4.7 Article

Low-fat akawi cheese made from bovine-camel milk blends: Rheological properties and microstructural characteristics

Journal

JOURNAL OF DAIRY SCIENCE
Volume 105, Issue 6, Pages 4843-4856

Publisher

ELSEVIER SCIENCE INC
DOI: 10.3168/jds.2021-21367

Keywords

camel milk; low-fat akawi cheese; rheological properties; gel-sol transition; proteolysis

Funding

  1. United Arab Emirates University

Ask authors/readers for more resources

In this study, the effect of blending bovine milk with camel milk on the physicochemical, rheological, and microstructural properties of low-fat akawi cheese was investigated. The blended cheeses showed improved moisture content, calcium content, and pH, as well as smooth microstructures compared to those made from bovine milk only. The rheological properties of the cheese were also enhanced by the addition of camel milk.
Camel milk (CM) can be used as an ingredient to produce various dairy products but it forms weak rennet-induced and acid-induced gels compared with bovine milk (BM). Therefore, in this study, we aimed to investigate the effect of blending bovine milk with camel milk on the physicochemical, rheological (amplitude sweep and frequency sweep), and microstructural properties of low-fat akawi (LFA) cheese. The cheeses were made of BM only or BM blended with 15% (CM15%) or 30% (CM30%) camel milk and stored at 4 & DEG;C for 28 d. The viscoelastic properties as a function of temperature were assessed. The LFA cheeses made from blended milks had higher moisture, total Ca, and soluble Ca contents, and had higher pH 4.6-watersoluble nitrogen compared with those made from BM. Analysis by scanning electron microscopy demonstrated that the microstructures formed in BM cheese were rough with granular surfaces, whereas those in blended milk cheeses had smooth surfaces. Hardness was lower for LFA cheeses made from blended milk than for those made from BM only. The LFA cheeses demonstrated viscoelastic behavior in a linear viscoelastic range from 0.1 to 1.0% strain. The storage modulus (G & PRIME;) was lower in LFA cheese made from BM over a range of frequencies. Adding CM reduced the resistance of LFA cheeses to flow as temperature increased. Blended cheeses exhibited lower complex viscosity values than BM cheeses during temperature increases. Thus, the addition of camel milk improved the rheological properties of LFA cheese.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available