Related references
Note: Only part of the references are listed.Utilization of copper mine tailings as a partial substitute for cement in concrete construction
Ahad Barzegar Ghazi et al.
CONSTRUCTION AND BUILDING MATERIALS (2022)
Environmental and human health risk assessment of sulfidic mine waste: Bioaccessibility, leaching and mineralogy
Jillian Helser et al.
JOURNAL OF HAZARDOUS MATERIALS (2022)
Partial replacement of metakaolin with red ceramic waste in geopolymer
Madhuchhanda Sarkar et al.
CERAMICS INTERNATIONAL (2021)
Properties, durability and cost efficiency of cement and hydrated lime mortars reusing copper mine tailings of Lefke-Xeros in Cyprus
Ceren Ince et al.
CONSTRUCTION AND BUILDING MATERIALS (2021)
Strength Properties of Sustainable Mortar Containing Waste Steel Slag and Waste Clay Brick: Effect of Temperature
Md Jihad Miah et al.
MATERIALS (2021)
High strength one-part alkali-activated slag blends designed by particle packing optimization
Priyadharshini Perumal et al.
CONSTRUCTION AND BUILDING MATERIALS (2021)
Multiscale X-ray tomography of cementitious materials: A review
Sebastien Brisard et al.
CEMENT AND CONCRETE RESEARCH (2020)
Influence of sodium silicate powder silica modulus for mechanical and chemical properties of dry-mix alkali-activated slag mortar
Tero Luukkonen et al.
CONSTRUCTION AND BUILDING MATERIALS (2020)
Promoting the performance of one-part alkali-activated slag using fine lead-zinc mine tailings
Wei Chen et al.
CONSTRUCTION AND BUILDING MATERIALS (2020)
Hydration kinetics and properties of cement blended with mechanically activated gold mine tailings
Xianjun Lyu et al.
THERMOCHIMICA ACTA (2020)
Characterization of Slag Reprocessing Tailings-Based Geopolymers in Marine Environment
Jie Wu et al.
MINERALS (2020)
A comparison between fly ash- and basic oxygen furnace slag-modified gold mine tailings geopolymers
Thabo Falayi
INTERNATIONAL JOURNAL OF ENERGY AND ENVIRONMENTAL ENGINEERING (2020)
Characterization of magnesium silicate hydrate (M-S-H)
Ellina Bernard et al.
CEMENT AND CONCRETE RESEARCH (2019)
Mine Tailings Geopolymers as a Waste Management Solution for A More Sustainable Habitat
Helena Paiva et al.
SUSTAINABILITY (2019)
Effectiveness of alkali-activated slag as alternative binder on workability and early age compressive strength of cemented paste backfills
Haiqiang Jiang et al.
CONSTRUCTION AND BUILDING MATERIALS (2019)
Experimental Study of Geopolymer Binder Synthesized with Copper Mine Tailings and Low-Calcium Copper Slag
Lino Manjarrez et al.
JOURNAL OF MATERIALS IN CIVIL ENGINEERING (2019)
Consolidation of mine tailings through geopolymerization at ambient temperature
Qian Wan et al.
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2019)
One-part alkali-activated materials: A review
Tero Luukkonen et al.
CEMENT AND CONCRETE RESEARCH (2018)
Pore characteristics (> 0.1 mm) of non-air entrained concrete destroyed by freeze-thaw cycles based on CT scanning and 3D printing
Wei Tian et al.
COLD REGIONS SCIENCE AND TECHNOLOGY (2018)
Alkali activation as new option for gold mine tailings inertization
Jenni Kiventera et al.
JOURNAL OF CLEANER PRODUCTION (2018)
Comparison of alkali and silica sources in one-part alkali-activated blast furnace slag mortar
Tero Luukkonen et al.
JOURNAL OF CLEANER PRODUCTION (2018)
Alkali-activated materials
John L. Provis
CEMENT AND CONCRETE RESEARCH (2018)
Properties of alkali-activated ground granulated blast furnace slag blended with ferronickel slag
Ruilin Cao et al.
CONSTRUCTION AND BUILDING MATERIALS (2018)
Incorporation of Al in C-A-S-H gels with various Ca/Si and Al/Si ratio: Microstructural and structural characteristics with DTA/TG, XRD, FTIR and TEM analysis
Ewa Kapeluszna et al.
CONSTRUCTION AND BUILDING MATERIALS (2017)
Obtaining the spacing factor of microporous concrete using high-resolution Dual Energy X-ray Micro CT
J. Schock et al.
CEMENT AND CONCRETE RESEARCH (2016)
Development of fly ash and iron ore tailing based porous geopolymer for removal of Cu(II) from wastewater
Ping Duan et al.
CERAMICS INTERNATIONAL (2016)
Immobilization of chromite ore processing residue with alkali-activated blast furnace slag-based geopolymer
Xiao Huang et al.
CERAMICS INTERNATIONAL (2016)
Utilization of sulphidic tailings from gold mine as a raw material in geopolymerization
Jenni Kiventera et al.
INTERNATIONAL JOURNAL OF MINERAL PROCESSING (2016)
Simple and fast porosity analysis of concrete using X-ray computed tomography
Anton du Plessis et al.
MATERIALS AND STRUCTURES (2016)
Experimental Investigation of the Variation of Concrete Pores under the Action of Freeze-Thaw Cycles
Jie Yuan et al.
WORLD MULTIDISCIPLINARY CIVIL ENGINEERING-ARCHITECTURE-URBAN PLANNING SYMPOSIUM 2016, WMCAUS 2016 (2016)
Stabilization/solidification of fly ash from fluidized bed combustion of recovered fuel and biofuel using alkali activation and cement addition
Janne Pesonen et al.
JOURNAL OF ENVIRONMENTAL CHEMICAL ENGINEERING (2016)
Hydrogeochemistry and microbiology of mine drainage: An update
D. Kirk Nordstrom et al.
APPLIED GEOCHEMISTRY (2015)
Investigation of microstructural damage in shotcrete under a freeze-thaw environment
Jianxun Chen et al.
CONSTRUCTION AND BUILDING MATERIALS (2015)
Alkali Activation of Copper Mine Tailings and Low-Calcium Flash-Furnace Copper Smelter Slag
Saeed Ahmari et al.
JOURNAL OF MATERIALS IN CIVIL ENGINEERING (2015)
Alkali activation of recovered fuel-biofuel fly ash from fluidised-bed combustion: Stabilisation/solidification of heavy metals
Juho Yliniemi et al.
WASTE MANAGEMENT (2015)
Determination of 3D porosity in steel fibre reinforced SCC beams using X-ray computed tomography
Tomasz Ponikiewski et al.
CONSTRUCTION AND BUILDING MATERIALS (2014)
Designing mine tailings for better environmental, social and economic outcomes: a review of alternative approaches
Mansour Edraki et al.
JOURNAL OF CLEANER PRODUCTION (2014)
Role of slag in microstructural development and hardening of fly ash-slag geopolymer
Sravanthi Puligilla et al.
CEMENT AND CONCRETE RESEARCH (2013)
Utilization of cement kiln dust (CKD) to enhance mine tailings-based geopolymer bricks
Saeed Ahmari et al.
CONSTRUCTION AND BUILDING MATERIALS (2013)
Determination of air-void parameters of hardened cement-based materials using X-ray computed tomography
Kwang Yeom Kim et al.
CONSTRUCTION AND BUILDING MATERIALS (2012)
Assessment of arsenic immobilization in synthetically prepared cemented paste backfill specimens
Samuel Coussy et al.
JOURNAL OF ENVIRONMENTAL MANAGEMENT (2012)
Utilisation of alkali-activated blast furnace slag in paste backfill of high-sulphide mill tailings: Effect of binder type and dosage
Ferdi Cihangir et al.
MINERALS ENGINEERING (2012)
Influence of activator type on hydration kinetics, hydrate assemblage and microstructural development of alkali activated blast-furnace slags
M. Ben Haha et al.
CEMENT AND CONCRETE RESEARCH (2011)
Synthesis and characterization of fly ash modified mine tailings-based geopolymers
Lianyang Zhang et al.
CONSTRUCTION AND BUILDING MATERIALS (2011)
Effect of alkalis on fresh C-S-H gels. FTIR analysis
I. Garcia Lodeiro et al.
CEMENT AND CONCRETE RESEARCH (2009)
Utilization of tailings from tungsten mine waste as a substitution material for cement
Yun Wang Choi et al.
CONSTRUCTION AND BUILDING MATERIALS (2009)
Immobilization of heavy metals (Pb, Cu, Cr, Zn, Cd, Mn) in the mineral additions containing concrete composites
Zbigniew Giergiczny et al.
JOURNAL OF HAZARDOUS MATERIALS (2008)
Synthesis and heavy metal immobilization behaviors of slag based geopolymer
Zhang Yunsheng et al.
JOURNAL OF HAZARDOUS MATERIALS (2007)
Use of infrared spectroscopy to study geopolymerization of heterogeneous amorphous aluminosificates
WKW Lee et al.
LANGMUIR (2003)
Mixture-proportioning of high-performance concrete
F de Larrard et al.
CEMENT AND CONCRETE RESEARCH (2002)
Sodium silicate-based, alkali-activated slag mortars Part I. Strength, hydration and microstructure
AR Brough et al.
CEMENT AND CONCRETE RESEARCH (2002)
Sodium silicate-based alkali-activated slag mortars Part II. The retarding effect of additions of sodium chloride or malic acid
AR Brough et al.
CEMENT AND CONCRETE RESEARCH (2000)
Share Paper
