4.5 Article

Assessment of heavy metals pollution in seawater and sediments in the Arabian Gulf, near Dammam, Saudi Arabia

Journal

JOURNAL OF KING SAUD UNIVERSITY SCIENCE
Volume 34, Issue 1, Pages -

Publisher

ELSEVIER
DOI: 10.1016/j.jksus.2021.101677

Keywords

Electrical conductivity; Heavy metals; Sediments; Total dissolved solids; Water

Funding

  1. Deputyship for Research & Innovation, Ministry of Education in Saudi Arabia [DRI-KSU659]

Ask authors/readers for more resources

Anthropogenic activities, urban and industrial wastewaters, and the disintegration of rock are the main causes of heavy metals in seawater and sediments worldwide. A study in Dammam, Saudi Arabia found high concentrations of As, Hg, Cd, Cr, Cu, Fe, and Sr, raising concerns about pollution in the area.
Anthropogenic activities, urban and industrial wastewaters, and the usual disintegration of rock from physical, chemical, and biological stresses are the main cause of heavy metals in seawater and sediments worldwide. Five different sampling locations were selected after an initial survey of the Dammam region Seawater study area, and sediment samples were procured in triplicate from each location to assess the level of selected heavy metals pollutions in the Arabian Gulf, Dammam, Saudi Arabia. Be, Cr, Ni, Cu, As, Se, Ag, Cd, Pb, Hg, Co, Zn, Fe, Mn, Sr, and Mo were detected using inductively coupled plasma mass spectrometer (ICP-MS). The pH ranges from 7.91 +/- 0.26-8.22 +/- 0.38 in stations 4 and 3, respectively. Surface seawater's electrical conductivity values ranged from 71788 +/- 28.52 to 75680 +/- 42.92 mu S/cm at stations 4 and 3. The minimum and maximum concentration of total dissolved solid was observed as 49524 +/- 50.25 and 54786 +/- 66.95 mgL(-1) in sites 4 and 3, respectively. The level of these metals fluctuated among the sampling sites. The highest concentration of these heavy metals was recorded from sampling site 4 and minimum in location 1. The average level of these metals in water samples were recorded Sr > Cu > Se > Zn > As > Mn > Fe > Ni > Mo > Hg > Co > Cr > Ag > Cd > Pb and Be, respectively. The average level of these metals in sediment samples were recorded Fe > Sr > Ni > Mn > Cu > Cr > Zn > Pb > Ag > As > Mo > Co > Se > Hg > Be and Cd, respectively. It has been concluded that the concentration of As, Hg, Cd, Cr, Cu, Fe, and Sr was high, which is alarming, particularly in the Dammam area. (C) 2021 The Author(s). Published by Elsevier B.V. on behalf of King Saud University.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.5
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available