Journal
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
Volume 835, Issue -, Pages -Publisher
ELSEVIER SCIENCE SA
DOI: 10.1016/j.msea.2022.142657
Keywords
Directed energy deposition (DED); Laser powder bed fusion (L-PBF); 630 stainless steel; Building direction; Charpy test; Crack propagation
Categories
Funding
- Korea Evaluation Institute of Industrial Technology (KEIT) [K-G012000875302]
- National Research Foundation of Korea (NRF) from the Ministry of Science and ICT [2021R1A2C101197311]
- Korea Institute for Advancement of Technology (KIAT) - Korea Government (MOTIE) [P0008763]
Ask authors/readers for more resources
The study found that the interfacial characteristics, hardness, and crack propagation properties of materials deposited by hybrid metal additive manufacturing processes (L-PBFed and DEDed) vary depending on the relative building directions. Defects at the interface between PBFed and DEDed were due to oxidized powder and non-uniform powder distribution, resulting in different retained austenite fractions and hardness between the DEDed and L-PBFed regions. Despite interfacial defects, crack resistance increased when crack propagation direction was perpendicular to the L-PBFed layer plane, but cracks progressed rapidly when propagation direction was parallel to the interlayer plane.
In this study, the interfacial characteristics of materials deposited by hybrid metal additive manufacturing (AM) processes (laser powder bed fusion (L-PBFed) and directed energy deposition (DEDed)) were investigated. The deposition characteristics, microstructure, bonding properties, and crack propagation characteristics at the interface were analyzed with different relative building directions of L-PBFed and DEDed. The additional layers by DED were deposited on the top surface (L-PBFed-Tracked surface) and on the side (L-PBFed-Layered surface) of the substrate built by L-PBFed. Defects occurred at the interface between PBFed and DEDed during the DED process due to the oxidized powder and non-uniform distribution of powders on the rougher surface of L-PBFed-Layered compared to L-PBFed-Tracked. Moreover, owing to the difference in the laser absorption rate and cooling rate caused by the difference in surface roughness, the retained austenite fraction of the DEDed region appeared different. In particular, the DEDed region exhibited a higher retained austenite fraction because it had a higher content of austenite-stabilizing elements than the L-PBFed region; thus, the hardness decreased signifi-cantly. In some parts of the heat-affected zone, the hardness increased significantly because of aging effect. An impact test was performed to investigate the crack-propagation characteristics at the interface according to the relative building directions of DEDed and L-PBFed. Consequently, despite the interfacial defect at the interface of the DEDed and L-PBFed depositions, the resistance to cracking increased when the crack-propagation direction was perpendicular to the L-PBFed layer plane. However, even if there were no defects at the interface of the DEDed and L-PBFed parts, cracks progressed rapidly after a low plastic deformation in the specimen whose crack propagation direction was parallel to interlayer plane. This suggests that the characteristics at the DEDed/L-PBFed interface vary considerably depending on the relative building directions of the two metal AM processes.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available