4.7 Article

Effects of different piston combustion chamber heights on heat transfer and energy conversion performance enhancement of a heavy- duty truck diesel engine

Related references

Note: Only part of the references are listed.
Article Energy & Fuels

Effects analysis on the catalytic combustion and heat transfer performance enhancement of a non-premixed hydrogen/air micro combustor

Jiaqiang E et al.

Summary: The study shows that in the catalytic combustor, homogeneous reactions are significantly weakened, resulting in higher and more uniform outer wall temperatures, better fluid mixing, and reduced temperature difference at the outer wall. Additionally, the catalytic combustor exhibits lower average flow velocity and pressure loss at an inlet velocity of 10 m/s.
Article Green & Sustainable Science & Technology

Effects analysis on heat dissipation characteristics of lithium-ion battery thermal management system under the synergism of phase change material and liquid cooling method

Feng Yi et al.

Summary: The study investigated the impact of parameters such as spacing, material content, battery direction, coolant flow rate, and pipe diameter on the performance of the composite cooling system, revealing that proper parameter configuration can effectively enhance the thermal performance of the system.

RENEWABLE ENERGY (2022)

Article Engineering, Environmental

NOx emission reduction in ammonia-powered micro-combustors by partially inserting porous medium under fuel-rich condition

Siliang Ni et al.

Summary: This study investigates the NOx emission performance in fuel-rich combustion of ammonia using micro combustors with double-rib structure partially inserted with porous medium. The results show that the porous medium can effectively reduce NO generation and emission under a larger inlet velocity. Increasing the thermal conductivity of the porous material can greatly decrease the emission of NO, but increase the emission of N2O. Additionally, increasing the porosity of the porous material leads to an increase in NO emission but a decrease in N2O emission.

CHEMICAL ENGINEERING JOURNAL (2022)

Article Green & Sustainable Science & Technology

Enhancing and assessing ammonia-air combustion performance by blending with dimethyl ether

Tao Cai et al.

Summary: This study investigates the impact of blending NH3 with DME on the laminar burning velocity of NH3/air flames, finding that the addition of DME significantly enhances the burning velocity of NH3 flames. This enhancement is primarily due to the combined thermal and chemical effects. Furthermore, in binary flames, the relative importance of termination and branching reactions increases with more DME blended.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2022)

Article Energy & Fuels

Numerical simulation study on soot continuous regeneration combustion model of diesel particulate filter under exhaust gas heavy load

Xiaohuan Zhao et al.

Summary: The study proposes a 3D soot continuous regeneration combustion model under exhaust gas heavy load using UDF function in FLUENT software, investigating 3 different models for simulation study with EDC model showing advantages in terms of turbulent kinetic energy and temperature. The results suggest that EDC model is more suitable for stable laminar flow state conditions.
Article Economics

The total cost of electric vehicle ownership: A consumer-oriented study of China's post-subsidy era

Danhua Ouyang et al.

Summary: This study analyzes the purchase cost of electric vehicles in China, finding that small EVs will achieve cost parity first, while PHEVs and large/medium-sized EVs will reach cost parity within the next few years. Despite decreasing purchase costs, most EV models will still not reach cost parity by 2030.

ENERGY POLICY (2021)

Review Thermodynamics

A review of studies using graphenes in energy conversion, energy storage and heat transfer development

Xiaohuan Zhao et al.

ENERGY CONVERSION AND MANAGEMENT (2019)

Review Energy & Fuels

Potential of acetone-butanol-ethanol (ABE) as a biofuel

Yuqiang Li et al.

Proceedings Paper Energy & Fuels

Life Cycle Analysis on Liquefied Natural Gas and Compressed Natural Gas in Heavy-duty Trucks with Methane Leakage Emphasized

Yuan Zhiyi et al.

INNOVATIVE SOLUTIONS FOR ENERGY TRANSITIONS (2019)

Article Engineering, Chemical

Development and application of an electric vehicles life-cycle energy consumption and greenhouse gas emissions analysis model

Tianduo Peng et al.

CHEMICAL ENGINEERING RESEARCH & DESIGN (2018)

Article Energy & Fuels

A novel solar-powered liquid piston Stirling refrigerator

Samuel Langdon-Arms et al.

APPLIED ENERGY (2018)

Article Energy & Fuels

A novel active free piston Stirling engine: Modeling, development, and experiment

A. R. Tavakolpour-Saleh et al.

APPLIED ENERGY (2017)

Review Energy & Fuels

A review of free-piston linear engines

Nguyen Ba Hung et al.

APPLIED ENERGY (2016)

Article Thermodynamics

Gas action effect of free piston Stirling engine

Jian Mou et al.

ENERGY CONVERSION AND MANAGEMENT (2016)

Article Economics

Carbon emissions in China: How far can new efforts bend the curve?

Xiliang Zhang et al.

ENERGY ECONOMICS (2016)

Article Thermodynamics

Optimal piston motion for maximum net output work of Daniel cam engines with low heat rejection

Viorel Badescu

ENERGY CONVERSION AND MANAGEMENT (2015)

Article Thermodynamics

Flow effects due to valve and piston motion in an internal combustion engine exhaust port

Bernhard Semlitsch et al.

ENERGY CONVERSION AND MANAGEMENT (2015)

Article Thermodynamics

Numerical investigation of piston bowl geometry and swirl ratio on emission from diesel engines

Abdul C. P. Gafoor et al.

ENERGY CONVERSION AND MANAGEMENT (2015)

Article Energy & Fuels

Energy efficient piston configuration for effective air motion - A CFD study

Antony Raj Gnana Sagaya Raj et al.

APPLIED ENERGY (2013)

Article Energy & Fuels

Double internal combustion piston engine

Zbyszko Kazimierski et al.

APPLIED ENERGY (2011)

Article Energy & Fuels

High swirl-inducing piston bowls in small diesel engines for emission reduction

B. V. V. S. U. Prasad et al.

APPLIED ENERGY (2011)

Article Energy & Fuels

Predictive piston motion control in a free-piston internal combustion engine

R. Mikalsen et al.

APPLIED ENERGY (2010)

Article Energy & Fuels

The control of a free-piston engine generator. Part 1: Fundamental analyses

R. Mikalsen et al.

APPLIED ENERGY (2010)

Article Energy & Fuels

A computational study of free-piston diesel engine combustion

R. Mikalsen et al.

APPLIED ENERGY (2009)

Article Energy & Fuels

Coupled dynamic-multidimensional modelling of free-piston engine combustion

R. Mikalsen et al.

APPLIED ENERGY (2009)