4.6 Article

Experimental Research of Fibrous Materials for Two-Stage Filtration of the Intake Air of Internal Combustion Engines

Related references

Note: Only part of the references are listed.
Article Engineering, Environmental

Monitoring and prediction of dust concentration in an open-pit mine using a deep-learning algorithm

Lin Li et al.

Summary: Dust pollution is a serious environmental issue in open-pit mines. This study proposes a hybrid model based on LSTM network and attention mechanism for predicting TSP concentration, which outperforms traditional ARIMA and LSTM models. The model has potential for application in various areas and provides guidance for dust suppression work in open-pit mines.

JOURNAL OF ENVIRONMENTAL HEALTH SCIENCE AND ENGINEERING (2021)

Article Energy & Fuels

Analyzing Characteristics of Particulate Matter Pollution in Open-Pit Coal Mines: Implications for Green Mining

Huaiting Luo et al.

Summary: This study focused on the particulate pollution in open-pit coal mines in China during winter, specifically analyzing the PM concentration variations and their relationship with meteorological factors. The results highlighted the impact of humidity, temperature, wind speed, and temperature difference on PM concentrations, with PM2.5 showing greater sensitivity to environmental factors. These findings are valuable for advancing green mining practices.

ENERGIES (2021)

Article Energy & Fuels

Enclosure Design for Brake Wear Particle Measurement Using Computational Fluid Dynamics

Tuo Zhang et al.

Summary: Researchers analyzed and regulated brake wear particles in dynamometers to address the environmental harm caused by fine dust generated by automobile brakes. Utilizing computational fluid dynamics technology, they predicted particle behavior, analyzed system flow characteristics, and proposed design improvements to reduce pressure loss and decrease particle residence time in the brake enclosure system.

ENERGIES (2021)

Article Engineering, Chemical

Local variations of air velocity in the vicinity of filter pleats in transitional airflow regime ? Experimental and numerical approaches

Walid Mrad et al.

Summary: This study characterizes the airflow in the vicinity of pleated filters used in ventilation systems through experimental velocity measurements and numerical simulations. Significant local velocity gradients were detected downstream of the filter, with the maximum local velocity detected as much as three times the inlet velocity. Numerical velocity data were in fairly close agreement with the experimental velocity profiles, especially in close proximity to the filter medium.

SEPARATION AND PURIFICATION TECHNOLOGY (2021)

Article Construction & Building Technology

Modeling the surface filtration pressure drop of PTFE HEPA filter media for low load applications

Wanyi Zhang et al.

BUILDING AND ENVIRONMENT (2020)

Article Chemistry, Physical

Experimental Study of Filtration Materials Used in the Car Air Intake

Tadeusz Dziubak et al.

MATERIALS (2020)

Article Engineering, Chemical

An experimental modeling of cyclone separator efficiency with PCA-PSO-SVR algorithm

Wei Zhang et al.

POWDER TECHNOLOGY (2019)

Article Engineering, Chemical

Particle loading characteristics of a two-stage filtration system

Xinjiao Tian et al.

SEPARATION AND PURIFICATION TECHNOLOGY (2019)

Article Engineering, Chemical

Numerical investigation of pressure and flow characteristics of pleated air filter system for automotive engine intake application

Ajay Kumar Maddineni et al.

SEPARATION AND PURIFICATION TECHNOLOGY (2019)

Article Engineering, Chemical

Influence of pre-stage filter selection and face velocity on the loading characteristics of a two-stage filtration system

Xinjiao Tian et al.

SEPARATION AND PURIFICATION TECHNOLOGY (2019)

Article Environmental Sciences

Dust distribution in open-pit mines based on monitoring data and fluent simulation

Tang Wanjun et al.

ENVIRONMENTAL MONITORING AND ASSESSMENT (2018)

Review Environmental Sciences

Non-exhaust PM emissions from electric vehicles

Victor R. J. H. Timmers et al.

ATMOSPHERIC ENVIRONMENT (2016)

Article Engineering, Chemical

Applicability of a coarse-grained CFD-DEM model on dense medium cyclone

Kaiwei Chu et al.

MINERALS ENGINEERING (2016)

Article Engineering, Chemical

Effect of dust loading rate on the loading characteristics of high efficiency filter media

Qiang Wang et al.

POWDER TECHNOLOGY (2016)

Article Chemistry, Physical

Efficient and reusable polyamide-56 nanofiber/nets membrane with bimodal structures for air filtration

Bowen Liu et al.

JOURNAL OF COLLOID AND INTERFACE SCIENCE (2015)

Article Engineering, Chemical

Experimental research on the dynamics of airflow parameters in a six-channel cyclone-separator

Pranas Baltrenas et al.

POWDER TECHNOLOGY (2015)

Article Engineering, Chemical

Modeling service life of pleated filters exposed to poly-dispersed aerosols

A. M. Saleh et al.

POWDER TECHNOLOGY (2014)

Article Engineering, Chemical

Combination of Single-Photon Emission and X-Ray Computed Tomography to visualize aerosol deposition in pleated filter

P. -C. Gervais et al.

SEPARATION AND PURIFICATION TECHNOLOGY (2014)

Article Engineering, Chemical

A simple semi-numerical model for designing pleated air filters under dust loading

A. M. Saleh et al.

SEPARATION AND PURIFICATION TECHNOLOGY (2014)

Article Engineering, Chemical

A macroscale model for simulating pressure drop and collection efficiency of pleated filters over time

S. Fotovati et al.

SEPARATION AND PURIFICATION TECHNOLOGY (2012)

Article Materials Science, Textiles

Electrospun PA-66 coating on textile surfaces

Pirjo Heikkilae et al.

TEXTILE RESEARCH JOURNAL (2007)

Article Engineering, Chemical

Effect of bi-modal aerosol mass loading on the pressure drop for gas cleaning industrial filters

JK Lee et al.

AEROSOL SCIENCE AND TECHNOLOGY (2001)

Article Engineering, Chemical

Clogging of fibrous filters by solid aerosol particles - Experimental and modelling study

D Thomas et al.

CHEMICAL ENGINEERING SCIENCE (2001)