Related references
Note: Only part of the references are listed.Evaluation of combined cooling, heating and power (CCHP) systems with energy storage units at different locations
Xi Zhuo Jiang et al.
APPLIED THERMAL ENGINEERING (2016)
Thermodynamic boundaries of energy saving in conventional CCHP (Combined Cooling, Heating and Power) systems
Minzhi Li et al.
ENERGY (2016)
Life cycle assessment (LCA) optimization of solar-assisted hybrid CCHP system
Jiangjiang Wang et al.
APPLIED ENERGY (2015)
Optimal electrical and thermal energy management of a residential energy hub, integrating demand response and energy storage system
Faeze Brahman et al.
ENERGY AND BUILDINGS (2015)
Carbon footprint analysis of a combined cooling heating and power system
Xi Zhuo Jiang et al.
ENERGY CONVERSION AND MANAGEMENT (2015)
A novel operation strategy for CCHP systems based on minimum distance
C. Y. Zheng et al.
APPLIED ENERGY (2014)
Simultaneous use of MRM (maximum rectangle method) and optimization methods in determining nominal capacity of gas engines in CCHP (combined cooling, heating and power) systems
Sepehr Sanaye et al.
ENERGY (2014)
Optimization of CHCP (combined heat power and cooling) systems operation strategy using dynamic programming
Andrea Luigi Facci et al.
ENERGY (2014)
Influence of working fluid properties on system performance and screen evaluation indicators for geothermal ORC (organic Rankine cycle) system
Huixing Zhai et al.
ENERGY (2014)
Vapor Pressure Measurement of Two Quaternary Systems LiBr + LiNO3 + LiCl + H2O and LiBr + LiCl+1,3-Propanediol + H2O
Xizhuo Jiang et al.
JOURNAL OF CHEMICAL AND ENGINEERING DATA (2014)
Energy Storage Technologies for Residential Buildings
Zhiqiang (John) Zhai et al.
JOURNAL OF ARCHITECTURAL ENGINEERING (2014)
Analysis and sizing of thermal energy storage in combined heating, cooling and power plants for buildings
S. Martinez-Lera et al.
APPLIED ENERGY (2013)
A novel variable effect LiBr-water absorption refrigeration cycle
Z. Y. Xu et al.
ENERGY (2013)
Performance assessment of a novel system using parabolic trough solar collectors for combined cooling, heating, and power production
Fahad A. Al-Sulaiman et al.
RENEWABLE ENERGY (2012)
Performance comparison of combined cooling heating and power system in different operation modes
Jiang-Jiang Wang et al.
APPLIED ENERGY (2011)
Energetic and exergetic performance analyses of a combined heat and power plant with absorption inlet cooling and evaporative aftercooling
Abdul Khaliq et al.
ENERGY (2011)
Analysis of combined cooling, heating, and power systems operating following the electric load and following the thermal load strategies with no electricity export
N. Fumo et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART A-JOURNAL OF POWER AND ENERGY (2011)
Numerical investigation of a two-stage air-cooled absorption refrigeration system for solar cooling: Cycle analysis and absorption cooling performances
P. Lin et al.
RENEWABLE ENERGY (2011)
Evaluation of a turbine driven CCHP system for large office buildings under different operating strategies
Pedro J. Mago et al.
ENERGY AND BUILDINGS (2010)
Evaluation of CCHP systems performance based on operational cost, primary energy consumption, and carbon dioxide emission by utilizing an optimal operation scheme
Heejin Cho et al.
APPLIED ENERGY (2009)
Performance analysis of CCHP and CHP systems operating following the thermal and electric load
P. J. Mago et al.
INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2009)
Performance of a LiBr-water absorption chiller operating with plate heat exchangers
M. de Vega et al.
ENERGY CONVERSION AND MANAGEMENT (2006)
Energy conservation in buildings: cogeneration and cogeneration coupled with thermal-energy storage
KH Khan et al.
APPLIED ENERGY (2004)
Analytical solutions and typical characteristics of part-load performances of single shaft gas turbine and its cogeneration
N Zhang et al.
ENERGY CONVERSION AND MANAGEMENT (2002)