Related references
Note: Only part of the references are listed.Hot deformation behaviour and microstructure evolution of Al-3% Mg2Si alloy
Min Hu et al.
MATERIALS CHARACTERIZATION (2022)
Influence of barium addition on the formation of primary Mg2Si crystals from Al-Mg-Si melts
Hamidreza Ghandvar et al.
JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2021)
Effect of solution treatment temperature on grain boundary composition and environmental hydrogen embrittlement of an Al-Zn-Mg-Cu alloy
Masoud Moshtaghi et al.
VACUUM (2021)
The contribution of aluminides to strength of Al-Mg2Si-Cu-Ni alloys at room and elevated temperatures
Yilin Sun et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2021)
High-temperature age-hardening behavior of Al-Mg-Si alloys with varying Sn contents
Gang Lu et al.
JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2021)
The effects of Cu, Zn and Zr on the solution temperature and quenching sensitivity of Al-Zn-Mg-Cu alloys
Yang-Chun Chiu et al.
MATERIALS CHEMISTRY AND PHYSICS (2020)
Microstructural characterization, solidification characteristics and tensile properties of Al-15%Mg2Si-x(Gd-Sb) in-situ composite
Hamidreza Ghandvar et al.
JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2020)
Synergistic effect of broken Mg2Si and sub-micron Mg17Al12 induced by EX- ECAP on the strength and ductility of deformed Mg-4Al-1Si-1Gd alloy
Xiangpeng Zhang et al.
JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2020)
Effect of solution-treating temperature on the intergranular corrosion of a peak-aged Al-Zn-Mg-Cu alloy
Zhixiu Wang et al.
JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2020)
Corrosion behavior of Al-15%Mg2Si alloy with 1% Ni addition
Yilin Sun et al.
RESULTS IN PHYSICS (2020)
Using novel strain aging kinetics models to determine the effect of solution temperature on critical strain of Al-Zn-Mg-Cu alloy
Pu Zhou et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2020)
Failures analysis of in-situ Al-Mg2Si composites using actual microstructure based model
Prosanta Biswas et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)
Effect of Cu addition on precipitation and age-hardening response of an Al-15%Mg2 Si alloy
Mengran Li et al.
MATERIALS CHARACTERIZATION (2020)
Microstructures and mechanical properties of Al-Mg2Si-Si alloys resistance spot welded with Al-Si interlayers
Qingdong Qin et al.
JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2019)
Effect of Ag addition on the precipitation evolution and interfacial segregation for Al-Mg-Si alloy
Yaoyao Weng et al.
ACTA MATERIALIA (2019)
High Performance of T6-Treated Al-15Mg2Si-3Cu Composite Reinforced with Spherical Primary Mg2Si after the Co-Modification of Bi plus Sr
Xueying Chong et al.
ADVANCED ENGINEERING MATERIALS (2019)
Influence of aging treatment on the microstructure, mechanical properties and anisotropy of hot extruded Al-Mg-Si plate
Liang Chen et al.
MATERIALS & DESIGN (2019)
Experimental and numerical study on the temperature sensitivity of the dynamic recrystallization activation energy and strain rate exponent in the JMAK model
Missam Irani et al.
JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2019)
Microstructural homogeneity, mechanical properties, and wear behavior of in situ Mg2Si particles reinforced Al–matrix composites fabricated by hot rolling
Dongtao Wang et al.
Journal of Materials Research and Technology-JMR&T (2019)
Intermetallic phase evolution and strengthening effect in Al-Mg2Si alloys with different Cu/Ni ratios
Yilin Sun et al.
MATERIALS LETTERS (2018)
Bake hardening behavior and precipitation kinetic of a novel Al-Mg-Si-Cu aluminum alloy for lightweight automotive body
Hui Li et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)
Effect of natural ageing and pre-straining on the hardening behaviour and microstructural response during artificial ageing of an Al-Mg-Si-Cu alloy
Deyan Yin et al.
MATERIALS & DESIGN (2016)
Optimization of the pre-aging treatment for an AA6022 alloy at various temperatures and holding times
Lipeng Ding et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2015)
Effects of TiB2 particles on aging behavior of in-situ TiB2/Al-Cu-Mg composites
Tianran Hong et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2015)
Influence of Natural Aging Time on Two-Step Aging Behavior of Al-Mg-Si(-Cu) Alloys
JaeHwang Kim et al.
MATERIALS TRANSACTIONS (2015)
The sequence of intermetallic formation and solidification pathway of an Al-13Mg-7Si-2Cu in-situ composite
Saeed Farahany et al.
MATERIALS CHARACTERIZATION (2014)
Precipitation kinetics of 2519A aluminum alloy based on aging curves and DSC analysis
Yi-ping Wu et al.
TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2014)
Effect of solution treatment and artificial aging on microstructure and mechanical properties of Al-Cu alloy
Jae-Ho Jang et al.
TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2013)
The effect of solution temperature on the microstructure and tensile properties of Al-15%Mg2Si composite
A. Malekan et al.
MATERIALS & DESIGN (2011)
Effect of solution temperature on aging behavior and properties of SiCp/Al-Cu-Mg composites
P. Jin et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2011)
Identification of σ and Ω phases in AA2009/SiC composites
P. Rodrigo et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2009)
Two types of S phase precipitates in Al-Cu-Mg alloys
S. C. Wang et al.
ACTA MATERIALIA (2007)
Analysis of aluminium based alloys by catorimetry: quantitative analysis of reactions and reaction kinetics
MJ Starink
INTERNATIONAL MATERIALS REVIEWS (2004)
Age-hardening behavior of a SiCw/A1-Li-Cu-Mg-Zr composite
SL Dong et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2002)
Share Paper
