4.6 Article

Structure, mechanical properties and tribological behavior of sp2-C:Ti/sp3-C:Ti multilayer films deposited by magnetron sputtering

Related references

Note: Only part of the references are listed.
Article Materials Science, Coatings & Films

Electrodeposition and microstructure of Ni and B co-doped diamond-like carbon (Ni/B-DLC) films

Ya-gang Zhang et al.

Summary: Ni/B co-doped diamond-like carbon (Ni/B-DLC) films were synthesized on AZ91D magnesium alloy surface by electrodeposition under mild environment. The co-doping of Ni and B led to changes in the morphology and structure of the films, resulting in higher hardness and excellent wear resistance.

SURFACE & COATINGS TECHNOLOGY (2021)

Article Materials Science, Coatings & Films

Exploring long-run reciprocating Wear of diamond-like carbon coatings: microstructural, morphological and tribological evolution

Yefei Zhou et al.

Summary: The study found that a high hardness substrate can improve the performance of DLC coatings in the early stages of abrasion, and dispersed contact stress can reduce the tendency of structural transformation. As the number of abrasion cycles increases, the structural characteristics of DLC coatings tend to stabilize.

SURFACE & COATINGS TECHNOLOGY (2021)

Article Materials Science, Coatings & Films

Investigation on cavitation erosion of diamond-like carbon films with heterogeneous multilayer structure

Feng Cheng et al.

Summary: Cavitation tests were conducted on three heterogeneous multilayer DLC films to evaluate their erosion resistance, showing that Ti/DLC film had the lowest erosion area. The presence of titanium as an adhesion layer improved adhesion strength, reduced residual stress, and decreased cracks within the films. Lower I-D/I-G ratio was also found to enhance fatigue resistance in the steady phase.

SURFACE & COATINGS TECHNOLOGY (2021)

Article Engineering, Mechanical

Tribocorrosion behavior of Ti6Al4V alloy after thermo-chemical treatment and DLC deposition for biomedical applications

Jacek Grabarczyk et al.

Summary: A combined surface modification method involving the deposition of carbon coating on thermally treated titanium alloy was proposed in this study. The oxidized and then DLC-coated samples showed the most outstanding results, enhancing low surface friction and coating durability, while maintaining high corrosion resistance.

TRIBOLOGY INTERNATIONAL (2021)

Article Engineering, Mechanical

Comparative study on microstructure, bio-tribological behavior and cytocompatibility of Cr-doped amorphous carbon films for Co-Cr-Mo artificial lumbar disc

Dingding Xiang et al.

Summary: The study compared the microstructure, bio-tribological behavior, and cytocompatibility of a-C:Cr films deposited on Co-Cr-Mo substrates using UBMS and PECVD methods. Results showed that UBMS a-C:Cr film had better lubrication and lower wear, while both films significantly improved the cytocompatibility of Co-Cr-Mo alloy.

TRIBOLOGY INTERNATIONAL (2021)

Article Chemistry, Multidisciplinary

Mechanical Properties and Biocompatibility of Ti-doped Diamond-like Carbon Films

Mengqi Zhang et al.

ACS OMEGA (2020)

Article Materials Science, Multidisciplinary

Elements-Added Diamond-Like Carbon Film for Biomedical Applications

Narin Sunthornpan et al.

ADVANCES IN MATERIALS SCIENCE AND ENGINEERING (2019)

Article Materials Science, Coatings & Films

Microstructure and properties of DLC/CNx films with different CNx sublayer thicknesses

Fang-er Yang et al.

SURFACE & COATINGS TECHNOLOGY (2019)

Article Materials Science, Coatings & Films

Improved adhesion of a-C and a-C:H films with a CrC interlayer on 16MnCr5 by HiPIMS-pretreatment

Wolfgang Tillmann et al.

SURFACE & COATINGS TECHNOLOGY (2019)

Article Engineering, Mechanical

Origin of low friction for amorphous carbon films with different hydrogen content in nitrogen atmosphere

Jingjing Wang et al.

TRIBOLOGY INTERNATIONAL (2019)

Review Chemistry, Multidisciplinary

Conductive diamond: synthesis, properties, and electrochemical applications

Nianjun Yang et al.

CHEMICAL SOCIETY REVIEWS (2019)

Article Chemistry, Physical

Electrical properties of multilayer (DLC-TiC) films produced by pulsed laser deposition

Raad A. Alawajji et al.

APPLIED SURFACE SCIENCE (2018)

Article Materials Science, Multidisciplinary

Adhesion and multipass scratch characterization of Ti:Ta-DLC composite coatings

Hikmet Cicek et al.

DIAMOND AND RELATED MATERIALS (2018)

Article Engineering, Mechanical

Stress Assessment in Artistic Materials Using a Micro-Scratching Technique

L. Krzemien et al.

EXPERIMENTAL TECHNIQUES (2018)

Article Materials Science, Coatings & Films

Adhesion enhancement of DLC hard coatings by HiPIMS metal ion etching pretreatment

J. A. Santiago et al.

SURFACE & COATINGS TECHNOLOGY (2018)

Article Engineering, Biomedical

Diamond-like carbon coatings with zirconium-containing interlayers for orthopedic implants

Dipankar Choudhury et al.

JOURNAL OF THE MECHANICAL BEHAVIOR OF BIOMEDICAL MATERIALS (2017)

Article Instruments & Instrumentation

Ion irradiation-induced, localized sp2 to sp3 hybridized carbon transformation in walls of multiwalled carbon nanotubes

Reetu Kumari et al.

NUCLEAR INSTRUMENTS & METHODS IN PHYSICS RESEARCH SECTION B-BEAM INTERACTIONS WITH MATERIALS AND ATOMS (2017)

Article Materials Science, Coatings & Films

The composition, structure and surface properties of the titanium-carbon coatings prepared by PVD technique

A. P. Rubshtein et al.

SURFACE & COATINGS TECHNOLOGY (2017)

Article Materials Science, Coatings & Films

Deposition of W/a-C:H:Zr and W/a-C:H:W multilayer coatings on substrate made of porous graphite by arc - Electron beam hybrid method

Maria Richert et al.

SURFACE & COATINGS TECHNOLOGY (2016)

Article Materials Science, Coatings & Films

Effects of Ti content on microstructure, mechanical and tribological properties of Ti-doped amorphous carbon multilayer films

W. Q. Bai et al.

SURFACE & COATINGS TECHNOLOGY (2015)

Article Materials Science, Multidisciplinary

Influence of duty cycle on microstructure, tribological and corrosion behaviors of a-C/a-C:Ti multilayer films

W. Q. Bai et al.

THIN SOLID FILMS (2015)

Article Materials Science, Multidisciplinary

Surface, microstructure and optical properties of copper-doped diamond-like carbon coating deposited in pulsed cathodic arc plasma

Alexander S. Chaus et al.

DIAMOND AND RELATED MATERIALS (2014)

Article Materials Science, Coatings & Films

Toward hard yet tough ceramic coatings

Yu Xi Wang et al.

SURFACE & COATINGS TECHNOLOGY (2014)

Article Materials Science, Multidisciplinary

Doped diamond electrodes on titanium substrates with controlled sp2/sp3 hybridization at different boron levels

F. L. Migliorini et al.

THIN SOLID FILMS (2014)

Article Materials Science, Multidisciplinary

Cell response and corrosion behavior of electrodeposited diamond-like carbon films on nanostructured titanium

T. M. Manhabosco et al.

CORROSION SCIENCE (2013)

Article Materials Science, Coatings & Films

Influence of carbon content on the microstructure and tribological properties of TiN(C) coatings in water lubrication

Qianzhi Wang et al.

SURFACE & COATINGS TECHNOLOGY (2012)

Article Engineering, Mechanical

Scratch resistance and tribological properties of DLC coatings under dry and lubrication conditions

Neha Sharma et al.

TRIBOLOGY INTERNATIONAL (2012)

Article Materials Science, Coatings & Films

Microstructure and mechanical properties of carbon nitride multilayer films deposited by DC magnetron sputtering

D. G. Liu et al.

SURFACE & COATINGS TECHNOLOGY (2011)

Article Chemistry, Physical

Improving mechanical properties of a-CNx films by Ti-TiN/CNx gradient multilayer

D. G. Liu et al.

APPLIED SURFACE SCIENCE (2010)

Article Materials Science, Coatings & Films

Effect of process parameters on mechanical and tribological performance of pulsed-DC sputtered TiC/a-C:H nanocomposite films

K. P. Shaha et al.

SURFACE & COATINGS TECHNOLOGY (2010)

Article Materials Science, Coatings & Films

Microstructure, mechanical and tribological properties of CrN/W2N multilayer films deposited by DC magnetron sputtering

R. L. Li et al.

SURFACE & COATINGS TECHNOLOGY (2009)

Article Materials Science, Coatings & Films

Adhesion and elasticity of plasma deposited wear resistant a-C:H coatings on nickel-titanium

Lorenz Gerke et al.

SURFACE & COATINGS TECHNOLOGY (2009)

Article Materials Science, Coatings & Films

Characterization of fatigue and adhesion properties of a-C:H/CrN coatings on bearing rings by impact tests

K. -D. Bouzakis et al.

SURFACE & COATINGS TECHNOLOGY (2008)

Article Physics, Applied

Improving mechanical properties of amorphous carbon nitride films by titanium doping

P. Xu et al.

JOURNAL OF APPLIED PHYSICS (2007)

Article Materials Science, Ceramics

Advanced TiC/a-C : H nanocomposite coatings deposited by magnetron sputtering

YT Pei et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2006)

Article Materials Science, Multidisciplinary

Surface and interface morphology and structure of amorphous carbon thin and multilayer films

P Patsalas et al.

DIAMOND AND RELATED MATERIALS (2005)

Article Materials Science, Multidisciplinary

Micro-scratch test study of TiN films grown on silicon by chemical vapor deposition

S Benayoun et al.

THIN SOLID FILMS (2001)