Related references
Note: Only part of the references are listed.Measurement and analysis of the radial motion error of aerostatic ultra-precision spindle
Hailong Cui et al.
MEASUREMENT (2019)
Error scaling of large-eddy simulation in the outer region of wall-bounded turbulence
Adrian Lozano-Duran et al.
JOURNAL OF COMPUTATIONAL PHYSICS (2019)
Full-Field Dependence on Inlet Modeling of Non-Isothermal Turbulent Jets Using Validated Large Eddy Simulations
Sasan Salkhordeh et al.
JOURNAL OF FLUIDS ENGINEERING-TRANSACTIONS OF THE ASME (2019)
Investigation the gas film in micro scale induced error on the performance of the aerostatic spindle in ultra-precision machining
Dongju Chen et al.
MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2018)
Chatter suppression techniques in metal cutting
J. Munoa et al.
CIRP ANNALS-MANUFACTURING TECHNOLOGY (2016)
Dynamic models for Large Eddy Simulation of compressible flows with a high order DG method
A. Abba et al.
COMPUTERS & FLUIDS (2015)
Improvement on load performance of externally pressurized gas journal bearings by opening pressure-equalizing grooves
Jianjun Du et al.
TRIBOLOGY INTERNATIONAL (2014)
An investigation into material-induced surface roughness in ultra-precision milling
S. J. Wang et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2013)
A theoretical and experimental investigation into multimode tool vibration with surface generation in ultra-precision diamond turning
S. J. Zhang et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2013)
A theoretical and experimental study of surface generation under spindle vibration in ultra-precision raster milling
S. J. Zhang et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2013)
Large eddy simulation of vortex shedding and pressure fluctuation in aerostatic bearings
Jincheng Zhu et al.
JOURNAL OF FLUIDS AND STRUCTURES (2013)
Dynamic characteristics of ultra-precision aerostatic bearings
Xue-Dong Chen et al.
ADVANCES IN MANUFACTURING (2013)
Modeling of dynamic characteristic of the aerostatic bearing spindle in an ultra-precision fly cutting machine
C. H. An et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2010)
Numerical calculations of pressure distribution in the bearing clearance of circular aerostatic thrust bearings with a single air supply inlet
Shigeka Yoshimoto et al.
JOURNAL OF TRIBOLOGY-TRANSACTIONS OF THE ASME (2007)
Effect of crystallographic orientation on wear of diamond tools for nano-scale ductile cutting of silicon
MS Uddin et al.
WEAR (2004)
Characterisation of nanosurface generation in single-point diamond turning
CF Cheung et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2001)
Optimization of feedrate in a face milling operation using a surface roughness model
DK Baek et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2001)
Share Paper
