Related references
Note: Only part of the references are listed.Numerical Study on Flow Field Distribution Regularities in Wet Gas Desulfurization Tower Changing Inlet Gas/Liquid Feature Parameters
Qingbo Deng et al.
JOURNAL OF ENERGY RESOURCES TECHNOLOGY-TRANSACTIONS OF THE ASME (2021)
Wet flue gas desulfurization performance of 330 MW coal-fired power unit based on computational fluid dynamics region identification of flow pattern and transfer process
Jiangyuan Qu et al.
CHINESE JOURNAL OF CHEMICAL ENGINEERING (2021)
CFD Analysis of a Water Vaporization Process in a Three-Dimensional Spouted Bed for Flue Gas Desulfurization
Jiali Du et al.
ACS OMEGA (2021)
Continuous SO2 absorption and desorption in regenerable flue gas desulfurization with ethylenediamine-phosphoric acid solution: A rate-based dynamic modeling
Jie Zhu et al.
FUEL (2021)
Mass transfer process intensification for SO2absorption in a commercial-scale wet flue gas desulfurization scrubber
Jiangyuan Qu et al.
CHEMICAL ENGINEERING AND PROCESSING-PROCESS INTENSIFICATION (2021)
Modeling and analysis of CO2 capture by aqueous ammonia plus piperazine blended solution in a spray column
Yin Xu et al.
SEPARATION AND PURIFICATION TECHNOLOGY (2021)
Eulerian-Eulerian Numerical Study of the Flue Gas Desulfurization Process in a Semidry Spouted Bed Reactor
Feng Wu et al.
ACS OMEGA (2020)
Fine particle removal from gas stream using a helical-duct dust concentrator: Numerical study
Sana Jamshidifard et al.
CHEMICAL ENGINEERING AND PROCESSING-PROCESS INTENSIFICATION (2019)
Eulerian-Eulerian numerical simulation for a flue gas desulfurization tower with perforated sieve trays
Chien-Chou Tseng et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2018)
Experimental and numerical study on effects of deflectors on flow field distribution and desulfurization efficiency in spray towers
Zhen Chen et al.
FUEL PROCESSING TECHNOLOGY (2017)
Investigation on the influence of injection direction on the spray cooling performance in natural draft dry cooling tower
Yubiao Sun et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2017)
Numerical investigation of the inertial loss coefficient and the porous media model for the flow through the perforated sieve tray
Chien-Chou Tseng et al.
CHEMICAL ENGINEERING RESEARCH & DESIGN (2016)
Numerical study of particle-induced Rayleigh-Taylor instability: Effects of particle settling and entrainment
Yi-Ju Chou et al.
PHYSICS OF FLUIDS (2016)
Flow uniformizing distribution panel design based on a non-uniform porosity distribution
M. K. Choi et al.
JOURNAL OF WIND ENGINEERING AND INDUSTRIAL AERODYNAMICS (2014)
Numerical modelling of the gas flow through perforated plates
B. Y. Guo et al.
CHEMICAL ENGINEERING RESEARCH & DESIGN (2013)
A New Model for the Simulation of Distillation Column
Li Wenbin et al.
CHINESE JOURNAL OF CHEMICAL ENGINEERING (2011)
Estimation of Numerical Errors Related to Some Basic Assumptions in Discrete Particle Methods
Sofiane Benyahia et al.
INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2010)
Multiphase Euler-Lagrange CFD simulation applied to Wet Flue Gas Desulphurisation technology
Luca Marocco et al.
INTERNATIONAL JOURNAL OF MULTIPHASE FLOW (2009)
CFD simulation with enhancement factor of sulfur dioxide absorption in the spray scrubber
Xiang Gao et al.
JOURNAL OF ZHEJIANG UNIVERSITY-SCIENCE A (2008)
Detailed modelling of a flue-gas desulfurisation plant
Antonio Gomez et al.
COMPUTERS & CHEMICAL ENGINEERING (2007)
Mass transfer and reaction process of the wet desulfurization reactor with falling film by cross-flow scrubbing
Juncong Sai et al.
KOREAN JOURNAL OF CHEMICAL ENGINEERING (2007)
Full-scale measurements of SO2 gas phase concentrations and slurry compositions in a wet flue gas desulphurisation spray absorber
HG Nygaard et al.
FUEL (2004)