Related references
Note: Only part of the references are listed.Ferrite phase transformation in dual-phase steel under shock loading
Ali Ameri et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2021)
Effects of load partitioning and texture on the plastic anisotropy of duplex stainless steel alloys under quasi-static loading conditions
Ali Ameri et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)
Spall strength of a mild carbon steel: Effects of tensile stress history and shock-induced microstructure
C. Li et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)
In-situ micro-tensile investigation of strain rate response along < 100 > and < 110 > directions in single crystal nickel
Alan Xu et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2018)
Dynamic deformation of hydrogen charged austenitic-ferritic steels: Hydrogen trapping mechanisms, and simulations
R. Silverstein et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2018)
Effect of peak stress and tensile strain-rate on spall in tantalum
D. R. Jones et al.
JOURNAL OF APPLIED PHYSICS (2018)
Twin nucleation in cold rolled low carbon steel subjected to plate impacts
W. Visser et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)
Effects of structural anisotropy on deformation and damage of a duplex stainless steel under high strain rate loading
C. Li et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)
Structure/property (constitutive and spallation response) of additively manufactured 316L stainless steel
G. T. Gray et al.
ACTA MATERIALIA (2017)
Failure of metals I: Brittle and ductile fracture
A. Pineau et al.
ACTA MATERIALIA (2016)
Influences of hydrogen and textural anisotropy on the microstructure and mechanical properties of duplex stainless steel at high strain rate (∼105 s-1)
R. Silverstein et al.
JOURNAL OF MATERIALS SCIENCE (2016)
Spall damage of a mild carbon steel: Effects of peak stress, strain rate and pulse duration
C. Li et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2016)
Development of a Lean Duplex Stainless Steel
Mats Liljas et al.
STEEL RESEARCH INTERNATIONAL (2016)
Lagrangian analysis led design of a shock recovery plate impact experiment
Rade Vignjevic et al.
INTERNATIONAL JOURNAL OF IMPACT ENGINEERING (2015)
Microstructural Effects on Damage Nucleation in Shock-Loaded Polycrystalline Copper
Andrew David Brown et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2015)
Dynamic failure in two-phase materials
S. J. Fensin et al.
JOURNAL OF APPLIED PHYSICS (2015)
Effect of loading direction on grain boundary failure under shock loading
S. J. Fensin et al.
ACTA MATERIALIA (2014)
Influence of hydrogen on microstructure and dynamic strength of lean duplex stainless steel
Ravit Silverstein et al.
JOURNAL OF MATERIALS SCIENCE (2014)
The effect of shock-wave profile on dynamic brittle failure
J. P. Escobedo et al.
JOURNAL OF APPLIED PHYSICS (2013)
The role of cold work on the shock response of tantalum
J. C. F. Millett et al.
JOURNAL OF APPLIED PHYSICS (2013)
An experimental investigation into the micro-mechanics of spall initiation and propagation in Ti-6Al-4V during shock loading
E. Wielewski et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2013)
Early stage dynamic damage and the role of grain boundary type
E. K. Cerreta et al.
SCRIPTA MATERIALIA (2012)
Design of a novel Mn-based 1 GPa duplex stainless TRIP steel with 60% ductility by a reduction of austenite stability
C. Herrera et al.
ACTA MATERIALIA (2011)
Effects of grain size and boundary structure on the dynamic tensile response of copper
J. P. Escobedo et al.
JOURNAL OF APPLIED PHYSICS (2011)
Deformation characteristics of low carbon steel subjected to dynamic impact loading
W. Visser et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2011)
Electron backscattering diffraction analysis of secondary cleavage:: cracks in a reactor pressure vessel steel
J Nohava et al.
MATERIALS CHARACTERIZATION (2002)
Influence of elastic and plastic anisotropy on the flow behavior in a duplex stainless steel
JJ Moverare et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2002)