4.7 Article

Application of the reciprocity principle to evaluation of mode-converted scattered shear horizontal (SH) wavefields in tapered thinning plates

Related references

Note: Only part of the references are listed.
Article Acoustics

Unidirectional Shear Horizontal Wave Generation by Periodic Permanent Magnets Electromagnetic Acoustic Transducer With Dual Linear-Coil Array

Alan Conci Kubrusly et al.

Summary: By using a specific design of electromagnetic acoustic transducer, it is possible to generate unidirectional Shear horizontal (SH) waves in metallic media. This design successfully reduces the presence of backward waves, leading to a significant reduction in false alarms in EMAT detection systems.

IEEE TRANSACTIONS ON ULTRASONICS FERROELECTRICS AND FREQUENCY CONTROL (2021)

Article Acoustics

Excitation of Single-Mode Shear-Horizontal Guided Waves and Evaluation of Their Sensitivity to Very Shallow Crack-Like Defects

Pouyan Khalili et al.

Summary: This article investigates the possibility of single-mode excitation of the SH1 mode at around 3 MHz . mm and its ability to detect very shallow defects. Through experiments and analytical predictions, it is shown that a signal dominated by the SH1 mode can be generated using a single PPM EMAT, allowing the detection of very shallow defects that may be missed by standard lower frequency guided wave testing.

IEEE TRANSACTIONS ON ULTRASONICS FERROELECTRICS AND FREQUENCY CONTROL (2021)

Article Acoustics

Mode conversion of SH guided waves with symmetry inversion in plates

Alan C. Kubrusly et al.

Summary: This study investigates the influence of thickness discontinuities on shear horizontal ultrasonic guided waves, revealing that geometrically symmetric but with opposite boundary conditions can act as a symmetry inverter discontinuity. Unlike fully symmetric discontinuities, the effectiveness of a symmetry inverter discontinuity depends on the frequency.

ULTRASONICS (2021)

Article Acoustics

Quantifying adhesive thickness and adhesion parameters using higher-order SH guided waves

Dileep Koodalil et al.

Summary: The method presented quantifies properties in an aluminium-epoxy-aluminium joint using shear horizontal guided waves and dispersion analysis. Experimental validation demonstrates the reliability of this approach in reducing false alarms.

ULTRASONICS (2021)

Review Acoustics

Shear horizontal wave transducers for structural health monitoring and nondestructive testing: A review

Hongchen Miao et al.

Summary: This paper reviews the latest research on SH wave transducers, covering the working principles, advantages and limitations of different types of transducers, as well as the configurations for exciting and receiving SH waves in plates and pipes. These studies are expected to greatly promote the applications of SH waves in SHM, NDT, and related areas such as elastic metamaterials.

ULTRASONICS (2021)

Article Acoustics

Unidirectional Shear Horizontal Wave Generation With Side-Shifted Periodic Permanent Magnets Electromagnetic Acoustic Transducer

Alan C. Kubrusly et al.

IEEE TRANSACTIONS ON ULTRASONICS FERROELECTRICS AND FREQUENCY CONTROL (2020)

Article Materials Science, Characterization & Testing

Interaction of SH guided waves with wall thinning

Alan C. Kubrusly et al.

NDT & E INTERNATIONAL (2019)

Article Acoustics

Mode Selectivity of SH Guided Waves by Dual Excitation and Reception Applied to Mode Conversion Analysis

Alan C. Kubrusly et al.

IEEE TRANSACTIONS ON ULTRASONICS FERROELECTRICS AND FREQUENCY CONTROL (2018)

Article Materials Science, Characterization & Testing

Circumferential guided wave EMAT system for pipeline screening using shear horizontal ultrasound

Matthew Clough et al.

NDT & E INTERNATIONAL (2017)

Article Materials Science, Characterization & Testing

Scattering of guided shear waves in plates with discontinuities

Annamaria Pau et al.

NDT & E INTERNATIONAL (2016)

Article Physics, Applied

Mode Conversion and Total Reflection of Torsional Waves for Pipe Inspection

Nurmalia et al.

JAPANESE JOURNAL OF APPLIED PHYSICS (2013)

Article Materials Science, Characterization & Testing

Mode conversion behavior of SH guided wave in a tapered plate

Nurmalia et al.

NDT & E INTERNATIONAL (2012)

Article Acoustics

The scattering of the fundamental torsional mode from axi-symmetric defects with varying depth profile in pipes

R. Carandente et al.

JOURNAL OF THE ACOUSTICAL SOCIETY OF AMERICA (2010)

Article Materials Science, Characterization & Testing

Prediction of pulse dispersion in tapered waveguides

L. De Marchi et al.

NDT & E INTERNATIONAL (2010)

Article Acoustics

Lamb mode conversion in a plate with a delamination

G Shkerdin et al.

JOURNAL OF THE ACOUSTICAL SOCIETY OF AMERICA (2004)

Article Acoustics

Scattering of the fundamental shear horizontal mode from steps and notches in plates

A Demma et al.

JOURNAL OF THE ACOUSTICAL SOCIETY OF AMERICA (2003)

Article Acoustics

Estimation of ultrasonic guided wave mode conversion in a plate with thickness variation

K Cho

IEEE TRANSACTIONS ON ULTRASONICS FERROELECTRICS AND FREQUENCY CONTROL (2000)