Related references
Note: Only part of the references are listed.Three-dimensional heat transfer of globe thermometers in indoor environments controlled by radiant systems
Daoming Xing et al.
BUILDING AND ENVIRONMENT (2021)
A critical review of passive condensation prevention for radiant cooling
Daoming Xing et al.
BUILDING AND ENVIRONMENT (2021)
Thermal sensation and thermal load of human body in irradiated hot environment
Atsumasa Yoshida et al.
URBAN CLIMATE (2021)
Thermal performance improvement for the ceiling radiant cooling panel with an inbuilt air gap by the convection shield
Daoming Xing et al.
SUSTAINABLE ENERGY TECHNOLOGIES AND ASSESSMENTS (2021)
Cooling load dynamics and simplified calculation method for radiant ceiling panel and dedicated outdoor air system
Baisong Ning et al.
ENERGY AND BUILDINGS (2020)
Influence of the arrangement of multiple radiant ceiling panels on the radiant temperature field
Matthieu Labat et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2020)
Theoretical study of infrared transparent cover preventing condensation on indoor radiant cooling surfaces
Daoming Xing et al.
ENERGY (2020)
Thermal comfort under asymmetric cold radiant environment at different exposure distances
Xiaowen Su et al.
BUILDING AND ENVIRONMENT (2020)
Numerical Study and Optimization of a Combined Thermoelectric Assisted Indirect Evaporative Cooling System
Yuanyuan Zhou et al.
JOURNAL OF THERMAL SCIENCE (2020)
A field study of occupant thermal comfort with radiant ceiling cooling and overhead air distribution system
Zhen Tian et al.
ENERGY AND BUILDINGS (2020)
Numerical investigation of general and local thermal comfort of an office equipped with radiant panels
Berrin Karacavus et al.
INDOOR AND BUILT ENVIRONMENT (2019)
Thermal comfort under radiant asymmetries of floor cooling system in 2 h and 8 h exposure durations
Xiang Zhou et al.
ENERGY AND BUILDINGS (2019)
Local effects on thermal comfort: Experimental investigation of small-area radiant cooling and low-speed draft caused by improperly retrofitted construction joints
Stijn Van Craenendonck et al.
BUILDING AND ENVIRONMENT (2019)
Monte Carlo calculation of view factors between some complex surfaces: Rectangular plane and parallel cylinder, rectangular plane and torus, especially cold-rolled strip and W-shaped radiant tube in continuous annealing furnace
Fei He et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2018)
A human thermal balance based evaluation of thermal comfort subject to radiant cooling system and sedentary status
S. Gao et al.
APPLIED THERMAL ENGINEERING (2017)
Radiation exchange between persons and surfaces for building energy simulations
Mette Havgaard Vorre et al.
ENERGY AND BUILDINGS (2015)
Calculation of view factors for complex geometries using Stokes' theorem
Sara C. Francisco et al.
JOURNAL OF BUILDING PERFORMANCE SIMULATION (2014)
A nodal model to predict vertical temperature distribution in a room with floor heating and displacement ventilation
Xiaozhou Wu et al.
BUILDING AND ENVIRONMENT (2013)
Experimental study on the globe thermometer behaviour in conditions of asymmetry of the radiant temperature
L. Fontana
APPLIED THERMAL ENGINEERING (2010)
Evaluation of thermal comfort using combined CFD and experimentation study in a test room equipped with a cooling ceiling
Tiberiu Catalina et al.
BUILDING AND ENVIRONMENT (2009)
Share Paper
