4.8 Article

Lattice Boltzmann simulation of a gas diffusion layer with a gradient polytetrafluoroethylene distribution for a proton exchange membrane fuel cell

Related references

Note: Only part of the references are listed.
Article Energy & Fuels

Numerical Investigation of Tapered Flow Field Configurations for Enhanced Polymer Electrolyte Membrane Fuel Cell Performance

Yulin Wang et al.

Summary: The study proposed a tapered flow field configuration to enhance the performance of polymer electrolyte membrane fuel cells by improving oxygen transport and water removal. Numerical investigations showed that different LI/O ratios had varying effects on oxygen transport, water removal, and overall cell performance, with an optimal design exhibiting more uniform distributions and improved performance.

APPLIED ENERGY (2022)

Article Thermodynamics

Multi-sub-inlets at cathode flow-field plate for current density homogenization and enhancement of PEM fuel cells in low relative humidity

Yulin Wang et al.

Summary: This article investigates the use of multi-sub-inlet designs on the cathode flow-field plate of a polymer electrolyte membrane fuel cell to improve current density uniformity and overall cell performance. The results show that compared to conventional designs, the multi-sub-inlet design can improve oxygen distribution, enhance water removal capacity, and maintain a low pressure drop, leading to improved cell performance. Additionally, increasing the flow rate of the sub-inlets can further enhance the maximum power density while maintaining oxygen distribution uniformity.

ENERGY CONVERSION AND MANAGEMENT (2022)

Article Thermodynamics

Experimental investigation of heat pipe thermoelectric generator

Yulong Zhao et al.

Summary: Thermoelectric generators can generate electricity from low-temperature energy sources like solar and geothermal energy. Heat pipes are used to increase the hot end temperature of thermoelectric modules to improve conversion efficiency. Increasing heating power reduces thermal resistance and enhances efficiency, while adding more modules increases thermal resistance and decreases hot end temperature.

ENERGY CONVERSION AND MANAGEMENT (2022)

Review Thermodynamics

Pore-scale modeling of complex transport phenomena in porous media

Li Chen et al.

Summary: This review summarizes the recent advances and challenges in pore-scale modeling, discussing its practical applications in geoscience, polymer exchange membrane fuel cells, and solid oxide fuel cells. Notable results from pore-scale modeling are presented, while the challenges facing the development of pore-scale models are also discussed.

PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2022)

Article Thermodynamics

Optimal thermal management of server cooling system based cooling tower under different ambient temperatures

Wei He et al.

Summary: This study optimizes the thermal management of the internal server cooling cycle and external cold source water cycle in a data center to achieve significant power savings.

APPLIED THERMAL ENGINEERING (2022)

Article Thermodynamics

Structural optimization of thermoelectric modules in a concentration photovoltaic-thermoelectric hybrid system

Minghui Ge et al.

Summary: This study investigated the influence of the structural parameters of a thermoelectric generator on the system efficiency of a photovoltaic-thermoelectric hybrid system. An optimal structural parameter for the TEG was identified, along with an analysis of its relationship with CPV temperature coefficient, concentration ratio, and cooling heat transfer coefficient.

ENERGY (2022)

Article Chemistry, Physical

Enhancing water transport performance of gas diffusion layers through coupling manipulation of pore structure and hydrophobicity

X. L. Wang et al.

Summary: In this study, the hydrothermal decoration approach is used to enhance the hydrophobicity of a commercial GDL. The enhanced water discharge capacity of the GDL induced by hydrothermal decoration can enhance the water management performance of PEMFCs.

JOURNAL OF POWER SOURCES (2022)

Article Chemistry, Physical

Effect of water distribution in gas diffusion layer on proton exchange membrane fuel cell performance

Like Yue et al.

Summary: The study found that placing the hydrophobic area of the GDL on the channel in a fuel cell can improve performance by allowing water to accumulate more under the rib, while placing the hydrophobic area under the rib leads to a more uniform water distribution but decreased performance.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2021)

Article Green & Sustainable Science & Technology

Droplet dynamic characteristics on PEM fuel cell cathode gas diffusion layer with gradient pore size distribution

Yulin Wang et al.

Summary: This study comprehensively investigated droplet dynamic characteristics on fuel cell cathode GDL with gradient pore size distribution (GPSD). Results show that droplets have shorter detachment time and smaller detachment radius on superhydrophobic and superhydrophilic GDLs. Large pores can facilitate droplet detachment but also increase droplet detachment radius and pressure drop. Different GPSDs can reduce droplet detachment time and pressure drop.

RENEWABLE ENERGY (2021)

Article Thermodynamics

Experimental study on thermoelectric power generation based on cryogenic liquid cold energy

Minghui Ge et al.

Summary: This study designed and built a thermoelectric power generation system for cold energy. The experimental results showed that the temperature difference between the hot and cold ends increased in the liquid-phase and two-phase regions, but decreased and then increased in the gas-phase region. The poor heat transfer capacity at the hot end of the generator restricted the improvement of the temperature difference at the hot and cold ends.

ENERGY (2021)

Article Chemistry, Physical

Effect of wettability heterogeneity and compression on liquid water transport in gas diffusion layer coated with microporous layer of PEMFC

Y. Ira et al.

Summary: This study applied the pseudo-potential Lattice Boltzmann method to investigate liquid water transport in polymer electrolyte fuel cell. The research focused on the impact of hydrophilic carbon fibers in the gas diffusion layer on water saturation level and steady-state time, showing that they can lead to the formation of discontinuous water clusters. The presence of hydrophilic fibers may have both positive and negative effects on water transport in the GDL.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2021)

Article Chemistry, Physical

Surface roughness dominated wettability of carbon fiber in gas diffusion layer materials revealed by molecular dynamics simulations

X. L. Wang et al.

Summary: The study focuses on enhancing the surface hydrophobicity of commercial GDL through different methods, resulting in increased surface roughness and improved water removal capacity. By tailoring the surface roughness of carbon fibers in GDL materials, the water contact angle can be significantly increased to enhance water removal ability.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2021)

Article Chemistry, Physical

Effects of basic gas diffusion layer components on PEMFC performance with capillary pressure gradient

Jaebong Sim et al.

Summary: The design of the gas diffusion layer (GDL) plays a crucial role in the performance of polymer electrolyte membrane fuel cells (PEMFC), especially in terms of water discharge and capillary pressure gradient. By adjusting different element contents in GDL, the performance of PEMFC can be significantly affected, with differences observed under various conditions.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2021)

Article Thermodynamics

Study on the characteristics of GDL with different PTFE content and its effect on the performance of PEMFC

Tao Chen et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2019)

Article Chemistry, Physical

Impact of PTFE distribution across the GDL on the water droplet removal from a PEM fuel cell electrode containing binder

A. H. Kakaee et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2018)

Review Chemistry, Physical

Multi-phase models for water and thermal management of proton exchange membrane fuel cell: A review

Guobin Zhang et al.

JOURNAL OF POWER SOURCES (2018)

Article Chemistry, Physical

Neutron radiography measurements of in-situ PEMFC liquid water saturation in 2D & 3D morphology gas diffusion layers

Nathanial J. Cooper et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2017)

Article Chemistry, Physical

Impact of PTFE distribution on the removal of liquid water from a PEMFC electrode by lattice Boltzmann method

G. R. Molaeimanesh et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2014)

Article Chemistry, Physical

Microstructure reconstruction and characterization of PEMFC electrodes

Wei Wu et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2014)

Article Electrochemistry

Multianalytical Study of the PTFE Content Local Variation of the PEMFC Gas Diffusion Layer

Tatyana V. Reshetenko et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2013)

Article Chemistry, Physical

3D phase-differentiated GDL microstructure generation with binder and PTFE distributions

Michael M. Daino et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2012)

Article Electrochemistry

Visualizing Liquid Water Evolution in a PEM Fuel Cell Using Synchrotron X-ray Radiography

J. Hinebaugh et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2012)

Article Chemistry, Physical

Numerical modeling and experimental study of the influence of GDL properties on performance in a PEMFC

Jeong Hwan Chun et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2011)

Article Engineering, Chemical

Effect of PTFE content in gas diffusion layer based on Nafion®/PTFE membrane for low humidity proton exchange membrane fuel cell

Jie-Cheng Tsai et al.

JOURNAL OF THE TAIWAN INSTITUTE OF CHEMICAL ENGINEERS (2011)

Article Metallurgy & Metallurgical Engineering

Gas diffusion layer with PTFE gradients for effective water management in PEM fuel cells

R. Vijay et al.

TRANSACTIONS OF THE INDIAN INSTITUTE OF METALS (2011)

Article Chemistry, Physical

Review of the proton exchange membranes for fuel cell applications

S. J. Peighambardoust et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2010)

Article Thermodynamics

LIQUID WATER DYNAMIC BEHAVIORS IN THE GDL AND GC OF PEMFCS USING LATTICE BOLTZMANN METHOD

Li Chen et al.

FRONTIERS IN HEAT AND MASS TRANSFER (2010)

Article Engineering, Chemical

Liquid water transport in a mixed-wet gas diffusion layer of a polymer electrolyte fuel cell

Puneet K. Sinha et al.

CHEMICAL ENGINEERING SCIENCE (2008)

Article Electrochemistry

Characterization of gas diffusion layers for PEMFC

M. Han et al.

ELECTROCHIMICA ACTA (2008)