Effect of Sandblasting on Static and Fatigue Strength of Flash Butt Welded 75Cr4 Bandsaw Blades

The aim of the research presented in this article is analysis of the effect of the surface treatment method on the static and fatigue strength of flash butt welded bandsaw blades. A 1-mm-thick 75Cr1 cold-work tool steel sheet used for bandsaw blades was used as the test material. Fractographic studies of the fatigue fractures and fractures formed in static tests were also carried out. The static strength tests showed sandblasting the weld surface had no significant effect on the load capacity of the joint. However, the sandblasted specimens showed a higher repeatability of the load capacity (lower standard deviation). In the case of both analyzed sample variants of specimens, sandblasted and non-sandblasted, the number of cycles at which the sample was damaged decreases with the percentage increase of the stress amplitude. When loading the samples with a stress amplitude value in the range between 400 and 690 MPa, sandblasting of the weld surface increased the average value of destructive cycles by about 10-86% (depending on the stress amplitude) compared to non-sandblasted joints. The sandblasting process introduces compressive stresses in the surface layer of the welds, therefore the variable tensile load acting on the sample requires a greater number of cycles before the fatigue cracks initiate and propagate. In the case of all specimens, a ductile fracture was observed. It was also found that, regardless of the variable stress amplitude, sandblasting has a positive effect on reducing the standard deviation of fatigue test results.

Automated summary

The research analyzed the effect of surface treatment methods on the static and fatigue strength of flash butt welded bandsaw blades, finding that sandblasting the weld surface increased the repeatability of load capacity and extended the time before fatigue cracks initiate.