Related references
Note: Only part of the references are listed.
Article
Thermodynamics
Ruming Pan et al.
Summary: This study investigated the ex-situ catalytic pyrolysis of waste polyethylene with activated carbon. The operating parameters and AC/WPE mass ratio had complex interactions on the oil and gas yields. A hybrid method of artificial neural network coupled with genetic algorithm was used to establish mathematical expressions and optimize the conditions for the highest oil yield. The experimental values were in good agreement with the predicted values, and the oil composition consisted of alkenes, naphthenes, alkanes, and aromatic hydrocarbons.
Article
Thermodynamics
Xueqiang Shi et al.
Summary: The study investigates the self-ignition and combustion characteristics of coal dust under inclination conditions using a two-step parallel oxidation reaction mechanism, providing a theoretical basis for the prevention and control of coal dust fires. Experimental results show that the self-ignition and combustion process of coal dust can be divided into five stages and the inclination angle affects the minimum ignition temperature, with coal dust deposited under the ceiling being more easily ignited.
Article
Engineering, Environmental
T. Fournie et al.
Summary: Smouldering treatment of sewage sludge, particularly when combined with sand or woodchips, offers an efficient method for phosphorus recapture with low release of potentially toxic elements in the resulting ash. Direct recovery of phosphorus can be achieved by acidic extraction, accounting for around 42% of retained phosphorus, or by emissions capture for up to 78% to 99% when co-smouldering with woodchips.
Article
Green & Sustainable Science & Technology
Shengtai Yan et al.
Summary: The smoldering of moist rice husk has potential for mass production of high quality silica directly from the husk.
Article
Thermodynamics
Shaorun Lin et al.
Summary: The study investigated the limiting quenching conditions of in-depth smoldering propagation, with simulation results agreeing well with experiments. Further analysis revealed that both the smoldering temperature and propagation rate increase with sample width and eventually approach their maximum values.
COMBUSTION AND FLAME
(2022)
Review
Thermodynamics
M. I. Jahirul et al.
Summary: This study reviewed the research findings of thermochemical conversion technologies of mixed waste plastics (MWP) into transport engine fuel. The study found that pyrolysis of MWP produces high oil yields and good fuel properties. However, certain types of plastics, such as polyethylene terephthalate and polyvinyl chloride, are not suitable for pyrolysis due to the production of harmful gases. Engine testing with MWP oil showed delayed combustion and higher emissions. Further research is needed to address the challenges and issues for industrial and commercial applications.
ENERGY CONVERSION AND MANAGEMENT
(2022)
Article
Thermodynamics
Ruming Pan et al.
Summary: This study proposes a novel smoldering-driven reactor for pyrolysis of plastic waste, using the heat from self-sustaining smoldering to produce oil and gas. The findings reveal that char smoldering can provide a stable propagating heat source for pyrolysis, and the concentration of char and air inlet velocity can regulate the duration and product yields of pyrolysis.
ENERGY CONVERSION AND MANAGEMENT
(2022)
Article
Thermodynamics
Joao Vitor F. Duque et al.
Summary: This study investigates the classical aspects of smoldering front propagation in an annular reactor, introducing new methodologies for calculating front velocity and determining combustion front regime. The experiments support the argument that annular reactor design is currently the best for recovering combustion heat. Different methods for calculating front velocity were used, revealing a gasification regime where the front structure showed downstream heat convection of the oxidation reaction resulting in increased bed temperature.
EXPERIMENTAL THERMAL AND FLUID SCIENCE
(2022)
Article
Energy & Fuels
Yibo Tang et al.
Summary: By using simulations and microstructure testing, the forward propagation of smoldering fires in different rank coals with varying particle sizes was investigated. It was found that as the particle size decreased, the pores > 10 nm, specific surface area, and pore volume increased, resulting in enhanced smoldering capability of coal. The critical minimum air-supply, activation energy, and maximum smoldering temperatures varied with particle size and coal type. Moisture content was identified as the dominant factor for smoldering spread during a certain stage.
Article
Energy & Fuels
Timothy Anderson et al.
Summary: This study applies a reaction model optimization workflow to calibrate seven different ISC reaction models and simulate the combustion of two heavy oil samples based on experimental data. The results indicate that reaction models with fewer reactions or parameters can equally or even better describe heavy oil combustion, and the number of stages of pseudocomponent decomposition is the most important aspect of a reaction model.
Article
Energy & Fuels
Zongwei Gan et al.
Summary: Smoldering combustion is an efficient method for organic waste treatment, and it has great advantages in oil sludge disposal by removing volatile petroleum hydrocarbons and recovering most of the metal elements.
Article
Chemistry, Applied
Zeyang Song et al.
Summary: The study explores the self-sustaining smoldering treatment for the destruction of food waste, focusing on cereal, vegetable, and meat waste. Results show that raw food waste with 40% moisture can be disposed by SSST with over 90% destruction ratio. However, the robustness of SSST is limited by heterogeneous issues, which can be addressed through pre-processing and supplementation of anthracite.
FUEL PROCESSING TECHNOLOGY
(2022)
Article
Energy & Fuels
Ruming Pan et al.
Summary: This study numerically investigates a smoldering-driven pyrolysis reactor and finds that it can destroy contaminants in sand through smoldering and sustain the process. The results also reveal that the reactor's pivotal operating characteristics can be regulated by adjusting critical parameters.
Article
Engineering, Environmental
Ruming Pan et al.
Summary: This study investigated the co-pyrolysis of waste polyethylene (WPE) and polystyrene (WPS) for oil production under different operating conditions. A hybrid model of artificial neural network-genetic algorithm (ANN-GA) was adopted to predict and optimize the co-pyrolysis oil yield and components. The results showed that high temperature, low polystyrene content, and low carrier gas flow rate were favorable for higher oil yield. The findings can guide the industrial process of waste plastic pyrolysis and the ANN-GA coupled with central-composite design can be used for regulating different target products under complex conditions.
JOURNAL OF ENVIRONMENTAL CHEMICAL ENGINEERING
(2022)
Article
Thermodynamics
Shaorun Lin et al.
Summary: This study investigates the extinguishing phenomenon in combustion, finding that the extinguishing diameter of combustion increases as the reactor diameter decreases. The minimum combustion temperature and propagation rate are found before extinguishing, and the oxygen supply uniquely affects the mode of combustion propagation.
PROCEEDINGS OF THE COMBUSTION INSTITUTE
(2021)
Article
Thermodynamics
Kai-Qi Zhong et al.
Summary: The study established a waste heat recovery system by using nanofluid working fluid and copper oxide nanoparticles to enhance thermal extraction efficiency. By optimizing the thermosiphon, the thermoelectric conversion efficiency was improved.
APPLIED THERMAL ENGINEERING
(2021)
Article
Engineering, Environmental
Marco A. B. Zanoni et al.
Summary: The use of thermal porous media reactors for environmental applications is increasing, and understanding the pressure increases within these systems is crucial for their success. Numerical modeling and experiments were used to quantify and explain the pressure increases during gas injection into smoldering treatment systems. Additionally, a new method was presented to estimate the maximum bed pressure drop for thermal porous media reactors.
CHEMICAL ENGINEERING JOURNAL
(2021)
Article
Thermodynamics
Shaorun Lin et al.
Summary: This study quantifies the propagation rates of smoldering combustion and the blow-off limits under external airflows up to 50 m/s. It finds that smoldering propagation rate first increases to its maximum value, then remains stable, and finally slightly decreases until blow-off. The blow-off airflow velocity of smoldering combustion is around ten times larger than that of flaming combustion, and it decreases as the fuel diameter or density increases.
COMBUSTION AND FLAME
(2021)
Article
Thermodynamics
Haiyan Yu et al.
Summary: A new mathematical model is introduced in this study to accurately calculate the radiative thermal conductivity of micro/nanoscale porous open cell structures, with the predicted values matching well with experimental results. Seven influential factors on thermal conductivity were extensively investigated, showing that the thermal conductivity is mainly affected by the extinction index and pore structure.
Article
Thermodynamics
Tarek L. Rashwan et al.
Summary: Smouldering combustion is an efficient waste-to-energy approach due to its ability to extract energy from problematic wastes and its low quenching temperature. Increasing reactor size leads to higher system energy efficiency, resulting in a more stable and sustainable reaction.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER
(2021)
Article
Energy & Fuels
Shawki Mazloum et al.
Summary: Plastic pyrolysis, as a method to convert plastic waste into fuels and chemicals, has been widely validated and applied at the lab scale, but there is limited literature on numerical modeling and optimization for industrial implementation. This study models and validates the heating and melting phenomena of plastics inside a semi-batch reactor using finite element method, laying the foundation for modeling the entire pyrolysis process.
Article
Engineering, Environmental
Xueqiang Shi et al.
Summary: The study investigated the self-ignition and smoldering characteristics of coal dust layers in inclined situations using a two-dimensional transient numerical model. Results showed significant effects of inclination angle and hot plate temperature on ignition delay time and minimum ignition temperature of coal dust.
PROCESS SAFETY AND ENVIRONMENTAL PROTECTION
(2021)
Article
Thermodynamics
Tarek L. Rashwan et al.
Summary: The study reveals that heat loss-induced non-uniform air flux significantly affects the smouldering propagation and cooling characteristics. Experimental results show an increase in air flux at the wall, causing non-uniform smouldering and cooling fronts. These non-uniform phenomena have a significant impact on the combustion process.
COMBUSTION AND FLAME
(2021)
Article
Thermodynamics
Ruming Pan et al.
Summary: This study investigated the interactive effects of temperature, residence time, and carrier gas flow rate on liquid fuel production through the pyrolysis of waste polyethylene (WPE). Experimental results showed a high predictive accuracy of the adaptive neural fuzzy model, and optimization using genetic algorithm maximized liquid fuel production under the optimal operating conditions.
ENERGY CONVERSION AND MANAGEMENT
(2021)
Article
Thermodynamics
Shawki Mazloum et al.
Summary: This study aims to model the plastic pyrolysis process at particle scale for polypropylene and high density polyethylene, using kinetic triplets and appropriate conditions in a thermogravimetric analyzer. The results show that modeling the melting sub-process using the modified apparent heat capacity method, and dividing the cracking phenomena into latent and apparent processes, can help control the error between simulated and measured results at a low level.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER
(2021)
Article
Thermodynamics
Tarek L. Rashwan et al.
Summary: With the increasing popularity of applied smouldering systems for energy conversion, there is a strong interest in optimizing reactor design to support robust smouldering. Heat losses play a critical role in the energy balance of smouldering systems and have implications for propagation limits and reactor design. Research shows that system energy efficiency is highly sensitive to improved insulation and increased radius up to a certain threshold, beyond which the sensitivity diminishes.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER
(2021)
Article
Energy & Fuels
Marco Maniscalco et al.
Summary: This study focused on the thermal degradation characteristics and kinetic of a plastic mixture primarily composed of LDPE and PP, finding that liquid yield increased with temperature while solid and gas phase yields decreased accordingly.
JOURNAL OF THE ENERGY INSTITUTE
(2021)
Article
Energy & Fuels
Zeyang Song et al.
INTERNATIONAL JOURNAL OF COAL GEOLOGY
(2020)
Article
Thermodynamics
Eirik G. Christensen et al.
COMBUSTION AND FLAME
(2020)
Review
Chemistry, Applied
Hons K. Wyn et al.
FUEL PROCESSING TECHNOLOGY
(2020)
Article
Thermodynamics
Hafiz M. F. Amin et al.
COMBUSTION AND FLAME
(2020)
Article
Engineering, Environmental
Alexandra L. Duchesne et al.
ENVIRONMENTAL SCIENCE & TECHNOLOGY
(2020)
Article
Thermodynamics
Marco A. B. Zanoni et al.
COMBUSTION AND FLAME
(2020)
Review
Thermodynamics
Jose L. Torero et al.
PROGRESS IN ENERGY AND COMBUSTION SCIENCE
(2020)
Article
Thermodynamics
Marco A. B. Zanoni et al.
COMBUSTION AND FLAME
(2019)
Article
Thermodynamics
Shuo Cheng et al.
Article
Energy & Fuels
Victor Pozzobon et al.
Article
Thermodynamics
Zoltan Till et al.
ENERGY CONVERSION AND MANAGEMENT
(2018)
Article
Energy & Fuels
Wei Chen et al.
Article
Chemistry, Physical
Muhammad Afzal Raja et al.
INTERNATIONAL JOURNAL OF HYDROGEN ENERGY
(2017)
Article
Thermodynamics
L. Yerman et al.
PROCEEDINGS OF THE COMBUSTION INSTITUTE
(2017)
Article
Energy & Fuels
Tanzeer Hasan et al.
Article
Energy & Fuels
M. Sennoune et al.
Article
Engineering, Environmental
A. Lopez-Urionabarrenechea et al.
CHEMICAL ENGINEERING JOURNAL
(2011)
Article
Thermodynamics
M. Sennoune et al.
COMBUSTION AND FLAME
(2011)
Article
Engineering, Environmental
C. Switzer et al.
ENVIRONMENTAL SCIENCE & TECHNOLOGY
(2009)
