4.5 Article

Advancing Reverse Electrowetting-on-Dielectric from Planar to Rough Surface Electrodes for High Power Density Energy Harvesting

Journal

ENERGY TECHNOLOGY
Volume 10, Issue 3, Pages -

Publisher

WILEY-V C H VERLAG GMBH
DOI: 10.1002/ente.202100867

Keywords

high surface areas; rough electrodes; low-frequency motion energy harvesting; mathematical modeling; reverse electrowetting-on-dielectric; wearable motion sensors; zero applied bias

Categories

Funding

  1. National Science Foundation (NSF) [ECCS 1933502]

Ask authors/readers for more resources

Reverse electrowetting-on-dielectric (REWOD)-based energy harvesting has been studied as a novel technique of harvesting energy using liquid droplets. Previous research relied on planar electrodes with limited surface area. This study presents a modeling approach using structured rough surface electrodes to enhance power density. The results show that the proposed rough electrode REWOD energy harvester achieves a maximum power density that is approximately 4 times higher than that of planar electrodes.
Reverse electrowetting-on-dielectric (REWOD)-based energy harvesting has been studied over the last decade as a novel technique of harvesting energy by actuating liquid droplet(s) utilizing applied mechanical modulation. Much prior research in REWOD has relied on planar electrodes, which by its geometry possess a limited surface area. In addition, most of the prior REWOD works have applied a high bias voltage to enhance the output power that compromises the concept of self-powering wearable motion sensors in human health monitoring applications. In order to enhance the REWOD power density resulting from an increased electrode-electrolyte interfacial area, high surface area electrodes are required. Herein, electrical and multiphysics-based modeling approaches of REWOD energy harvester using structured rough surface electrodes are presented. By enhancing the overall available surface area, an increase in the overall capacitance is achieved. COMSOL and MATLAB-based models are also developed, and the empirical results are compared with the models to validate the performance. Root mean square (RMS) power density is calculated using the RMS voltage across an optimal load impedance. For the proposed rough electrode REWOD energy harvester, maximum power density of 3.18 mu W cm(-2) is achieved at 5 Hz frequency, which is approximate to 4 times higher than that of the planar electrodes.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.5
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available