Related references
Note: Only part of the references are listed.The effect of spray angle on the combustion and emission performance of a separated swirl combustion system in a diesel engine
Haiqin Zhou et al.
ENERGY (2020)
Verifying the wall-flow-guided assumption of the lateral swirl combustion system in DI diesel engines
Yanlin Chen et al.
FUEL (2020)
Effect of retarded injection timing and EGR on performance, combustion and emission characteristics of a CRDi diesel engine fueled with WHDPE oil/diesel blends
D. Kulandaivel et al.
FUEL (2020)
An investigation into the impact of burning diesel/lubricant oil mixtures on the nature of particulate emissions: Implications for DPF ash-loading acceleration method
Mengzhu Zhang et al.
JOURNAL OF THE ENERGY INSTITUTE (2020)
Performance of a conventional diesel aftertreatment system used in a medium-duty multi-cylinder dual-mode dual-fuel engine
Antonio Garcia et al.
ENERGY CONVERSION AND MANAGEMENT (2019)
A study of swirl ratio effects on the NOx formation and mixture stratification in an RCCI engine
M. Dadsetan et al.
ENERGY (2019)
NOx model development and validation with diesel and hydrogen/diesel dual-fuel system on diesel engine
Madan Kumar et al.
ENERGY (2018)
Experimental and computational study on the effects of injection timing on thermodynamics, combustion and emission characteristics of a natural gas (NG)-diesel dual fuel engine at low speed and low load
Jun Shu et al.
ENERGY CONVERSION AND MANAGEMENT (2018)
Combined influence of injection timing and EGR on combustion, performance and emissions of DI diesel engine fueled with neat waste plastic oil
D. Damodharan et al.
ENERGY CONVERSION AND MANAGEMENT (2018)
Environmental, enviroeconomic and enhanced thermodynamic analyses of a diesel engine with diesel oxidation catalyst (DOC) and diesel particulate filter (DPF) after treatment systems
Hakan Caliskan et al.
ENERGY (2017)
Effects of fuel injection parameters on the performance of homogeneous charge compression ignition at low-load conditions
SeungHwan Keum et al.
INTERNATIONAL JOURNAL OF ENGINE RESEARCH (2016)
ANN-based modeling and reducing dual-fuel engine's challenging emissions by multi-objective evolutionary algorithm NSGA-II
S. Lotfan et al.
APPLIED ENERGY (2016)
Impact of fuel spray angles and injection timing on the combustion and emission characteristics of a high-speed diesel engine
Hyung Jun Kim et al.
ENERGY (2016)
Performance -emission optimization of a diesel-hydrogen dual fuel operation: A NSGA II coupled TOPSIS MADM approach
Madhujit Deb et al.
ENERGY (2016)
Optimization of combustion chamber geometry for natural gas engines with diesel micro-pilot-induced ignition
Bin Wang et al.
ENERGY CONVERSION AND MANAGEMENT (2016)
Multi-objective optimization of a natural aspirated three-cylinder spark ignition engine using modified non-dominated sorting genetic algorithm and multicriteria decision making
Mohammad Hassan Shojaeefard et al.
JOURNAL OF RENEWABLE AND SUSTAINABLE ENERGY (2016)
Multidimensional modeling of the effect of Exhaust Gas Recirculation (EGR) on exergy terms in an HCCI engine fueled with a mixture of natural gas and diesel
Samad Jafarmadar et al.
ENERGY CONVERSION AND MANAGEMENT (2015)
Experimental and theoretical analysis of effects of atomic, diatomic and polyatomic inert gases in air and EGR on mixture properties, combustion, thermal efficiency and NOx emissions of a pilot-ignited NG engine
Weifeng Li et al.
ENERGY CONVERSION AND MANAGEMENT (2015)
Combining artificial neural network and multi-objective optimization to reduce a heavy-duty diesel engine emissions and fuel consumption
Amir-Hasan Kakaee et al.
JOURNAL OF CENTRAL SOUTH UNIVERSITY (2015)
Experimental study of NOx reduction on a medium speed heavy duty diesel engine by the application of EGR (exhaust gas recirculation) and Miller timing
Roel Verschaeren et al.
ENERGY (2014)
Sensitivity of combustion noise and NOx and soot emissions to pilot injection in PCCI Diesel engines
A. J. Torregrosa et al.
APPLIED ENERGY (2013)
A hybrid method of modified NSGA-II and TOPSIS to optimize performance and emissions of a diesel engine using biodiesel
Mir Majid Etghani et al.
APPLIED THERMAL ENGINEERING (2013)
PFI (port fuel injection) of n-butanol and direct injection of biodiesel to attain LTC (low-temperature combustion) for low-emissions idling in a compression engine
Valentin Soloiu et al.
ENERGY (2013)
IMPROVEMENT OF EMISSIONS AND PERFORMANCE BY USING OF AIR JET, EXHAUST GAS RE-CIRCULATION AND INSULATION METHODS IN A DIRECT INJECTION DIESEL ENGINE
Samad Jafarmadar et al.
THERMAL SCIENCE (2013)
Experimental study of n-butanol addition on performance and emissions with diesel low temperature combustion
Quanchang Zhang et al.
ENERGY (2012)
A soot formation embedded reduced reaction mechanism for diesel surrogate fuel
Wenmiao Chen et al.
FUEL (2009)
Multiobjective Optimization Problems With Complicated Pareto Sets, MOEA/D and NSGA-II
Hui Li et al.
IEEE TRANSACTIONS ON EVOLUTIONARY COMPUTATION (2009)
Optimization of a hydrocarbon fuel ignition model for two single component surrogates of diesel fuel
V Hamosfakidis et al.
COMBUSTION AND FLAME (2003)
A fast and elitist multiobjective genetic algorithm: NSGA-II
K Deb et al.
IEEE TRANSACTIONS ON EVOLUTIONARY COMPUTATION (2002)