Related references
Note: Only part of the references are listed.Biofilm and cell adhesion strength on dental implant surfaces via the laser spallation technique
J. D. Boyd et al.
DENTAL MATERIALS (2021)
Effects of surface roughening on antibacterial and osteogenic properties of Ti-Cu alloys with different Cu contents
Wei Zhang et al.
JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2021)
Roughness and correlations in the transition from island to film growth: Simulations and application to CdTe deposition
Tung B. T. To et al.
APPLIED SURFACE SCIENCE (2021)
Microstructural manipulation and improved mechanical properties of a near α titanium alloy
C. J. Zhang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)
Analysis of the formation of sub-grain boundaries in commercially pure titanium compressed at elevated temperature
Zhipeng Zhao et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)
Tuning the stress in TiN films by regulating the doubly charged ion fraction in a reactive HiPIMS discharge
Rommel Paulo B. Viloan et al.
JOURNAL OF APPLIED PHYSICS (2020)
Developing highly nanoporous titanate structures via wet chemical conversion of DC magnetron sputtered titanium thin films
Matthew D. Wadge et al.
JOURNAL OF COLLOID AND INTERFACE SCIENCE (2020)
Optimization of HiPIMS discharges: The selection of pulse power, pulse length, gas pressure, and magnetic field strength
Nils Brenning et al.
JOURNAL OF VACUUM SCIENCE & TECHNOLOGY A (2020)
Generation of Charged Ti Nanoparticles and Their Deposition Behavior with a Substrate Bias during RF Magnetron Sputtering
Ji-Hye Kwon et al.
COATINGS (2020)
Characteristics, wear and corrosion properties of borided pure titanium by pack boriding near α → β phase transition temperature
Yonghua Duan et al.
CERAMICS INTERNATIONAL (2020)
Pulse length selection for optimizing the accelerated ion flux fraction of a bipolar HiPIMS discharge
Rommel Paulo B. Viloan et al.
PLASMA SOURCES SCIENCE & TECHNOLOGY (2020)
Optimizing the deposition rate and ionized flux fraction by tuning the pulse length in high power impulse magnetron sputtering
Martin Rudolph et al.
PLASMA SOURCES SCIENCE & TECHNOLOGY (2020)
Structural and Electrochemical Characterization of Nanostructured Titanium Thin Films Prepared by DC Magnetron Sputtering with Supported Discharge
A. Kavitha et al.
IRANIAN JOURNAL OF SCIENCE AND TECHNOLOGY TRANSACTION A-SCIENCE (2019)
Effect of Bias Voltage on Mechanical Properties of HiPIMS/RFMS Cosputtered Zr-Si-N Films
Yung-I Chen et al.
MATERIALS (2019)
Pressure dependence of singly and doubly charged ion formation in a HiPIMS discharge
R. Hippler et al.
JOURNAL OF APPLIED PHYSICS (2019)
Controlling the B/Ti ratio of TiBx thin films grown by high-power impulse magnetron sputtering
Babak Bakhit et al.
JOURNAL OF VACUUM SCIENCE & TECHNOLOGY A (2018)
Review Article: Stress in thin films and coatings: Current status, challenges, and prospects
Gregory Abadias et al.
JOURNAL OF VACUUM SCIENCE & TECHNOLOGY A (2018)
Adhesion and mechanical properties of Ti films deposited by DC magnetron sputtering
R. C. Vega-Moron et al.
SURFACE & COATINGS TECHNOLOGY (2018)
Tailoring of titanium thin film properties in high power pulsed magnetron sputtering
Baohua Wu et al.
VACUUM (2018)
Oblique angle deposition of Au/Ti porous getter films
Ming Wu et al.
JOURNAL OF APPLIED PHYSICS (2018)
Tutorial: Reactive high power impulse magnetron sputtering (R-HiPIMS)
Andre Anders
JOURNAL OF APPLIED PHYSICS (2017)
Sputter deposition of Titanium and Nickel thin films in radio frequency magnetron discharge characterized by optical emission spectroscopy and by Rutherford backscattering spectrometry
M. Salhi et al.
THIN SOLID FILMS (2017)
Enhanced properties of tungsten thin films deposited with a novel HiPIMS approach
Ioana-Laura Velicu et al.
APPLIED SURFACE SCIENCE (2017)
Applications of Savitzky-Golay Filter for Seismic Random Noise Reduction
Yanping Liu et al.
ACTA GEOPHYSICA (2016)
Venting temperature determines surface chemistry of magnetron sputtered TiN films
G. Greczynski et al.
APPLIED PHYSICS LETTERS (2016)
ZnO/TiO2 nanohexagon arrays heterojunction photoanode for enhancing power conversion efficiency in dye-sensitized solar cells
Hafiz Muhammad Asif Javed et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2016)
Peak amplitude of target current determines deposition rate loss during high power pulsed magnetron sputtering
G. Greczynski et al.
VACUUM (2016)
Effect of wear of diamond wire on surface morphology, roughness and subsurface damage of silicon wafers
Arkadeep Kumar et al.
WEAR (2016)
Applications of Savitzky-Golay Filter for Seismic Random Noise Reduction
Yanping Liu et al.
ACTA GEOPHYSICA (2016)
Unravelling the physical mechanisms that determine microstructural evolution of ultrathin Volmer-Weber films
V. Elofsson et al.
JOURNAL OF APPLIED PHYSICS (2014)
An investigation of c-HiPIMS discharges during titanium deposition
Paul Michael Barker et al.
SURFACE & COATINGS TECHNOLOGY (2014)
Time-resolved measurement of film growth during high-power pulsed magnetron sputtering (HIPIMS) of titanium
F. Mitschker et al.
JOURNAL OF PHYSICS D-APPLIED PHYSICS (2013)
Dynamic of the growth flux at the substrate during high-power pulsed magnetron sputtering (HiPIMS) of titanium
W. Breilmann et al.
JOURNAL OF PHYSICS D-APPLIED PHYSICS (2013)
Size and shape fine-tuning of SnO2 nanoparticles for highly efficient and stable dye-sensitized solar cells
Ludmila Cojocaru et al.
JOURNAL OF MATERIALS CHEMISTRY A (2013)
Mechanisms of Stranski-Krastanov growth
Arvind Baskaran et al.
JOURNAL OF APPLIED PHYSICS (2012)
An introduction to thin film processing using high-power impulse magnetron sputtering
Daniel Lundin et al.
JOURNAL OF MATERIALS RESEARCH (2012)
High power impulse magnetron sputtering discharge
J. T. Gudmundsson et al.
JOURNAL OF VACUUM SCIENCE & TECHNOLOGY A (2012)
Roughness Parameters for Standard Description of Surface Nanoarchitecture
Hayden K. Webb et al.
SCANNING (2012)
ZrB2 thin films grown by high power impulse magnetron sputtering from a compound target
Mattias Samuelsson et al.
THIN SOLID FILMS (2012)
Titanium film deposition by high-power impulse magnetron sputtering: Influence of pulse duration
F. J. Jing et al.
VACUUM (2012)
Discharge physics of high power impulse magnetron sputtering
Andre Anders
SURFACE & COATINGS TECHNOLOGY (2011)
HiPIMS Ion Energy Distribution Measurements in Reactive Mode
Pierre-Yves Jouan et al.
IEEE TRANSACTIONS ON PLASMA SCIENCE (2010)
Deposition rates of high power impulse magnetron sputtering: Physics and economics
Andre Anders
JOURNAL OF VACUUM SCIENCE & TECHNOLOGY A (2010)
High power pulsed magnetron sputtering: A review on scientific and engineering state of the art
K. Sarakinos et al.
SURFACE & COATINGS TECHNOLOGY (2010)
Measurements of Deposition Rate and Substrate Heating in a HiPIMS Discharge
Glen West et al.
PLASMA PROCESSES AND POLYMERS (2009)
Stress and strain in polycrystalline thin films
G. C. A. M. Janssen
THIN SOLID FILMS (2007)
Properties of titanium thin films deposited by dc magnetron sputtering
Y. L. Jeyachandran et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2006)
Effect of particle size and strain in nanocrystalline SnO2 according to doping concentration of ruthenium
NS Ramgir et al.
SOLID STATE SCIENCES (2006)
Surface structure and composition of flat titanium thin films as a function of film thickness and evaporation rate
KY Cai et al.
APPLIED SURFACE SCIENCE (2005)
Savitzky-Golay smoothing and differentiation filter for even number data
JW Luo et al.
SIGNAL PROCESSING (2005)
Schwoebel-Ehrlich barrier: from two to three dimensions
SJ Liu et al.
APPLIED PHYSICS LETTERS (2002)
Stranski-Krastanov growth of Sn on a polycrystalline Al film surface initiated by the wetting of Al by Sn
C Eisenmenger-Sittner et al.
SURFACE SCIENCE (2001)
A novel method to determine the Ehrlich-Schwoebel barrier
R Gerlach et al.
SURFACE SCIENCE (2001)
Share Paper
