Related references
Note: Only part of the references are listed.Automated vision system for magnetic particle inspection of crankshafts using convolutional neural networks
Karim Tout et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2021)
Using Axisymmetric Smoothed Finite Element Method (S-FEM) to Analyze Pressure Piping with Defect in ABAQUS
X. Cui et al.
INTERNATIONAL JOURNAL OF COMPUTATIONAL METHODS (2020)
Quantitative Evaluation of Crack Depths on Thin Aluminum Plate Using Eddy Current Pulse-Compression Thermography
Qiuji Yi et al.
IEEE TRANSACTIONS ON INDUSTRIAL INFORMATICS (2020)
Enhanced sizing for surface cracks in welded tubular joints using ultrasonic phased array and image processing
Liuyang Feng et al.
NDT & E INTERNATIONAL (2020)
Research on laser-generated Rayleigh waves with angled surface crack by finite element method
Wei Zeng et al.
OPTIK (2019)
Inspection of butt welds for complex surface parts using ultrasonic phased array
Wentao Li et al.
ULTRASONICS (2019)
Scattering of a Rayleigh wave by a near surface crack which is normal to the free surface
Chuanyong Wang et al.
INTERNATIONAL JOURNAL OF ENGINEERING SCIENCE (2019)
Ultra low-cycle fatigue performance of S420 and S700 steel welded tubular X-joints
Konstantinos Chatziioannou et al.
INTERNATIONAL JOURNAL OF FATIGUE (2019)
Development of the specular echoes estimator to predict relevant modes for Total Focusing Method imaging
Kombosse Sy et al.
NDT & E INTERNATIONAL (2018)
Depth Measurement of Small Surface-Breaking Cracks Using the Half-Skip Total Focusing Method
Maria V. Felice et al.
41ST ANNUAL REVIEW OF PROGRESS IN QUANTITATIVE NONDESTRUCTIVE EVALUATION, VOL 34 (2015)
Fatigue performance of tubular X-joints with PJP plus welds: II - Numerical investigation
Xudong Qian et al.
JOURNAL OF CONSTRUCTIONAL STEEL RESEARCH (2013)
Non-contact ultrasonic detection of angled surface defects
B. Dutton et al.
NDT & E INTERNATIONAL (2011)
An analysis of angled surface-breaking crack detection by dual-laser source generated ultrasound
Chenyin Ni et al.
NDT & E INTERNATIONAL (2010)
An approximate model for three-dimensional alternating current potential drop analyses using a commercial finite element code
Giuseppe Sposito et al.
NDT & E INTERNATIONAL (2010)
Simulation of ultrasonic phased array technique for imaging and sizing of defects using longitudinal waves
L. Satyanarayan et al.
INTERNATIONAL JOURNAL OF PRESSURE VESSELS AND PIPING (2007)
Rayleigh wave interaction with surface-breaking cracks
X. Jian et al.
JOURNAL OF APPLIED PHYSICS (2007)
Pulsed Rayleigh wave scattered at a surface crack
X. Jian et al.
ULTRASONICS (2006)
COMPUTATIONAL METHODS FOR GUIDED ULTRASONIC WAVES IN PLATES
Arvind Shah et al.
INTERNATIONAL JOURNAL OF COMPUTATIONAL METHODS (2006)
Post-processing of the full matrix of ultrasonic transmit-receive array data for non-destructive evaluation
C Holmes et al.
NDT & E INTERNATIONAL (2005)
Share Paper
