Related references
Note: Only part of the references are listed.Structural, Morphological, and Optical Characterization of GaN/p-Si Thin Films for Various Argon Flow Rates
Asim Mantarci
JOM (2020)
Enhancement of thermoelectric properties of sulphurized CZTS nano-crystals by the engineering of secondary phases
A. Ali et al.
SOLID STATE SCIENCES (2020)
Effects of element ratio on robustness of CZTS films: Variations in sulfurization temperature
Jiangtao Xu et al.
CERAMICS INTERNATIONAL (2020)
A third generation solar cell based on wet-chemically etched Si nanowires and sol-gel derived Cu2ZnSnS4 thin films
Elif Peksu et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2019)
CZTS layers formed under sulfur-limited conditions at above atmospheric pressure
M. A. Olgar et al.
MATERIALS SCIENCE IN SEMICONDUCTOR PROCESSING (2019)
CZTS films from three different routes: crystallite size-dependent properties
P. Prabeesh et al.
MATERIALS RESEARCH EXPRESS (2019)
Effect of Ar:N2 flow rate on morphology, optical and electrical properties of CCTO thin films deposited by RF magnetron sputtering
Mohsen Ahmadipour et al.
CERAMICS INTERNATIONAL (2019)
Cliff-like conduction band offset at CdS/Cu2ZnSnS4 heterojunction prepared by sputtering CuSn alloy target using different stacking order
Xinxing Liu et al.
SOLAR ENERGY (2019)
Improving Carrier-Transport Properties of CZTS by Mg Incorporation with Spray Pyrolysis
Stener Lie et al.
ACS APPLIED MATERIALS & INTERFACES (2019)
A two step technique to remove the secondary phases grown by sol - gel method
Arslan Ashfaq et al.
CERAMICS INTERNATIONAL (2019)
The role of sulphur in the sulfurization of CZTS layer prepared by DC magnetron sputtering from a single quaternary ceramic target
Jinchun Jiang et al.
CERAMICS INTERNATIONAL (2018)
Crystallization temperature investigation of Cu2ZnSnS4 by using Differential scanning calorimetry (DSC)
Dagang Miao et al.
CERAMICS INTERNATIONAL (2018)
Compositional disparity in Cu2ZnSnS4 (CZTS) thin film deposited by RF-sputtering from a single quaternary compound target
M. T. Ferdaous et al.
MATERIALS LETTERS (2018)
The role of pre-annealing in the sulfurization of Cu-Zn-Sn stacked metal layer prepared by magnetron sputtering
Jinchun Jiang et al.
MATERIALS SCIENCE IN SEMICONDUCTOR PROCESSING (2018)
Past, present and future of the thin film CdTe/CdS solar cells
A. Bosio et al.
SOLAR ENERGY (2018)
Cu2ZnSnSSe4 solar cells with 9.6% efficiency via selenizing Cu-Zn-Sn-S precursor sputtered from a quaternary target
Rujun Sun et al.
SOLAR ENERGY MATERIALS AND SOLAR CELLS (2018)
Cu2ZnSnS4 solar cells with over 10% power conversion efficiency enabled by heterojunction heat treatment
Chang Yan et al.
NATURE ENERGY (2018)
The characteristic of Cu2ZnSnS4 thin film solar cells prepared by sputtering CuSn and CuZn alloy targets
Yilei Lu et al.
CURRENT APPLIED PHYSICS (2018)
Thin-film solar cells exceeding 22% solar cell efficiency: An overview on CdTe-, Cu(In,Ga)Se2-, and perovskite-based materials
Michael Powalla et al.
APPLIED PHYSICS REVIEWS (2018)
Direct current magnetron sputtered Cu2ZnSnS4 thin films using a ceramic quaternary target
Yan Zhu et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2017)
Growth and properties of Cu2ZnSnS4 thin films prepared by multiple metallic layer stacks as a function of sulfurization time
Narayana Thota et al.
JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS (2017)
Fabrication and characterization of Cu2ZnSnS4 thin films by sputtering a single target at different temperature
Qichen Zhao et al.
PHYSICA B-CONDENSED MATTER (2017)
Ultra-thin Cu2ZnSnS4 solar cell by pulsed laser deposition
Andrea Cazzaniga et al.
SOLAR ENERGY MATERIALS AND SOLAR CELLS (2017)
Composition-ratio control of CZTS films deposited by PLD
Masahiro Kotani et al.
PHYSICA STATUS SOLIDI C: CURRENT TOPICS IN SOLID STATE PHYSICS, VOL 14 NO 6 (2017)
Impact of sol-gel precursor treatment with preheating temperature on properties of Cu2ZnSnS4 thin film and its photovoltaic solar cell
Rongyue Liu et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2016)
Effect of precursor stacking order and sulfurization temperature on compositional homogeneity of CZTS thin films
M. A. Olgar et al.
THIN SOLID FILMS (2016)
Composition controlled preparation of Cu-Zn-Sn precursor films for Cu2ZnSnS4 solar cells using pulsed electrodeposition
Wenping Dang et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2015)
Effect of post-annealing atmosphere on the grain-size and surface morphological properties of pulsed laser deposited CZTS thin films
S. A. Vanalakar et al.
CERAMICS INTERNATIONAL (2014)
Fabrication and Characterization of CZTS Thin Films Prepared by the Sulfurization of RF-Sputtered Stacked Metal Precursors
Mohamed Abusnina et al.
JOURNAL OF ELECTRONIC MATERIALS (2014)
Influence of the sulphurization time on the morphological, chemical, structural and electrical properties of Cu2ZnSnS4 polycrystalline thin films
J. C. Gonzalez et al.
SOLAR ENERGY MATERIALS AND SOLAR CELLS (2014)
Epitaxial growth of kesterite Cu2ZnSnS4 on a Si(001) substrate by thermal co-evaporation
Byungha Shin et al.
THIN SOLID FILMS (2014)
Structural and Optical Properties of the New Absorber Cu2ZnSnS4 Thin Films Grown by Vacuum Evaporation Method
R. Touati et al.
PROCEEDINGS OF E-MRS SPRING MEETING 2013 SYMPOSIUM D ADVANCED INORGANIC MATERIALS AND STRUCTURES FOR PHOTOVOLTAICS (2014)
Effect of post-sulfurization on the composition, structure and optical properties of Cu2ZnSnS4 thin films deposited by sputtering from a single quaternary target
Jun He et al.
APPLIED SURFACE SCIENCE (2013)
Growth of CZTS thin films by sulfurization of sputtered single-layered Cu-Zn-Sn metallic precursors from an alloy target
Shanshan Zhou et al.
JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS (2013)
Study on structural, morphological and electrical properties of sputtered titanium nitride films under different argon gas flow
Nishat Arshi et al.
MATERIALS CHEMISTRY AND PHYSICS (2012)
The path towards a high-performance solution-processed kesterite solar cell
David B. Mitzi et al.
SOLAR ENERGY MATERIALS AND SOLAR CELLS (2011)
Chemical composition dependence of morphological and optical properties of Cu2ZnSnS4 thin films deposited by sol-gel sulfurization and Cu2ZnSnS4 thin film solar cell efficiency
Kunihiko Tanaka et al.
SOLAR ENERGY MATERIALS AND SOLAR CELLS (2011)
New routes to sustainable photovoltaics:: evaluation of Cu2ZnSnS4 as an alternative absorber material
Jonathan J. Scragg et al.
PHYSICA STATUS SOLIDI B-BASIC SOLID STATE PHYSICS (2008)
Optical and photoelectric properties of SnS thin films prepared by chemical bath deposition
A Tanusevski
SEMICONDUCTOR SCIENCE AND TECHNOLOGY (2003)
Share Paper
