4.7 Article

Effect of pyrolysis temperature on blast furnace injection performance of biochar

Related references

Note: Only part of the references are listed.
Article Energy & Fuels

Evaluation of biomass-based production of below zero emission reducing gas for the iron and steel industry

Martin Hammerschmid et al.

Summary: By producing biomass-based reducing gas, it is possible to significantly reduce fossil CO2 emissions in the iron and steel sector in Austria, providing a feasible solution for environmental sustainability in the industry.

BIOMASS CONVERSION AND BIOREFINERY (2021)

Article Green & Sustainable Science & Technology

Influence mechanism and kinetic analysis of co-gasification of biomass char and semi-coke

Wang Liang et al.

Summary: The study found that the gasification reactivity of semi-coke is lower than bamboo reed char, but the addition of bamboo reed char can significantly enhance the gasification reaction performance. Experimental and theoretical results demonstrate the synergistic effect between bamboo reed char and semi-coke, and significant kinetic compensation effect was observed in the co-gasification reaction through kinetic fitting.

RENEWABLE ENERGY (2021)

Article Thermodynamics

Combustion behaviors of molded bamboo charcoal: Influence of pyrolysis temperatures

Wanhe Hu et al.

Summary: The study revealed that the combustion behaviors of bamboo charcoal were significantly influenced by pyrolysis temperatures, with changes in combustion characteristics observed as the temperature increased; volatile combustion disappeared at 350 degrees Celsius for bamboo charcoal; the maximum higher heating value of bamboo charcoal was reached at 650 degrees Celsius.

ENERGY (2021)

Article Green & Sustainable Science & Technology

Life-cycle assessment of the coal gasification-shaft furnace-electric furnace steel production process

Feng Li et al.

Summary: The CSE steelmaking technology has gained attention for its environmental and economic benefits, with a life cycle assessment showing lower environmental impacts compared to the traditional BF-BOF process. Key contributors to environmental impacts are the electric arc furnace, decarburization, pelletizing, and gas heating plants.

JOURNAL OF CLEANER PRODUCTION (2021)

Article Chemistry, Multidisciplinary

Kinetic Modeling of CO2 and H2O Gasification Reactions for Metallurgical Coke Using a Distributed Activation Energy Model

Yui Numazawa et al.

Summary: In this study, a distributed activation energy model (DAEM) was used to analyze the kinetic characteristics of CO2 and H2O gasification reactions for pulverized metallurgical coke. The results indicated that gasification occurs at the particle surface, with activation energy changing as the reaction progresses and being independent of particle size. The activation energies for CO2 and H2O gasification were found to range from 200-260 kJ/mol and 220-290 kJ/mol, respectively, with the frequency factor for H2O gasification being significantly higher than that for CO2 gasification.

ACS OMEGA (2021)

Review Green & Sustainable Science & Technology

A review on low carbon emissions projects of steel industry in the World

Xinyu Zhang et al.

Summary: In the context of global climate change, steel companies have become major contributors to greenhouse gas emissions. Many countries are focusing on emission reduction technologies in the steel industry, with various projects and initiatives aimed at optimizing the metallurgical industry and showcasing development direction and progress. This cutting-edge research is essential for shaping the future of the industry and addressing climate change.

JOURNAL OF CLEANER PRODUCTION (2021)

Review Green & Sustainable Science & Technology

A review of CO2 emissions reduction technologies and low-carbon development in the iron and steel industry focusing on China

Lei Ren et al.

Summary: China's iron and steel industry, as the largest producer and consumer of steel globally, plays a significant role in energy conservation and reducing greenhouse gas emissions. By combining technological improvements and ultra-low carbon technologies, the industry can achieve a substantial reduction in CO2 emissions and improve cost-effectiveness.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2021)

Article Green & Sustainable Science & Technology

Conversion mechanism and gasification kinetics of biomass char during hydrothermal carbonization

Wang Liang et al.

Summary: The hydrothermal carbonization (HTC) process can improve the gasification performance and physicochemical properties of corn cob, but reaction time and temperature still play important roles. HTC technology facilitates the conversion of biomass into solid fuel with high energy density, providing a theoretical basis for expanding the application field of hydrochar.

RENEWABLE ENERGY (2021)

Article Crystallography

Effect of Unburned Pulverized Coal on the Melting Characteristics and Fluidity of Blast Furnace Slag

Dongwen Xiang et al.

Summary: The presence of unburned pulverized coal affects the viscosity, free-running temperature, and viscous flow activation energy of blast furnace slag, mainly due to the formation of white particles composed of deposited carbon and high melting point solid solution, as well as the disintegration or polymerization of the Si(x)Oyz- structure.

CRYSTALS (2021)

Article Chemistry, Multidisciplinary

Comprehensive Study on the Feasibility of Pyrolysis Biomass Char Applied to Blast Furnace Injection and Tuyere Simulation Combustion

Han Dang et al.

Summary: This study comprehensively investigated the basic properties of 16 types of pyrolysis biomass char samples, showing that most samples meet the requirements of blast furnace injection fuel. Some of the char samples have the potential to be used as blast furnace injection fuel.

ACS OMEGA (2021)

Review Metallurgy & Metallurgical Engineering

Review of green and low-carbon ironmaking technology

Jun Zhao et al.

IRONMAKING & STEELMAKING (2020)

Article Engineering, Environmental

Charcoal production from waste pequi seeds for heat and power generation

Mara Rubia da Silva Miranda et al.

WASTE MANAGEMENT (2020)

Article Engineering, Environmental

Influence mechanism of alkali metals on CO2 gasification properties of metallurgical coke

Guangwei Wang et al.

CHEMICAL ENGINEERING JOURNAL (2020)

Article Green & Sustainable Science & Technology

Water-energy-carbon nexus assessment of China's iron and steel industry: Case study from plant level

Xiaozhuang Wang et al.

JOURNAL OF CLEANER PRODUCTION (2020)

Article Engineering, Environmental

Oxidation kinetics of biochar from woody and herbaceous biomass

Chad A. Peterson et al.

CHEMICAL ENGINEERING JOURNAL (2020)

Article Chemistry, Analytical

Influence of pyrolysis conditions and the nature of the wood on the quality of charcoal as a reducing agent

A. Dufourny et al.

JOURNAL OF ANALYTICAL AND APPLIED PYROLYSIS (2019)

Article Agricultural Engineering

Possibilities for CO2 emission reduction using biomass in European integrated steel plants

H. Mandova et al.

BIOMASS & BIOENERGY (2018)

Article Agricultural Engineering

Characteristics of co-hydrothermal carbonization on polyvinyl chloride wastes with bamboo

Zhongliang Yao et al.

BIORESOURCE TECHNOLOGY (2018)

Article Engineering, Chemical

Effect of pyrolysis temperature on pine sawdust chars and their gasification reactivity mechanism with CO2

Wei Tong et al.

ASIA-PACIFIC JOURNAL OF CHEMICAL ENGINEERING (2018)

Review Energy & Fuels

An Overview of Recent Developments in Biomass Pyrolysis Technologies

M. N. Uddin et al.

ENERGIES (2018)

Article Materials Science, Multidisciplinary

Combustion characteristics and kinetic analysis of co-combustion between bag dust and pulverized coal

Tao Xu et al.

INTERNATIONAL JOURNAL OF MINERALS METALLURGY AND MATERIALS (2018)

Article Metallurgy & Metallurgical Engineering

Influence of particle size on combustion behavior of bamboo char used for blast furnace injection

Run-sheng Xu et al.

JOURNAL OF IRON AND STEEL RESEARCH INTERNATIONAL (2018)

Article Thermodynamics

Isothermal kinetic analysis on fast pyrolysis of lump coal used in COREX process

Runsheng Xu et al.

JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2016)

Review Green & Sustainable Science & Technology

Biomass applications in iron and steel industry: An overview of challenges and opportunities

Elsayed Mousa et al.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2016)

Review Green & Sustainable Science & Technology

Lignocellulosic biomass pyrolysis: A review of product properties and effects of pyrolysis parameters

Tao Kan et al.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2016)

Article Green & Sustainable Science & Technology

The effect of temperature and compression during pyrolysis on the density of charcoal made from Australian eucalypt wood

Michael Somerville et al.

RENEWABLE ENERGY (2015)

Article Energy & Fuels

Fuel characterization and co-pyrolysis kinetics of biomass and fossil fuels

Mohammad S. Masnadi et al.

Review Green & Sustainable Science & Technology

A review on pyrolysis of biomass constituents: Mechanisms and composition of the products obtained from the conversion of cellulose, hemicelluloses and lignin

Francois-Xavier Collard et al.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2014)

Article Chemistry, Analytical

Study on the gas evolution and char structural change during pyrolysis of cotton stalk

Peng Fu et al.

JOURNAL OF ANALYTICAL AND APPLIED PYROLYSIS (2012)

Article Engineering, Chemical

Experimental study on the comprehensive behavior of combustion for blended coals

Yuangang Xu et al.

ASIA-PACIFIC JOURNAL OF CHEMICAL ENGINEERING (2010)

Article Engineering, Environmental

Compositions and sorptive properties of crop residue-derived chars

Y Chun et al.

ENVIRONMENTAL SCIENCE & TECHNOLOGY (2004)