carbon foam composites. The addition of these additives significantly improves the structure and morphology of the composites, as well as their electrical, mechanical, and thermal properties. Among the composite samples studied, the CF/GNS-FND hybrid composites exhibit the highest in-plane electrical and thermal conductivities, as well as compressive strength and Young's modulus.

DIAMOND AND RELATED MATERIALS (2022)

Article Biotechnology & Applied Microbiology

Synthesis of novel nicotinamide susbstituted phthalocyanine and photodynamic antomicrobial chemotherapy evaluation potentiated by potassium iodide against the gram positive S. aureus and gram negative E. coli

Azeem Ullah et al.

Summary: The novel nicotinamide substituted phthlocyanine photosensitizer synthesized in this study showed efficient antibacterial properties under red light illumination, producing reactive oxygen species through a type-1 process. Furthermore, the addition of Potassium Iodide significantly enhanced the antibacterial effects of the PS, leading to a greater reduction in bacterial count.

BIOTECHNOLOGY LETTERS (2021)

Article Engineering, Mechanical

Transient thermal fatigue crack propagation prediction in a gas turbine component

B. Salehnasab et al.

Summary: This study investigated the thermal fatigue life of a detected crack on the edge of the pinhole of a gas turbine engine's hot gas path seal using finite element analysis and nondestructive testing methods. The predicted results were in good agreement with the actual situation.

ENGINEERING FAILURE ANALYSIS (2021)

Article Physics, Applied

First-principle-based structural and thermodynamic parameters of Ni-Al intermetallic compounds under different pressures and temperatures

Shabir Ali et al.

Summary: The thermodynamic parameters of Ni-Al intermetallic compounds under different pressures were studied using first-principles calculations and density functional theory. The results showed good agreement with experimental and theoretical results at zero pressure, and the relationships between the parameters at varying pressures and temperatures were also investigated using the quasi-harmonic Debye model.

MODERN PHYSICS LETTERS B (2021)

Review Environmental Sciences

Review on the hazardous applications and photodegradation mechanisms of chlorophenols over different photocatalysts

Amir Zada et al.

Summary: Chlorophenols are significant environmental pollutants that pose serious threats to aquatic and terrestrial organisms. Effective removal through photocatalytic degradation is crucial, with factors like pH and anion presence affecting the process. Production of different oxidizing agents and the degradation mechanism of chlorophenols by various photocatalysts have been discussed for future environmental protection measures.

ENVIRONMENTAL RESEARCH (2021)

Article Engineering, Mechanical

Analysis of structural changes in a gas turbine blade as a result of high temperature and stress

Jozef Blachnio et al.

Summary: The article investigates the internal cooling structure and microstructure of turbine rotor blades, revealing significant effects of creep at high temperatures. Blade end-face wear was found to be caused by high-temperature creep.

ENGINEERING FAILURE ANALYSIS (2021)

Article Polymer Science

Synergistic effect of nanodiamond and titanium oxide nanoparticles on the mechanical, thermal and electrical properties of pitch-derived carbon foam composites

Muhammad Khan et al.

Summary: The study demonstrates that FND particles are suitable for improving the fabrication of TO nanoparticles in CF, to establish a strong connection between the nanoparticles and CF for enhancing the mechanical, thermal, and electrical properties of CF composites.

POLYMER INTERNATIONAL (2021)

Article Thermodynamics

Paper title: thermochemical heat storage behavior of ZnSO4.7H2O under low-temperature

Ata Ur Rehman et al.

Summary: Research on ZnSO4 hydrated salt as a potential heat storage material for space heating applications has shown that it can release high heat at 100 degrees Celsius, demonstrating good thermal storage performance. However, agglomeration at higher temperatures may affect the hydration rate.

HEAT AND MASS TRANSFER (2021)

Article Materials Science, Multidisciplinary

Surface optimization of detonation nanodiamonds for the enhanced mechanical properties of polymer/nanodiamond composites

Muhammad Khan et al.

DIAMOND AND RELATED MATERIALS (2020)

Article Spectroscopy

Probing the physio-chemical appraisal of green synthesized PbO nanoparticles in PbO-PVC nanocomposite polymer membranes

Abdul Hamid et al.

SPECTROCHIMICA ACTA PART A-MOLECULAR AND BIOMOLECULAR SPECTROSCOPY (2020)

Article Chemistry, Physical

Functionalized nano diamond composites for photocatalytic hydrogen evolution and effective pollutant degradation

Muhammad Khan et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2020)

Article Materials Science, Multidisciplinary

Comparative study of the ball milling and acid treatment of functionalized nanodiamond composites

Muhammad Khan et al.

INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2018)

Article Materials Science, Multidisciplinary

Synergistic effect of organic and inorganic nano fillers on the dielectric and mechanical properties of epoxy composites

Muhammad Khan et al.

JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2018)

Article Metallurgy & Metallurgical Engineering

Effect of Titanium Addition on Alumina Growth Mechanism on Yttria-Containing FeCrAl-Base Alloy

Taihong Huang et al.

OXIDATION OF METALS (2018)

Article Metallurgy & Metallurgical Engineering

Kinetics of Al2O3-Scale Growth by Oxidation and Dissolution in Molten Silicate

Thomas Gheno et al.

OXIDATION OF METALS (2017)

Article Materials Science, Multidisciplinary

Reinforcement effect of acid modified nanodiamond in epoxy matrix for enhanced mechanical and electromagnetic properties

Muhammad Khan et al.

DIAMOND AND RELATED MATERIALS (2017)

Article Materials Science, Multidisciplinary

Effect of multi walled carbon nanotubes and diamond nanoparticles on the structure and properties of carbon foams

Muhammad Khan et al.

DIAMOND AND RELATED MATERIALS (2017)

Article Materials Science, Multidisciplinary

Dispersion behavior and the influences of ball milling technique on functionalization of detonated nano-diamonds

Muhammad Khan et al.

DIAMOND AND RELATED MATERIALS (2016)

Article Materials Science, Coatings & Films

Electrodeposition of Ni-Al2O3 composite coatings with combined addition of SDS and HPB surfactants

S. W. Jiang et al.

SURFACE & COATINGS TECHNOLOGY (2016)

Review Materials Science, Multidisciplinary

L12-Strengthened Cobalt-Base Superalloys

Akane Suzuki et al.

ANNUAL REVIEW OF MATERIALS RESEARCH, VOL 45 (2015)

Article Engineering, Manufacturing

Influence of Tool Materials on Machinability of Titanium- and Nickel-Based Alloys: A Review

Salman Pervaiz et al.

MATERIALS AND MANUFACTURING PROCESSES (2014)

Article Materials Science, Coatings & Films

Effect of oxygen content in NiCoCrAlY bondcoat on the lifetimes of EB-PVD and APS thermal barrier coatings

P. Song et al.

SURFACE & COATINGS TECHNOLOGY (2013)

Article Materials Science, Multidisciplinary

Oxidation mechanism of cobalt based alloy at high temperatures (800-1100°C)

H. Buscail et al.

CORROSION ENGINEERING SCIENCE AND TECHNOLOGY (2012)

Article Materials Science, Multidisciplinary

Effect of pre-oxidation on the hot corrosion of CoNiCrAlYRe alloy

L-C Chen et al.

CORROSION SCIENCE (2011)

Article Materials Science, Multidisciplinary

Hot corrosion behaviour of a cobalt-base super-alloy K40S with and without NiCrAlYSi coating

K. Zhang et al.

CORROSION SCIENCE (2011)

Article Materials Science, Multidisciplinary

High temperature cyclic oxidation and hot corrosion behaviours of superalloys at 900A°C

Subhash Kamal et al.

BULLETIN OF MATERIALS SCIENCE (2010)

Article Metallurgy & Metallurgical Engineering

Sulfur Segregation at Al2O3/γ-Iei plus γ'-Ni3Al Interfaces: Effects of Pt, Cr and Hf Additions

P. Y. Hou et al.

OXIDATION OF METALS (2009)

Article Chemistry, Physical

Recent developments in gas turbine materials and technology and their implications for syngas firing

I. G. Wright et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2007)

Article Metallurgy & Metallurgical Engineering

Pre-oxidation of Inconel alloys for inhibition of carbon deposition from heated jet fuel

Orhan Altin et al.

OXIDATION OF METALS (2006)

Article Engineering, Mechanical

Revisiting the inhibition of vanadium-induced hot corrosion in gas turbines

E Rocca et al.

JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME (2003)

Article Metallurgy & Metallurgical Engineering

Improvement in the oxidation resistance of an Al-deposited Fe-Cr-Al foil by preoxidation

S Taniguchi et al.

OXIDATION OF METALS (2002)

Article Materials Science, Coatings & Films

Cyclic oxidation of diffusion aluminide coatings on cobalt base super alloys

BM Warnes et al.

SURFACE & COATINGS TECHNOLOGY (2001)

Article Materials Science, Multidisciplinary

High-temperature oxidation behavior of aluminide coatings on a new cobalt-base superalloy in air

PS Liu et al.

CORROSION SCIENCE (2001)