4.7 Article

Effects of annealing temperature and atmosphere on performances of Zn0.9Mg0.1O buffer layers for CIGS solar cell br

Related references

Note: Only part of the references are listed.
Article Chemistry, Applied

Effects of silver-doping on properties of Cu(In,Ga)Se2 films prepared by CuInGa precursors

Chen Wang et al.

Summary: Ag doping improves the crystallinity and film quality of ACIGS absorbers, reducing carrier recombination and enhancing carrier transport. Excessive Ag, however, leads to lattice distortion and structural defects, affecting device performance.

JOURNAL OF ENERGY CHEMISTRY (2022)

Article Energy & Fuels

Understanding deposition temperature dependent photovoltaic characteristics of Cu(In,Ga)Se2 solar cells: A study with thermally stable alkali aluminosilicate glass substrates

Muhammad Saifullah et al.

Summary: This study investigates the effects of different T-max temperatures on the performance of CIGSe solar cells, showing that higher T-max levels can promote Na diffusion but decrease short-circuit current density. As T-max increases, the Na concentration in the absorber layer gradually decreases, but the highest conversion efficiency is achieved at T-max = 600 degrees C.

SOLAR ENERGY MATERIALS AND SOLAR CELLS (2021)

Article Chemistry, Multidisciplinary

Impact of RbF and NaF Postdeposition Treatments on Charge Carrier Transport and Recombination in Ga-Graded Cu(In,Ga)Se2 Solar Cells

Yu-Han Chang et al.

Summary: This study investigates the impact of NaF and RbF postdeposition treatments on minority carrier dynamics in Cu(In,Ga)Se-2 solar cells using transient absorption spectroscopy. NaF PDT improves electron recombination lifetimes, while the effectiveness of RbF PDT decreases with higher Ga-concentrations. Additionally, both alkali PDTs promote electron mobility in the absorber region with large grains.

ADVANCED FUNCTIONAL MATERIALS (2021)

Article Physics, Condensed Matter

Realization of high-quality RF sputtered ZnMgO (x=15%) thin films by post-growth annealing treatment

Punam Murkute et al.

Summary: This study investigated the impact of post-deposition annealing parameters on RF sputtered Zn0.85Mg0.15O thin films, showing that high temperature annealing facilitated Mg incorporation in ZnO lattice and increased grain size due to grain aggregation. High activation energy and narrow line width were achieved in the 900 degrees C annealed film, with the dissociation of bound exciton peaks observed at increasing annealing temperatures.

SUPERLATTICES AND MICROSTRUCTURES (2021)

Article Chemistry, Physical

High optoelectronic performance of ZnO films co-doped with ternary functional elements of F, Al and Mg

Yanfeng Wang et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2020)

Article Engineering, Electrical & Electronic

Mobility improvement of Zn1-xMgxO:Al prepared under room temperature by co-sputtering through optimizations of Al and Mg contents

Jakapan Chantana et al.

MATERIALS SCIENCE IN SEMICONDUCTOR PROCESSING (2020)

Article Engineering, Electrical & Electronic

Room-temperature ultraviolet-ozone annealing of ZnO and ZnMgO nanorods to attain enhanced optical properties

Md Jawaid Alam et al.

JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS (2020)

Article Chemistry, Physical

Role of zinc interstitial defects in indium and magnesium codoped ZnO transparent conducting films

Hong Zhang et al.

APPLIED SURFACE SCIENCE (2019)

Article Energy & Fuels

Cd-Free Cu(In,Ga)(Se,S)2 Thin-Film Solar Cell With Record Efficiency of 23.35%

Motoshi Nakamura et al.

IEEE JOURNAL OF PHOTOVOLTAICS (2019)

Article Nanoscience & Nanotechnology

Influence of Mg Doping on ZnO Nanoparticles for Enhanced Photocatalytic Evaluation and Antibacterial Analysis

K. Pradeev Raj et al.

NANOSCALE RESEARCH LETTERS (2018)

Article Energy & Fuels

Rapid thermal annealing on ZnMgO window layer for improved performance of CdTe solar cells

Shengqiang Ren et al.

SOLAR ENERGY MATERIALS AND SOLAR CELLS (2018)

Article Energy & Fuels

Thin-film Cu(In,Ga)(Se,S)2-based solar cell with (Cd,Zn)S buffer layer and Zn1-xMgxO window layer

Jakapan Chantana et al.

PROGRESS IN PHOTOVOLTAICS (2017)

Article Materials Science, Ceramics

Microstructure and magnetic behavior of (Mg/Ni) co-doped ZnO nanoparticles

C. Boyraz et al.

CERAMICS INTERNATIONAL (2017)

Article Nanoscience & Nanotechnology

Sputtered Inx(O,S)y Buffer Layers for Cu(In,Ga)Se2 Thin-Film Solar Cells: Engineering of Band Alignment and Interface Properties

Wei-Hao Ho et al.

ACS APPLIED MATERIALS & INTERFACES (2017)

Article Materials Science, Ceramics

Band gap engineering in Zn(1-x)CdxO and Zn(1-x)MgxO thin films by RF sputtering

S. Gowrishankar et al.

CERAMICS INTERNATIONAL (2014)

Article Physics, Applied

Deep level related photoluminescence in ZnMgO

M. Trunk et al.

APPLIED PHYSICS LETTERS (2010)

Article Chemistry, Physical

Effect of annealing temperature on the structure and optical properties of In-doped ZnO thin films

L. P. Peng et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2009)

Article Energy & Fuels

Annealing effects on Zn1-xMgxO/CIGS interfaces characterized by ultraviolet light excited time-resolved photoluminescence

Shin-ichi Shimakawa et al.

SOLAR ENERGY MATERIALS AND SOLAR CELLS (2008)

Article Physics, Applied

Ultraviolet-illumination-enhanced photoluminescence effect in zinc oxide thin films

CM Jin et al.

JOURNAL OF APPLIED PHYSICS (2005)

Article Materials Science, Multidisciplinary

Preparation of Zn1-xMgxO films by radio frequency magnetron sputtering

T Minemoto et al.

THIN SOLID FILMS (2000)