Related references
Note: Only part of the references are listed.Simulation and flow physics of a shocked and reshocked high-energy-density mixing layer
Jason D. Bender et al.
JOURNAL OF FLUID MECHANICS (2021)
Melting of Tantalum at Multimegabar Pressures on the Nanosecond Timescale
R. G. Kraus et al.
PHYSICAL REVIEW LETTERS (2021)
Multi-megabar Dynamic Strength Measurements of Ta, Au, Pt, and Ir
J. L. Brown et al.
JOURNAL OF DYNAMIC BEHAVIOR OF MATERIALS (2021)
Experimental evaluation of shear modulus scaling of dynamic strength at extreme pressures
J. L. Brown et al.
JOURNAL OF APPLIED PHYSICS (2020)
Rayleigh-Taylor instabilities in high-energy density settings on the National Ignition Facility
Bruce A. Remington et al.
PROCEEDINGS OF THE NATIONAL ACADEMY OF SCIENCES OF THE UNITED STATES OF AMERICA (2019)
Generalization of the Unified Analytic Melt-Shear Model to Multi-Phase Materials: Molybdenum as an Example
Leonid Burakovsky et al.
CRYSTALS (2019)
Ultrahigh pressure equation of state of tantalum to 310 GPa
Kaleb C. Burrage et al.
HIGH PRESSURE RESEARCH (2019)
Influence of defects on the shock Hugoniot of tantalum
Eric N. Hahn et al.
JOURNAL OF APPLIED PHYSICS (2019)
Uniaxial compression of single crystal and polycrystalline tantalum
G. Whiteman et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)
A comparison of material flow strength models using Bayesian cross-validation
Jason Bernstein et al.
COMPUTATIONAL MATERIALS SCIENCE (2019)
Extreme Hardening of Pb at High Pressure and Strain Rate
A. Krygier et al.
PHYSICAL REVIEW LETTERS (2019)
Tantalum strength at extreme strain rates from impact-driven Richtmyer-Meshkov instabilities
Michael B. Prime et al.
PHYSICAL REVIEW E (2019)
The defect evolution in shock loaded tantalum single crystals
B. Pang et al.
ACTA MATERIALIA (2018)
Elastic precursor wave decay in shock-compressed aluminum over a wide range of temperature
Ryan A. Austin
JOURNAL OF APPLIED PHYSICS (2018)
Strength of tantalum shocked at ultrahigh pressures
Aaron P. Stebner et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)
Verification of experimental dynamic strength methods with atomistic ramp-release simulations
Alexander P. Moore et al.
PHYSICAL REVIEW MATERIALS (2018)
Orientation dependent spall strength of tantalum single crystals
Eric N. Hahn et al.
ACTA MATERIALIA (2018)
Effect of peak stress and tensile strain-rate on spall in tantalum
D. R. Jones et al.
JOURNAL OF APPLIED PHYSICS (2018)
Inferring Strength of Tantalum from Hydrodynamic Instability Recovery Experiments
Z. Sternberger et al.
JOURNAL OF DYNAMIC BEHAVIOR OF MATERIALS (2018)
Molecular Scale Study of the Plastic Response of Tantalum under Ramp Compression and Release
Alexander P. Moore et al.
SHOCK COMPRESSION OF CONDENSED MATTER - 2017 (2018)
In situ X-ray diffraction measurement of shock-wave-driven twinning and lattice dynamics
C. E. Wehrenberg et al.
NATURE (2017)
Probing the limits of metal plasticity with molecular dynamics simulations
Luis A. Zepeda-Ruiz et al.
NATURE (2017)
On the ultimate tensile strength of tantalum
Eric N. Hahn et al.
ACTA MATERIALIA (2017)
Physically-based strength model of tantalum incorporating effects of temperature, strain rate and pressure
Hojun Lim et al.
MODELLING AND SIMULATION IN MATERIALS SCIENCE AND ENGINEERING (2016)
Effect of strain rate and dislocation density on the twinning behavior in tantalum
Jeffrey N. Florando et al.
AIP ADVANCES (2016)
Strain-rate dependence of ramp-wave evolution and strength in tantalum
J. Matthew D. Lane et al.
PHYSICAL REVIEW B (2016)
Structural model of mechanical twinning and its application for modeling of the severe plastic deformation of copper rods in Taylor impact tests
Elijah N. Borodin et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2015)
Analytic model of the remobilization of pinned glide dislocations from quasi-static to high strain rates
A. Hunter et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2015)
A physically based model of temperature and strain rate dependent yield in BCC metals: Implementation into crystal plasticity
Hojun Lim et al.
JOURNAL OF THE MECHANICS AND PHYSICS OF SOLIDS (2015)
Plastic deformation of high-purity α-titanium: Model development and validation using the Taylor cylinder impact test
Benoit Revil-Baudard et al.
MECHANICS OF MATERIALS (2015)
Grain-Size-Independent Plastic Flow at Ultrahigh Pressures and Strain Rates
H. -S. Park et al.
PHYSICAL REVIEW LETTERS (2015)
Flow strength of tantalum under ramp compression to 250 GPa
J. L. Brown et al.
JOURNAL OF APPLIED PHYSICS (2014)
Tantalum and vanadium response to shock-wave loading at normal and elevated temperatures. Non-monotonous decay of the elastic wave in vanadium
E. B. Zaretsky et al.
JOURNAL OF APPLIED PHYSICS (2014)
Compatible, total energy conserving and symmetry preserving arbitrary Lagrangian-Eulerian hydrodynamics in 2D rz - Cylindrical coordinates
Mack Kenamond et al.
JOURNAL OF COMPUTATIONAL PHYSICS (2014)
Investigation and modeling of the anomalous yield point phenomenon in pure tantalum
D. Colas et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2014)
Multiscale strength (MS) models: their foundation, their successes, and their challenges
R. E. Rudd et al.
18TH APS-SCCM AND 24TH AIRAPT, PTS 1-19 (2014)
DEVELOPMENTS IN MICROCOINING RIPPLED METAL FOILS
Greg C. Randall et al.
FUSION SCIENCE AND TECHNOLOGY (2013)
A multiscale strength model for tantalum over an extended range of strain rates
N. R. Barton et al.
JOURNAL OF APPLIED PHYSICS (2013)
Extracting strength from high pressure ramp-release experiments
J. L. Brown et al.
JOURNAL OF APPLIED PHYSICS (2013)
Analysis of deformation twinning in tantalum single crystals under shock loading conditions
Jeffrey N. Florando et al.
JOURNAL OF APPLIED PHYSICS (2013)
Stable structures of tantalum at high temperature and high pressure
Yansun Yao et al.
PHYSICAL REVIEW B (2013)
Unstable Richtmyer-Meshkov growth of solid and liquid metals in vacuum
W. T. Buttler et al.
JOURNAL OF FLUID MECHANICS (2012)
Tailored ramp-loading via shock release of stepped-density reservoirs
Shon T. Prisbrey et al.
PHYSICS OF PLASMAS (2012)
THEORY AND SIMULATION OF 1D TO 3D PLASTIC RELAXATION IN TANTALUM
Robert E. Rudd et al.
SHOCK COMPRESSION OF CONDENSED MATTER - 2011, PTS 1 AND 2 (2012)
EXPERIMENTAL RESULTS OF TANTALUM MATERIAL STRENGTH AT HIGH PRESSURE AND HIGH STRAIN RATE
Hye-Sook Park et al.
SHOCK COMPRESSION OF CONDENSED MATTER - 2011, PTS 1 AND 2 (2012)
A multiscale strength model for extreme loading conditions
N. R. Barton et al.
JOURNAL OF APPLIED PHYSICS (2011)
Use of the Richtmyer-Meshkov Instability to Infer Yield Stress at High-Energy Densities
Guy Dimonte et al.
PHYSICAL REVIEW LETTERS (2011)
Modeling the mechanical response of polycrystals deforming by climb and glide
Ricardo A. Lebensohn et al.
PHILOSOPHICAL MAGAZINE (2010)
The trianvil test apparatus: Measurement of shear strength under pressure
J. P. Escobedo et al.
REVIEW OF SCIENTIFIC INSTRUMENTS (2010)
Modeling viscoplastic behavior and heterogeneous intracrystalline deformation of columnar ice polycrystals
R. A. Lebensohn et al.
ACTA MATERIALIA (2009)
Richtmyer-Meshkov instability in elastic-plastic media
A. R. Piriz et al.
PHYSICAL REVIEW E (2008)
Restoring the density-gradient expansion for exchange in solids and surfaces
John P. Perdew et al.
PHYSICAL REVIEW LETTERS (2008)
Elastic-viscoplastic anisotropic modeling of textured metals and validation using the Taylor cylinder impact test
B. Plunkett et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2007)
Strength behavior of materials at high pressures
Tracy J. Vogler et al.
INTERNATIONAL JOURNAL OF IMPACT ENGINEERING (2006)
Compact system for high-speed velocimetry using heterodyne techniques
O. T. Strand et al.
REVIEW OF SCIENTIFIC INSTRUMENTS (2006)
Microstructural development in asymmetric processing of tantalum plate
DP Field et al.
JOURNAL OF ELECTRONIC MATERIALS (2005)
Magnetically accelerated, ultrahigh velocity flyer plates for shock wave experiments
RW Lemke et al.
JOURNAL OF APPLIED PHYSICS (2005)
Richtmyer-Meshkov instability of arbitrary shapes
KO Mikaelian
PHYSICS OF FLUIDS (2005)
Dynamic deformation and damage in cast γ-TiAl during Taylor cylinder impact:: Experiments and model validation
E Cerreta et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2004)
Analytic model of the shear modulus at all temperatures and densities
L Burakovsky et al.
PHYSICAL REVIEW B (2003)
Model of plastic deformation for extreme loading conditions
DL Preston et al.
JOURNAL OF APPLIED PHYSICS (2003)
Low-symmetry plastic deformation in BCC tantalum: experimental observations, modeling and simulations
PJ Maudlin et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2003)
Share Paper
