Related references
Note: Only part of the references are listed.Drivers of mechanical performance variance in 3D-printed fused filament fabrication parts: An Onyx FR case study
Christine Ma et al.
POLYMER COMPOSITES (2021)
Fused Deposition Modelling of Fibre Reinforced Polymer Composites: A Parametric Review
Narongkorn Krajangsawasdi et al.
JOURNAL OF COMPOSITES SCIENCE (2021)
Anisotropy of poly(lactic acid)/carbon fiber composites prepared by fused deposition modeling
Qingjun Ding et al.
JOURNAL OF APPLIED POLYMER SCIENCE (2020)
Effect of extrusion temperature on fused filament fabrication parts orthotropic behaviour
Michele Angelo Attolico et al.
RAPID PROTOTYPING JOURNAL (2020)
Evaluation of the Dimensional Accuracy of 3D-Printed Anatomical Mandibular Models Using FFF, SLA, SLS, MJ, and BJ Printing Technology
Bilal Msallem et al.
JOURNAL OF CLINICAL MEDICINE (2020)
Investigating the Effects of Annealing on the Mechanical Properties of FFF-Printed Thermoplastics
Javaid Butt et al.
JOURNAL OF MANUFACTURING AND MATERIALS PROCESSING (2020)
3D-Printed Carbon Fiber Reinforced Polymer Composites: A Systematic Review
Seyed Hamid Reza Sanei et al.
JOURNAL OF COMPOSITES SCIENCE (2020)
Moisture effect on the mechanical properties of additively manufactured continuous carbon fiber-reinforced Nylon-based thermoplastic
Bruno Calheiros Kikuchi et al.
POLYMER COMPOSITES (2020)
Effects of nozzle temperature and building orientation on mechanical properties and microstructure of PEEK and PEI printed by 3D-FDM
Shouling Ding et al.
POLYMER TESTING (2019)
Comparison of physical and mechanical properties of PLA, ABS and nylon 6 fabricated using fused deposition modeling and injection molding
Makara Lay et al.
COMPOSITES PART B-ENGINEERING (2019)
Effect of Filling Pattern on the Tensile and Flexural Mechanical Properties of FDM 3D Printed Products
B. Akhoundi et al.
EXPERIMENTAL MECHANICS (2019)
Effects of the Infill Density on the Mechanical Properties of Nylon Specimens Made by Filament Fused Fabrication
Svetlana Terekhina et al.
TECHNOLOGIES (2019)
FDM process parameters influence over the mechanical properties of polymer specimens: A review
Diana Popescu et al.
POLYMER TESTING (2018)
Effect of process parameters on tensile strength of FDM printed PLA part
Shilpesh R. Rajpurohit et al.
RAPID PROTOTYPING JOURNAL (2018)
The influence of printing parameters on selected mechanical properties of FDM/FFF 3D-printed parts
G. Cwikla et al.
MODTECH INTERNATIONAL CONFERENCE - MODERN TECHNOLOGIES IN INDUSTRIAL ENGINEERING V (2017)
Plasticization lags behind water migration in nylon-6: An NMR imaging and relaxation study
N. J. W. Reuvers et al.
POLYMER (2015)
Transverse and longitudinal coefficient of thermal expansion of carbon fibers at high temperatures (300-2500 K)
C. Pradere et al.
CARBON (2008)
Transverse and longitudinal CTE measurements of carbon fibers and their impact on interfacial residual stresses in composites
R Kulkarni et al.
JOURNAL OF COMPOSITE MATERIALS (2006)
Share Paper
