Related references
Note: Only part of the references are listed.A review on the progress and challenges of binder jet 3D printing of sand moulds for advanced casting
Tharmalingam Sivarupan et al.
ADDITIVE MANUFACTURING (2021)
Mechanical properties of 3D printed material with binder jet technology and potential applications of additive manufacturing in seismic testing of structures
Lorenzo Del Giudice et al.
ADDITIVE MANUFACTURING (2020)
Compressive and Tensile Behavior of 3D-Printed and Natural Sandstones
Matthew A. Perras et al.
TRANSPORT IN POROUS MEDIA (2019)
On the rapid manufacturing process of functional 3D printed sand molds
Saptarshee Mitra et al.
JOURNAL OF MANUFACTURING PROCESSES (2019)
Novel sprue designs in metal casting via 3D sand-printing
Santosh Reddy Sama et al.
ADDITIVE MANUFACTURING (2019)
Investigation of process parameter effect on anisotropic properties of 3D printed sand molds
Nicolas Coniglio et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2018)
3D PRINTED SMART MOLDS FOR SAND CASTING
Jason Walker et al.
INTERNATIONAL JOURNAL OF METALCASTING (2018)
The Design of 3D-Printed Lattice-Reinforced Thickness-Varying Shell Molds for Castings
Haolong Shangguan et al.
MATERIALS (2018)
Non-conventional mold design for metal casting using 3D sand-printing
Santosh Reddy Sama et al.
JOURNAL OF MANUFACTURING PROCESSES (2018)
A comparison of tensile failure in 3D-printed and natural sandstone
D. Vogler et al.
ENGINEERING GEOLOGY (2017)
3D-printed shell-truss sand mold for aluminum castings
Haolong Shangguan et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2017)
Perspective on 3D printing of separation membranes and comparison to related unconventional fabrication techniques
Ze-Xian Low et al.
JOURNAL OF MEMBRANE SCIENCE (2017)
3D printing for rapid sand casting-A review
Meet Upadhyay et al.
JOURNAL OF MANUFACTURING PROCESSES (2017)
Large deflection and rotation of Timoshenko beams with frictional end supports under three-point bending
Dao-Kui Li et al.
COMPTES RENDUS MECANIQUE (2016)
Foundry sand core property assessment by 3-point bending test evaluation
Bernhard J. Stauder et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2016)
Dynamic measurements of the load on gray cast iron castings and contraction of castings during cooling in furan sand molds
Naoya Marumoto et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2016)
Effect of molding parameters on chemically bonded sand mold properties
Himanshu Khandelwal et al.
JOURNAL OF MANUFACTURING PROCESSES (2016)
Effect of Binder Composition on the Shrinkage of Chemically Bonded Sand Cores
Himanshu Khandelwal et al.
MATERIALS AND MANUFACTURING PROCESSES (2015)
A verification of the thermal stress analysis, including the furan sand mold, used to predict the thermal stress in castings
Yuichi Motoyama et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2013)
Effects of layer thickness and binder saturation level parameters on 3D printing process
Mohammad Vaezi et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2011)
3D printing technique applied to rapid casting
Elena Bassoli et al.
RAPID PROTOTYPING JOURNAL (2007)