Related references
Note: Only part of the references are listed.An improved contact model considered the effect of boundary lubrication regime on piston ring-liner contact for the two-stroke marine engines from the perspective of the Stribeck curve
Lyu Xiuyi et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART C-JOURNAL OF MECHANICAL ENGINEERING SCIENCE (2022)
A comprehensive experimental study on tribological performance of piston ring-cylinder liner pair
Zhan Liu et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART J-JOURNAL OF ENGINEERING TRIBOLOGY (2022)
The impact of helical slide honing on surface microtexture compared to plateau honing process through relevant characterization methods
Mohammed Yousfi et al.
MICROSCOPY RESEARCH AND TECHNIQUE (2022)
Optimizing the Mo concentration in low viscosity fully formulated oils
Aaron Thornley et al.
TRIBOLOGY INTERNATIONAL (2022)
Combined measurement and simulation of piston ring cylinder liner contacts with a reciprocating long-stroke tribometer
Bjorn Michelberger et al.
TRIBOLOGY INTERNATIONAL (2021)
Effect of Energy and Temperature on Tetrahedral Amorphous Carbon Coatings Deposited by Filtered Laser-Arc
Frank Kaulfuss et al.
MATERIALS (2021)
Interplay of mechanics and chemistry governs wear of diamond-like carbon coatings interacting with ZDDP-additivated lubricants
Valentin R. Salinas Ruiz et al.
NATURE COMMUNICATIONS (2021)
An investigation into the oil transport and starvation of piston ring pack
S. R. Bewsher et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART J-JOURNAL OF ENGINEERING TRIBOLOGY (2019)
Wear acceleration mechanism of diamond-like carbon (DLC) films lubricated with MoDTC solution: Roles of tribofilm formation and structural transformation in wear acceleration of DLC films lubricated with MoDTC solution
Hikaru Okubo et al.
TRIBOLOGY INTERNATIONAL (2019)
Oil distribution and oil film thickness within the piston ring-liner contact measured by laser-induced fluorescence in a reciprocating model test under starved lubrication conditions
Petra Obert et al.
TRIBOLOGY INTERNATIONAL (2019)
Mechano-chemical decomposition of organic friction modifiers with multiple reactive centres induces superlubricity of ta-C
Takuya Kuwahara et al.
NATURE COMMUNICATIONS (2019)
Critical role of a metallic counterpart on the tribochemical wear of ta-C coatings in base oil
Stephanie Lafon-Placette et al.
WEAR (2018)
Development of a test method for a realistic, single parameter-dependent analysis of piston ring versus cylinder liner contacts with a rotational tribometer
Julian Biberger et al.
TRIBOLOGY INTERNATIONAL (2017)
Friction and wear of a piston ring/cylinder liner at the top dead centre: Experimental study and modelling
B. Zabala et al.
TRIBOLOGY INTERNATIONAL (2017)
Tribochemical induced wear and ultra-low friction of superhard ta-C coatings
Stefan Makowski et al.
WEAR (2017)
The effect of cylinder liner operating temperature on frictional loss and engine emissions in piston ring conjunction
R. Rahmani et al.
APPLIED ENERGY (2017)
Assessment of friction from compression ring conjunction of a high-performance internal combustion engine: A combined numerical and experimental study
M. Gore et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART C-JOURNAL OF MECHANICAL ENGINEERING SCIENCE (2016)
The influence of oil supply and cylinder liner temperature on friction, wear and scuffing behavior of piston ring cylinder liner contacts - A new model test
Petra Obert et al.
TRIBOLOGY INTERNATIONAL (2016)
Surface-specific flow factors for prediction of friction of cross-hatched surfaces
M. Leighton et al.
SURFACE TOPOGRAPHY-METROLOGY AND PROPERTIES (2016)
Effects of Fresh Lubricant Oils on Particle Emissions Emitted by a Modern Gasoline Direct Injection Passenger Car
Liisa Pirjola et al.
ENVIRONMENTAL SCIENCE & TECHNOLOGY (2015)
On the boundary conditions in multi-phase flow through the piston ring-cylinder liner conjunction
H. Shahmohamadi et al.
TRIBOLOGY INTERNATIONAL (2015)
Quality Designed Twin Wire Arc Spraying of Aluminum Bores
Johannes Koenig et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2015)
A Generic Friction Model for Radial Slider Bearing Simulation Considering Elastic and Plastic Deformation
Gueter Offner et al.
LUBRICANTS (2015)
Lubricating Oil Dominates Primary Organic Aerosol Emissions from Motor Vehicles
David R. Worton et al.
ENVIRONMENTAL SCIENCE & TECHNOLOGY (2014)
Boundary Conditions for Elastohydrodynamics of Circular Point Contacts
M. Mohammadpour et al.
TRIBOLOGY LETTERS (2014)
The influence of piston ring geometry and topography on friction
N. Morris et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART J-JOURNAL OF ENGINEERING TRIBOLOGY (2013)
Friction Power Loss Simulation of Internal Combustion Engines Considering Mixed Lubricated Radial Slider, Axial Slider and Piston to Liner Contacts
Guenter Offner
TRIBOLOGY TRANSACTIONS (2013)
Global energy consumption due to friction in passenger cars
Kenneth Holmberg et al.
TRIBOLOGY INTERNATIONAL (2012)
Measurements of the surface microroughness with the scanning electron microscope
J. Paluszynski et al.
JOURNAL OF MICROSCOPY (2009)
Three-dimensional characterization of microstructures in a SEM
W Drzazga et al.
MEASUREMENT SCIENCE AND TECHNOLOGY (2006)
Mechanisms of MoS2 formation by MoDTC in presence of ZnDTP:: effect of oxidative degradation
MID Bouchet et al.
WEAR (2005)
Boundary lubrication mechanisms of carbon coatings by MoDTC and ZDDP additives
MI de Barros'Bouchet et al.
TRIBOLOGY INTERNATIONAL (2005)
Tribological characteristics and surface interaction between piston ring coatings and a blend of energy-con serving oils and ethanol fuels
SC Tung et al.
WEAR (2003)
Investigation of surface topography using a multidetector system in a SEM
D Kaczmarek
VACUUM (2001)
Review of power cylinder friction for diesel engines
DE Richardson
JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME (2000)
A study on variation in oil film thickness of a piston ring package: variation of oil film thickness in piston sliding direction
T Seki et al.
JSAE REVIEW (2000)
Share Paper
