4.6 Article

QUBIC VII: The feedhorn-switch system of the technological demonstrator

Related references

Note: Only part of the references are listed.
Article Astronomy & Astrophysics

QUBIC IV: Performance of TES bolometers and readout electronics

M. Piat et al.

Summary: This article reports on the performance and characterization of the readout chain and transition edge sensors (TES) in the prototype version of the QUBIC bolometric interferometer for cosmology. The results show that the device is capable of conducting bolometric interferometry.

JOURNAL OF COSMOLOGY AND ASTROPARTICLE PHYSICS (2022)

Article Astronomy & Astrophysics

QUBIC II: Spectral polarimetry with bolometric interferometry

L. Mousset et al.

Summary: Bolometric interferometry is a novel technique for spectral imaging, which can differentiate between the cosmic microwave background and astrophysical foregrounds. This paper illustrates the methodology using QUBIC and investigates point source reconstruction and Galactic dust mapping, as well as the noise properties of spectral imaging.

JOURNAL OF COSMOLOGY AND ASTROPARTICLE PHYSICS (2022)

Article Astronomy & Astrophysics

QUBIC I: Overview and science program

J. -Ch. Hamilton et al.

Summary: QUBIC is a novel polarimeter designed to measure the B-mode polarization of the CMB, addressing the challenge of observational cosmology. It combines the advantages of interferometry and bolometric detectors to control instrumental systematic effects and achieve wide-band sensitivity. This article provides an overview of the instrument design, calibration results, and scientific program, including measurements of both primordial B-modes and Galactic foregrounds. It also presents the forecast for typical observations, showing a statistical sensitivity of Sigma(r) = 0.015.

JOURNAL OF COSMOLOGY AND ASTROPARTICLE PHYSICS (2022)

Article Astronomy & Astrophysics

QUBIC V: Cryogenic system design and performance

S. Masi et al.

Summary: This study describes the design and experimental validation of the cryogenic system for the QUBIC experiment, which aims to measure the polarization of the Cosmic Microwave Background (CMB). The system has a large volume and mass, and uses cryogenic detector arrays and cold optical systems to enhance mapping speed. After more than 6 months of continuous operation testing, the system has been proven to operate stably.

JOURNAL OF COSMOLOGY AND ASTROPARTICLE PHYSICS (2022)

Article Astronomy & Astrophysics

QUBIC VIII: Optical design and performance

C. O'Sullivan et al.

Summary: QUBIC is a ground-based experiment aiming to detect B-mode polarization anisotropies in the CMB. It mitigates the systematic errors of ground-based observations using the novel technique of bolometric interferometry, which combines the sensitivity of an imager with the error control of an interferometer.

JOURNAL OF COSMOLOGY AND ASTROPARTICLE PHYSICS (2022)

Article Astronomy & Astrophysics

QUBIC VI: Cryogenic half wave plate rotator, design and performance

G. D'Alessandro et al.

Summary: This paper presents the design and testing results of a crucial optical element, half-wave plate (HWP), for the QUBIC experiment. The rotating precision of the QUBIC HWP reaches 0.15 degrees using a stepper motor and custom-made optical encoder, without causing any thermal issues during measurements. Finite element thermal simulations estimate a maximum temperature gradient within the HWP of <= 10 mK. Polarization modulation measurements at 150 GHz demonstrate a polarization efficiency of over 99%.

JOURNAL OF COSMOLOGY AND ASTROPARTICLE PHYSICS (2022)

Article Astronomy & Astrophysics

QUBIC III: Laboratory characterization

S. A. Torchinsky et al.

Summary: This article reports on an extensive test campaign of a prototype version of the QUBIC instrument in Paris, demonstrating the viability of bolometric interferometry for measurements of the CMB polarization.

JOURNAL OF COSMOLOGY AND ASTROPARTICLE PHYSICS (2022)

Article Astronomy & Astrophysics

A chemically etched corrugated feedhorn array for D-band CMB observations

S. Mandelli et al.

Summary: The study presents the design, manufacturing, and testing of a 37-element array of corrugated feedhorns for CMB measurements, manufactured by chemically etching aluminum plates. The process shows great potential for state-of-the-art CMB experiments.

EXPERIMENTAL ASTRONOMY (2021)

Article Astronomy & Astrophysics

QUBIC: Exploring the Primordial Universe with the Q&U Bolometric Interferometer

Aniello Mennella et al.

UNIVERSE (2019)

Article Physics, Multidisciplinary

Detection of B-Mode Polarization at Degree Angular Scales by BICEP2

P. A. R. Ade et al.

PHYSICAL REVIEW LETTERS (2014)

Article Astronomy & Astrophysics

Self-calibration: an efficient method to control systematic effects in bolometric interferometry

M. -A. Bigot-Sazy et al.

ASTRONOMY & ASTROPHYSICS (2013)

Article Astronomy & Astrophysics

THE Q/U IMAGING EXPERIMENT INSTRUMENT

C. Bischoff et al.

ASTROPHYSICAL JOURNAL (2013)

Article Physics, Applied

Optimizing Feedhorn-Coupled TES Polarimeters for Balloon and Space-Based CMB Observations

M. D. Niemack et al.

JOURNAL OF LOW TEMPERATURE PHYSICS (2012)

Proceedings Paper Astronomy & Astrophysics

A cryogenic set-up for accurate measurements of S-parameters

M. Zannoni et al.

MILLIMETER, SUBMILLIMETER, AND FAR-INFRARED DETECTORS AND INSTRUMENTATION FOR ASTRONOMY VI (2012)

Article Astronomy & Astrophysics

QUBIC: The QU bolometric interferometer for cosmology

E. Battistelli et al.

ASTROPARTICLE PHYSICS (2011)

Article Instruments & Instrumentation

W-band prototype of platelet feed-horn array for CMB polarisation measurements

F. Del Torto et al.

JOURNAL OF INSTRUMENTATION (2011)

Article Instruments & Instrumentation

Radiation patterns of multi-moded corrugated horns for far-IR space applications

JA Murphy et al.

INFRARED PHYSICS & TECHNOLOGY (2001)