Related references
Note: Only part of the references are listed.Energy, exergy and environmental assessments of biodiesel and diesel fuels for an internal combustion engine using silicon carbide particulate filter
Ibrahim Yildiz et al.
JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2021)
Study on thermal performance of a PCM enhanced hydronic radiant floor heating system
Barbara Larwa et al.
ENERGY (2021)
The PCM-porous system used to cool the inclined PV panel
Juan Duan
RENEWABLE ENERGY (2021)
Empirical validation and comparison of methodologies to simulate micro and macro-encapsulated PCMs in the building envelope
Sajith Wijesuriya et al.
APPLIED THERMAL ENGINEERING (2021)
Phase change materials integrated into building walls: An updated review
B. Lamrani et al.
RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2021)
Mixing efficiency of hydrogen and air co-flow jets via wedge shock generator in dual-combustor ramjet
Yu Jiang et al.
AEROSPACE SCIENCE AND TECHNOLOGY (2021)
Design improvement of a laboratory prototype for efficiency evaluation of solar thermal water heating system using phase change material (PCMs)
Greg Wheatley et al.
RESULTS IN ENGINEERING (2021)
The influence of the wedge shock generator on the vortex structure within the trapezoidal cavity at supersonic flow
Zhixiong Li et al.
AEROSPACE SCIENCE AND TECHNOLOGY (2020)
The effect of sinusoidal wall on hydrogen jet mixing rate considering supersonic flow
Zhixiong Li et al.
ENERGY (2020)
Optimal design of a thermal energy storage system using phase change materials for a net-zero energy Solar Decathlon house
Wenye Lin et al.
ENERGY AND BUILDINGS (2020)
Thermoecologic Assessment and Life Cycle-Based Environmental Pollution Cost Analysis of Microgas Turbine
S. Kagan Ayaz et al.
JOURNAL OF ENVIRONMENTAL ENGINEERING (2020)
Thermal performance based optimization of an office wall containing PCM under intermittent cooling operation
Ekrem Tuncbilek et al.
APPLIED THERMAL ENGINEERING (2020)
Application of an active PCM storage system into a building for heating/cooling load reduction
Gohar Gholamibozanjani et al.
ENERGY (2020)
Investigation of energy performance and operational schemes of a Tibet-focused PCM-integrated solar heating system employing a dynamic energy simulation model
Juan Zhao et al.
ENERGY (2019)
Thermodynamic based economic and environmental analyses of an industrial cogeneration system
Hasan Caglayan et al.
APPLIED THERMAL ENGINEERING (2019)
Heat transfer and turbulent simulation of nanomaterial due to compound turbulator including irreversibility analysis
M. Sheikholeslami et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2019)
Thermo-ecological analysis of industrial kilns
Hasan Caglayan et al.
JOURNAL OF ENVIRONMENTAL MANAGEMENT (2019)
Improving the melting performance of a horizontal shell-tube latent-heat thermal energy storage unit using local enhanced finned tube
Shengxiang Deng et al.
ENERGY AND BUILDINGS (2019)
Effect of aspect ratio on saturated boiling flow in microchannels with nonuniform heat flux
Wen-Tao Yan et al.
HEAT TRANSFER-ASIAN RESEARCH (2019)
Numerical investigation of hydrodynamic and heat transfer performances of nanofluids in a fractal microchannel heat sink
Wen-Tao Yan et al.
HEAT TRANSFER-ASIAN RESEARCH (2019)
Lorentz forces effect on NEPCM heat transfer during solidification in a porous energy storage system
M. Sheikholeslami et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2018)
Evaluation of a novel solar driven sorption cooling/heating system integrated with PCM storage compartment
Mohammadreza Behi et al.
ENERGY (2018)
A review on applications of shape-stabilized phase change materials embedded in building enclosure in recent ten years
Na Zhu et al.
SUSTAINABLE CITIES AND SOCIETY (2018)
Thermo-Ecologic Evaluation of a Spray Dryer for Ceramic Industry
Hasan Caglayan et al.
SPECIAL ISSUE OF THE FOURTH INTERNATIONAL SYMPOSIUM ON HYDROGEN ENERGY, RENEWABLE ENERGY AND MATERIALS, 2018 (HEREM 2018) (2018)
Research on melting and solidification processes for enhanced double tubes with constant wall temperature/wall heat flux
Wei-Biao Ye et al.
HEAT TRANSFER-ASIAN RESEARCH (2018)
Sustainability assessment of heat exchanger units for spray dryers
Hasan Caglayan et al.
ENERGY (2017)
Establishment and experimental verification of TRNSYS model for PCM floor coupled with solar water heating system
Shilei Lu et al.
ENERGY AND BUILDINGS (2017)
A review on the air-PCM-TES application for free cooling and heating in the buildings
Muriel Iten et al.
RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2016)
Development and optimization of an innovative HVAC system with integrated PVT and PCM thermal storage for a net-zero energy retrofitted house
Massimo Fiorentini et al.
ENERGY AND BUILDINGS (2015)
Modeling a radiant floor system with Phase Change Material (PCM) integrated into a building simulation tool: Analysis of a case study of a floor heating system coupled to a heat pump
Javier Mazo et al.
ENERGY AND BUILDINGS (2012)
Review of PCM based cooling technologies for buildings
E. Osterman et al.
ENERGY AND BUILDINGS (2012)
Thermodynamic analyses and assessments of various thermal energy storage systems for buildings
Hakan Caliskan et al.
ENERGY CONVERSION AND MANAGEMENT (2012)