Related references
Note: Only part of the references are listed.Influence of plastic deformation in fatigue crack behavior in bainitic steel
M. C. Marinelli et al.
INTERNATIONAL JOURNAL OF FATIGUE (2021)
Fundamentals and application of solid-state phase transformations for advanced high strength steels containing metastable retained austenite
Zongbiao Dai et al.
MATERIALS SCIENCE & ENGINEERING R-REPORTS (2021)
Nanostructured Bainitic Bearing Steel
Zhinan Yang et al.
ISIJ INTERNATIONAL (2020)
Mechanism of crack initiation and early growth of high strength steels in very high cycle fatigue regime
Qingyuan Song et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)
Microcrack initiation mechanism of a duplex stainless steel under very high cycle fatigue loading condition: The significance of load partitioning and micro residual stresses
Hongwang Fu et al.
ACTA MATERIALIA (2020)
Transformation-induced plasticity (TRIP) in advanced steels: A review
Maryam Soleimani et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)
EA4T railway axle steel fatigue behavior under very high-frequency fatigue loading
Stanislava Fintova et al.
ENGINEERING FAILURE ANALYSIS (2020)
Role of retained austenite with different morphologies on sub-surface fatigue crack initiation in advanced bainitic steels
Guhui Gao et al.
SCRIPTA MATERIALIA (2020)
Properties of the Fine Granular Area and Postulated Models for Its Formation during Very High Cycle Fatigue-A Review
Jan Patrick Sippel et al.
APPLIED SCIENCES-BASEL (2020)
Comparative micromechanics assessment of high-carbon martensite/bainite bearing steel microstructures using in-situ synchrotron X-ray diffraction
D. Foster et al.
MATERIALIA (2020)
Fatigue crack propagation modes: plastic deformation mode and damage accumulation mode
Shigeru Hamada et al.
INTERNATIONAL JOURNAL OF FRACTURE (2020)
Correlation between microstructure and yield strength of as-quenched and Q&P steels with different carbon content (0.06-0.42 wt%C)
Guhui Gao et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)
High-cycle and very-high-cycle fatigue behaviour of a titanium alloy with equiaxed microstructure under different mean stresses
Xiangnan Pan et al.
FATIGUE & FRACTURE OF ENGINEERING MATERIALS & STRUCTURES (2019)
Interior induced fatigue of surface-strengthened steel under constant and variable loading: Failure mechanism and damage modeling
W. Li et al.
FATIGUE & FRACTURE OF ENGINEERING MATERIALS & STRUCTURES (2019)
Microstructural effects on the sub-critical fatigue crack growth in nano-bainite
Avanish Kumar et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)
Effect of inclusion and microstructure on the very high cycle fatigue behaviors of high strength bainite/martensite multiphase steels
Guhui Gao et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)
Fatigue life and mechanistic modeling of interior micro-defect induced cracking in high cycle and very high cycle regimes
Ming-Liang Zhu et al.
ACTA MATERIALIA (2018)
A review about the effects of structural and operational factors on the gigacycle fatigue of steels
D. Jeddi et al.
FATIGUE & FRACTURE OF ENGINEERING MATERIALS & STRUCTURES (2018)
On the crystallographic, stage I-like, character of fine granular area formation in internal fish-eye fatigue cracks
H. Abdesselam et al.
INTERNATIONAL JOURNAL OF FATIGUE (2018)
The role of local plasticity during very high cycle fatigue crack initiation in high-strength steels
D. Spriestersbach et al.
INTERNATIONAL JOURNAL OF FATIGUE (2018)
Effect of stress ratio on very high cycle fatigue properties of Ti-10V-2Fe-3Al alloy with duplex microstructure
Ying Wu et al.
JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2018)
Study on microstructures and properties of carbide-free and carbide-bearing bainitic steels
Xiaoyan Long et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)
Cyclic deformation mechanisms and microcracks behavior in high-strength bainitic steel
M. C. Marinelli et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)
Bone-like crack resistance in hierarchical metastable nanolaminate steels
Motomichi Koyama et al.
SCIENCE (2017)
Mechanisms of fatigue crack growth - a critical digest of theoretical developments
P. Chowdhury et al.
FATIGUE & FRACTURE OF ENGINEERING MATERIALS & STRUCTURES (2016)
Very high cycle fatigue behaviors of bainite/martensite multiphase steel treated by quenching-partitioning-tempering process
Guhui Gao et al.
INTERNATIONAL JOURNAL OF FATIGUE (2016)
The formation mechanism of characteristic region at crack initiation for very-high-cycle fatigue of high-strength steels
Youshi Hong et al.
INTERNATIONAL JOURNAL OF FATIGUE (2016)
Rolling contact fatigue of bainitic rail steels: The significance of microstructure
Xiaolu Gui et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2016)
PTCLab: free and open-source software for calculating phase transformation crystallography
X. -F. Gu et al.
JOURNAL OF APPLIED CRYSTALLOGRAPHY (2016)
Cyclic deformation behaviors of a high strength carbide-free bainitic steel
F. C. Zhang et al.
MATERIALS & DESIGN (2016)
Microscopic and nanoscopic observations of metallurgical structures around inclusions at interior crack initiation site for a bearing steel in very high-cycle fatigue
T. Sakai et al.
FATIGUE & FRACTURE OF ENGINEERING MATERIALS & STRUCTURES (2015)
Formation of fine grained area in martensitic steel during very high cycle fatigue
G. Chai et al.
FATIGUE & FRACTURE OF ENGINEERING MATERIALS & STRUCTURES (2015)
On the role of microstructure in governing the fatigue behaviour of nanostructured bainitic steels
Rosalia Rementeria et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2015)
Effect of microstructure on the very high cycle fatigue behavior of a bainite/martensite multiphase steel
Ping Zhao et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2015)
Enhanced ductility and toughness in an ultrahigh-strength Mn-Si-Cr-C steel: The great potential of ultrafine filmy retained austenite
Guhui Gao et al.
ACTA MATERIALIA (2014)
Propensities of crack interior initiation and early growth for very-high-cycle fatigue of high strength steels
Youshi Hong et al.
INTERNATIONAL JOURNAL OF FATIGUE (2014)
Significance of crystallographic misorientation at phase boundaries for fatigue crack initiation in a duplex stainless steel during high and very high cycle fatigue loading
B. Doenges et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2014)
Dynamic and post-dynamic recrystallization under hot, cold and severe plastic deformation conditions
Taku Sakai et al.
PROGRESS IN MATERIALS SCIENCE (2014)
Axle fracture of an ICE3 high speed train
C. Klinger et al.
ENGINEERING FAILURE ANALYSIS (2013)
The physics of fatigue crack initiation
Michael D. Sangid
INTERNATIONAL JOURNAL OF FATIGUE (2013)
Effects of inclusions on very high cycle fatigue properties of high strength steels
S. X. Li
INTERNATIONAL MATERIALS REVIEWS (2012)
Effects of inclusion size and location on very-high-cycle fatigue behavior for high strength steels
Zhengqiang Lei et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2012)
Mechanism of fatigue crack initiation and propagation in the very high cycle fatigue regime of high-strength steels
P. Grad et al.
SCRIPTA MATERIALIA (2012)
Local plasticity exhaustion in a very high cycle fatigue regime
Guocai Chai et al.
SCRIPTA MATERIALIA (2012)
A physically based fatigue model for prediction of crack initiation from persistent slip bands in polycrystals
Michael D. Sangid et al.
ACTA MATERIALIA (2011)
Microstructural development during the quenching and partitioning process in a newly designed low-carbon steel
M. J. Santofimia et al.
ACTA MATERIALIA (2011)
Very high cycle fatigue - Is there a fatigue limit?
B. Pyttel et al.
INTERNATIONAL JOURNAL OF FATIGUE (2011)
The significance of microstructural barriers during fatigue of a duplex steel in the high- and very-high-cycle-fatigue (HCF/VHCF) regime
Ulrich Krupp et al.
INTERNATIONAL JOURNAL OF FATIGUE (2010)
Roles of microstructure in fatigue crack initiation
Kwai S. Chan
INTERNATIONAL JOURNAL OF FATIGUE (2010)
Characterization of microstructural damage due to low-cycle fatigue by EBSD observation
Masayuki Kamaya
MATERIALS CHARACTERIZATION (2009)
Subsurface crack initiation and propagation mechanism in high-strength steel in a very high cycle fatigue regime
K. Shiozawa et al.
INTERNATIONAL JOURNAL OF FATIGUE (2006)
The morphology and crystallography of lath martensite in alloy steels
S. Morito et al.
ACTA MATERIALIA (2006)
The formation of subsurface non-defect fatigue crack origins
Guocai Chai
INTERNATIONAL JOURNAL OF FATIGUE (2006)
Fatigue behaviour of duplex stainless steels in the very high cycle regime
Guocai Chai
INTERNATIONAL JOURNAL OF FATIGUE (2006)
Crystallography of upper bainite in Fe-Ni-C alloys
T. Furuhara et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2006)
An overview on bainite formation in steels
Zhi-Gang Yang et al.
CURRENT OPINION IN SOLID STATE & MATERIALS SCIENCE (2005)
Strain-induced martensitic transformation in fatigue crack tip zone for a high strength steel
CY Huo et al.
MATERIALS CHARACTERIZATION (2005)
Design of novel high strength bainitic steels: Part 1
FG Caballero et al.
MATERIALS SCIENCE AND TECHNOLOGY (2001)
Correlation of plastic deformation and dynamic recrystallization in magnesium alloy Zk60
A Galiyev et al.
ACTA MATERIALIA (2001)
Overview -: Residual stress part 2 -: Nature and origins
PJ Withers et al.
MATERIALS SCIENCE AND TECHNOLOGY (2001)
On the mechanism of fatigue failure in the superlong life regime (N>107 cycles).: Part I:: influence of hydrogen trapped by inclusions
Y Murakami et al.
FATIGUE & FRACTURE OF ENGINEERING MATERIALS & STRUCTURES (2000)
Share Paper
