Related references
Note: Only part of the references are listed.A strategy for synthetic microstructure generation and crystal plasticity parameter calibration of fine-grain-structured dual-phase steel
Wenqi Liu et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2020)
Mechanical and fracture behavior of high strength steels under high strain rate deformation: Experiments and modelling
T. Chiyatan et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)
Prediction of crack formation in the progressive folding of square tubes during dynamic axial crushing
Wenqi Liu et al.
INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES (2020)
Damage identification parameters of dual-phase 600-800 steels based on experimental void analysis and finite element simulations
Rafael Oliveira Santos et al.
JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2019)
Numerical modeling of the evolution of ductile damage under proportional and non-proportional loading
R. Fincato et al.
INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES (2019)
Experiments with the X0-specimen on the effect of non-proportional loading paths on damage and fracture mechanisms in aluminum alloys
Steffen Gerke et al.
INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES (2019)
Damage mechanism analysis of a high-strength dual-phase steel sheet with optimized fracture samples for various stress states and loading rates
Wenqi Liu et al.
ENGINEERING FAILURE ANALYSIS (2019)
Deformation behavior and microstructural evolution in ultra-high-strength dual-phase (UHS-DP1000) steel with different strain rates
Mei Xu et al.
JOURNAL OF IRON AND STEEL RESEARCH INTERNATIONAL (2019)
Stress-state and strain-rate dependent ductile fracture of dual and complex phase steel
Borja Erice et al.
MECHANICS OF MATERIALS (2018)
Determining the strain to fracture for simple shear for a wide range of sheet metals
Christian C. Roth et al.
INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES (2018)
Extension of the modified Bai-Wierzbicki model for predicting ductile fracture under complex loading conditions
B. Wu et al.
FATIGUE & FRACTURE OF ENGINEERING MATERIALS & STRUCTURES (2017)
Micromechanisms of deformation in dual phase steels at high strain rates
Anindya Das et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)
Calibration and application of ductile fracture criterion under non-proportional loading condition
Xincun Zhuang et al.
ENGINEERING FRACTURE MECHANICS (2016)
Biaxial experiments and phenomenological modeling of stress-state-dependent ductile damage and fracture
Michael Bruenig et al.
INTERNATIONAL JOURNAL OF FRACTURE (2016)
Effect of strain rate on flow stress and anisotropy of DP600, TRIP780, and AA5182-O sheet metal alloys
T. Rahmaan et al.
INTERNATIONAL JOURNAL OF IMPACT ENGINEERING (2016)
A nonlinear model for ductile damage accumulation under multiaxial non-proportional loading conditions
Luca Cortese et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2016)
A new model for upper shelf impact toughness assessment with a computationally efficient parameter identification algorithm
Denis Novokshanov et al.
ENGINEERING FRACTURE MECHANICS (2015)
Stress state dependence of ductile damage and fracture behavior: Experiments and numerical simulations
Michael Bruenig et al.
ENGINEERING FRACTURE MECHANICS (2015)
Ductile fracture of aluminum 2024-T351 under proportional and non-proportional multi-axial loading: Bao-Wierzbicki results revisited
Jessica Papasidero et al.
INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES (2015)
On the path-dependence of the fracture locus in ductile materials: Experiments
Shamik Basu et al.
INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES (2015)
Temperature and strain rate effects on the mechanical behavior of dual phase steel
Yu Cao et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2015)
Effect of strain rate on ductile fracture initiation in advanced high strength steel sheets: Experiments and modeling
Christian C. Roth et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2014)
Strain localization and damage in dual phase steels investigated by coupled in-situ deformation experiments and crystal plasticity simulations
C. C. Tasan et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2014)
A new finite element approach for modelling ductile damage void nucleation and growth-analysis of loading path effect on damage mechanisms
E. Roux et al.
MODELLING AND SIMULATION IN MATERIALS SCIENCE AND ENGINEERING (2014)
Experimental investigation of void coalescence in a dual phase steel using X-ray tomography
C. Landron et al.
ACTA MATERIALIA (2013)
A hybrid approach for modelling of plasticity and failure behaviour of advanced high-strength steel sheets
J. Lian et al.
INTERNATIONAL JOURNAL OF DAMAGE MECHANICS (2013)
On the Taylor-Quinney coefficient in dynamically phase transforming materials. Application to 304 stainless steel
R. Zaera et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2013)
Experimental study on high strain rate behavior of high strength 600-1000 MPa dual phase steels and 1200 MPa fully martensitic steels
Wurong Wang et al.
MATERIALS & DESIGN (2013)
Failure mechanisms in DP600 steel: Initiation, evolution and fracture
H. Ghadbeigi et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2013)
Mechanical behaviour of dual-phase high-strength steel under high strain rate tensile loading
Jingui Qin et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2013)
Strain rate dependent tensile behavior of advanced high strength steels: Experiment and constitutive modeling
Ji-Hoon Kim et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2013)
Novel Technique for Static and Dynamic Shear Testing of Ti6Al4V Sheet
J. Peirs et al.
EXPERIMENTAL MECHANICS (2012)
On the path-dependence of the fracture locus in ductile materials - Analysis
A. A. Benzerga et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2012)
Investigation of the Uncertainty of DIC Under Heterogeneous Strain States with Numerical Tests
Y. Wang et al.
STRAIN (2012)
Mechanisms of void formation during tensile testing in a commercial, dual-phase steel
J. Kadkhodapour et al.
ACTA MATERIALIA (2011)
Application of a split-Hopkinson tension bar in a mutual assessment of experimental tests and numerical predictions
Y. Chen et al.
INTERNATIONAL JOURNAL OF IMPACT ENGINEERING (2011)
Dynamic tensile behavior of multi phase high yield strength steel
N. K. Singh et al.
MATERIALS & DESIGN (2011)
Experiments on stress-triaxiality dependence of material behavior of aluminum alloys
Larissa Driemeier et al.
MECHANICS OF MATERIALS (2010)
Study of systematic errors in strain fields obtained via DIC using heterogeneous deformation generated by plastic FEA
P. Lava et al.
OPTICS AND LASERS IN ENGINEERING (2010)
Rate-dependent behavior and constitutive model of DP600 steel at strain rate from 10-4 to 103 s-1
Haidong Yu et al.
MATERIALS & DESIGN (2009)
Assessment of measuring errors in DIC using deformation fields generated by plastic FEA
P. Lava et al.
OPTICS AND LASERS IN ENGINEERING (2009)
Influence of specimen geometry on split Hopkinson tensile bar tests on sheet materials
P. Verleysen et al.
EXPERIMENTAL MECHANICS (2008)
A new model of metal plasticity and fracture with pressure and Lode dependence
Yuanli Bai et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2008)
Calibration of stress-triaxiality dependent crack formation criteria: A new hybrid experimental-numerical method
D. Mohr et al.
EXPERIMENTAL MECHANICS (2007)
Dual phase versus TRIP strip steels: comparison of dynamic properties for automotive crash performance
S. Oliver et al.
MATERIALS SCIENCE AND TECHNOLOGY (2007)
Effect of martensite plasticity on the deformation behavior of a low-carbon dual-phase steel
M. Mazinani et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2007)
Ductile damage evolution under triaxial state of stress: theory and experiments
N Bonora et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2005)
Effect of high strain rate deformation on microstructure of strip steels tested under dynamic tensile conditions
ND Beynon et al.
MATERIALS SCIENCE AND TECHNOLOGY (2005)
On fracture locus in the equivalent strain and stress triaxiality space
YB Bao et al.
INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES (2004)
Experimental investigation on the plasticity of hexagonal aluminum honeycomb under multiaxial loading
D Mohr et al.
JOURNAL OF APPLIED MECHANICS-TRANSACTIONS OF THE ASME (2004)
Systematic errors in digital image correlation caused by intensity interpolation
HW Schreier et al.
OPTICAL ENGINEERING (2000)