Related references
Note: Only part of the references are listed.Surface damage during transient thermal load of 50% thickness reduced W-2% (Vol.) Y2O3 sheet with different recrystallization volume fraction
Xiang Zan et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2020)
Smart 3D Network Nanocomposites Collect Irradiation-Induced Trash
Jun Tang et al.
MATTER (2020)
Helium retention in krypton ion pre-irradiated nanochannel W film
Wenjing Qin et al.
NUCLEAR FUSION (2018)
Nanochannel structures in W enhance radiation tolerance
Wenjing Qin et al.
ACTA MATERIALIA (2018)
Erosion dynamics of tungsten fuzz during ELM-like heat loading
G. Sinclair et al.
JOURNAL OF APPLIED PHYSICS (2018)
Radiation damage in nanostructured materials
Xinghang Zhang et al.
PROGRESS IN MATERIALS SCIENCE (2018)
Effect on structure and mechanical property of tungsten irradiated by high intensity pulsed ion beam
Xianxiu Mei et al.
NUCLEAR INSTRUMENTS & METHODS IN PHYSICS RESEARCH SECTION B-BEAM INTERACTIONS WITH MATERIALS AND ATOMS (2017)
Melt layer erosion during ELM-like heat loading on molybdenum as an alternative plasma-facing material
G. Sinclair et al.
SCIENTIFIC REPORTS (2017)
Thermal-stress analysis on the crack formation of tungsten during fusion relevant transient heat loads
Changjun Li et al.
NUCLEAR MATERIALS AND ENERGY (2017)
Transient heat load challenges for plasma-facing materials during long-term operation
M. Wirtz et al.
NUCLEAR MATERIALS AND ENERGY (2017)
Stress measurements by multi-reflection grazing-incidence X-ray diffraction method (MGIXD) using different radiation wavelengths and different incident angles
Marianna Marciszko et al.
ACTA MATERIALIA (2017)
The effect of thermal treatment on the stress state and evolving microstructure of Cu/W nano-multilayers
C. Cancellieri et al.
JOURNAL OF APPLIED PHYSICS (2016)
New Steady-State Quiescent High-Confinement Plasma in an Experimental Advanced Superconducting Tokamak
J. S. Hu et al.
PHYSICAL REVIEW LETTERS (2015)
Cracking behavior of tungsten armor under ELM-like thermal shock loads: A computational study
Muyuan Li et al.
NUCLEAR MATERIALS AND ENERGY (2015)
Formation of nanoscale carbon structures in the surface layer of metals under the impact of high intensity ion beam
G. E. Remnev et al.
APPLIED SURFACE SCIENCE (2014)
Thermal shock performance of CVD tungsten coating at elevated temperatures
Youyun Lian et al.
JOURNAL OF NUCLEAR MATERIALS (2014)
On the evolution of residual stress at different substrate temperatures in sputter-deposited polycrystalline Mo thin films by x-ray diffraction
Ch Kishan Singh et al.
MATERIALS RESEARCH EXPRESS (2014)
Thermal shock response of deformed and recrystallised tungsten
M. Wirtz et al.
FUSION ENGINEERING AND DESIGN (2013)
Preparation and properties of CVD-W coated W/Cu FGM mock-ups
Youyun Lian et al.
FUSION ENGINEERING AND DESIGN (2013)
A gigawatt power pulsed ion beam generator for industrial applications
Alexander I. Pushkarev et al.
SURFACE & COATINGS TECHNOLOGY (2013)
Simulation of residual thermostress in tungsten after repetitive ELM-like heat loads
S. Pestchanyi et al.
FUSION ENGINEERING AND DESIGN (2011)
Physics basis and design of the ITER plasma-facing components
R. A. Pitts et al.
JOURNAL OF NUCLEAR MATERIALS (2011)
Performance of different tungsten grades under transient thermal loads
J. Linke et al.
NUCLEAR FUSION (2011)
Controlling Radiation Damage
Graeme Ackland
SCIENCE (2010)
Cracking failure study of ITER-reference tungsten grade under single pulse thermal shock loads at elevated temperatures
T. Hirai et al.
JOURNAL OF NUCLEAR MATERIALS (2009)
Experimental validation of 3D simulations of tungsten melt erosion under ITER-like transient loads
B. Bazylev et al.
JOURNAL OF NUCLEAR MATERIALS (2009)
Residual stresses in tungsten under exposures with ITER ELM-like plasma loads
V. A. Makhlaj et al.
PHYSICA SCRIPTA (2009)
High heat flux testing of plasma facing materials and components -: Status and perspectives for ITER related activities
J. Linke et al.
JOURNAL OF NUCLEAR MATERIALS (2007)
Thermo-mechanical calculations on operation temperature limits of tungsten as plasma facing material
T. Hirai et al.
FUSION ENGINEERING AND DESIGN (2007)
Tungsten:: an option for divertor and main chamber plasma facing components in future fusion devices
R Neu et al.
NUCLEAR FUSION (2005)
Stress analysis of polycrystalline thin films and surface regions by X-ray diffraction
U Welzel et al.
JOURNAL OF APPLIED CRYSTALLOGRAPHY (2005)
Characteristics of type I ELM energy and particle losses in existing devices and their extrapolation to ITER
A Loarte et al.
PLASMA PHYSICS AND CONTROLLED FUSION (2003)
Residual stress measurement in textured thin film by grazing-incidence X-ray diffraction
CH Ma et al.
THIN SOLID FILMS (2002)
New approach to stress analysis based on grazing-incidence X-ray diffraction
SJ Skrzypek et al.
JOURNAL OF APPLIED CRYSTALLOGRAPHY (2001)