4.4 Article

Magnesium doped semipolar (11-22) p-type gallium nitride: Impact of dopant concentration variants towards grain size distributions and crystalline quality

Journal

THIN SOLID FILMS
Volume 741, Issue -, Pages -

Publisher

ELSEVIER SCIENCE SA
DOI: 10.1016/j.tsf.2021.139003

Keywords

Gallium nitride; Grain size; Cp2Mg; Semi-polar; Thin film

Funding

  1. Universiti Pendidikan Sultan Idris, Malaysia [2020-0295-103-11]
  2. Collaborative Research in Engineering, Science & Technology (CREST) , Penang, Malaysia [PV007-2019]

Ask authors/readers for more resources

In this study, the effect of varying biscyclopentadienyl magnesium flow rate on the growth of p-type gallium nitride thin films was investigated. The results show that using an optimized flux of 30 standard cubic centimeter per minute significantly reduces grain size and improves crystallinity. Additionally, the mobility and carrier concentrations were enhanced with the use of moderate biscyclopentadienyl magnesium flow rate.
In this study, the effect of biscyclopentadienyl magnesium flow rate for the growth of p-type gallium nitride thin films was varied from 20 to 40 standard cubic centimeter per minute to acquire the optimum doping concentration level. The growth of semi-polar (11-22) p-type gallium nitride thin films on m-plane sapphire was accomplished via metal organic chemical vapor deposition. Atomic force microscopy reveals the occurrence of dissimilar grain size distributions upon the utilization of different dopant flow rates. Statistical data shows that the utilization of optimized biscyclopentadienyl magnesium flux of 30 standard cubic centimeter per minute would significantly reduce the grain size to as low as similar to 550 nm (+/- 1 nm), yielding a mot mean square roughness of 6.00 nm. X ray rocking curve analysis observed that a moderate biscyclopentadienyl magnesium flow rate of 30 standard cubic centimeter per minute leads to narrowing in full width at half maximum, indicating an enhanced crystallinity with a reduction of the basal stacking fault density of 8.18 x 10(4) cm(-1) with the use of 30 standard cubic centimeter per minute of biscyclopentadienyl magnesium. Moreover, the mobilities and carrier concentrations were improved to as high as 1.8 cm(2).V-1.s(-1) and 5.5 x 10(17) cm(-3) with a moderate biscyclopentadienyl magnesium flow rate of 30 standard cubic centimeter per minute. The analysis suggests that with the optimum biscyclopentadienyl magnesium flow rate (30 standard cubic centimeter per minute), preferential sites for magnesium incorporation can be enhanced.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.4
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available