Related references
Note: Only part of the references are listed.Dislocation-mediated shear amorphization in boron carbide
Kolan Madhav Reddy et al.
SCIENCE ADVANCES (2021)
Spark plasma sintering of B4C and B4C-TiB2 composites: Deformation and failure mechanisms under quasistatic and dynamic loading
W. S. Rubink et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2021)
Effect of aspect ratio on dynamic fracture toughness of particulate polymer composite using artificial neural network
Aanchna Sharma et al.
ENGINEERING FRACTURE MECHANICS (2020)
Advancing the mechanical properties of Si/B co-doped boron carbide through TiB2 reinforcement
Qirong Yang et al.
MATERIALS LETTERS (2020)
Amorphization Mitigation in Boron-Rich Boron Carbides Quantified by Raman Spectroscopy
Mark C. Schaefer et al.
CERAMICS-SWITZERLAND (2020)
Small amount TiB2 addition into B4C through sputter deposition and hot pressing
Chawon Hwang et al.
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2019)
Uniaxial tensile strength and fracture analysis of a hot-pressed boron carbide
Jeffrey J. Swab et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2019)
Experimental observations of amorphization in stoichiometric and boron-rich boron carbide
Ankur Chauhan et al.
ACTA MATERIALIA (2019)
Tuning the deformation mechanisms of boron carbide via silicon doping
Sisi Xiang et al.
SCIENCE ADVANCES (2019)
Fabrication and characterization of arc melted Si/B co-doped boron carbide
Qirong Yang et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2019)
Progress in pressureless sintering of boron carbide ceramics - a review
Wei Zhang et al.
ADVANCES IN APPLIED CERAMICS (2019)
Locating Si atoms in Si-doped boron carbide: A route to understand amorphization mitigation mechanism
Atta U. Khan et al.
ACTA MATERIALIA (2018)
Effects of fiber type, volume fraction and aspect ratio on the flexural and acoustic emission behaviors of steel fiber reinforced concrete
Biao Li et al.
CONSTRUCTION AND BUILDING MATERIALS (2018)
Grain Boundary Sliding and Amorphization are Responsible for the Reverse Hall-Petch Relation in Superhard Nanocrystalline Boron Carbide
Dezhou Guo et al.
PHYSICAL REVIEW LETTERS (2018)
Ductility in Crystalline Boron Subphosphide (B12P2) for Large Strain Indentation
Qi An et al.
JOURNAL OF PHYSICAL CHEMISTRY C (2017)
Structure and mechanical properties of boron-rich boron carbides
Chun Cheng et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2017)
The effect of Si on the microstructure and mechanical properties of spark plasma sintered boron carbide
Luoning Ma et al.
MATERIALS CHARACTERIZATION (2017)
Microstructural characterization of boron-rich boron carbide
Kelvin Y. Xie et al.
ACTA MATERIALIA (2017)
Microstructural Characterization of a Commercial Hot-Pressed Boron Carbide Armor Plate
Kelvin Y. Xie et al.
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2016)
Rate-Dependent Mechanical Behavior and Amorphization of Ultrafine-Grained Boron Carbide
Matthew DeVries et al.
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2016)
Grain size dependence of hardness and fracture toughness in pure near fully-dense boron carbide ceramics
Bibi Malmal Moshtaghioun et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2016)
Directional amorphization of boron carbide subjected to laser shock compression
Shiteng Zhao et al.
PROCEEDINGS OF THE NATIONAL ACADEMY OF SCIENCES OF THE UNITED STATES OF AMERICA (2016)
In search of amorphization-resistant boron carbide
Ghatu Subhash et al.
SCRIPTA MATERIALIA (2016)
Electrically conductive graphene nanoplatelet/boron carbide composites with high hardness and toughness
Yongqiang Tan et al.
SCRIPTA MATERIALIA (2016)
Enhancing Toughness in Boron Carbide with Reduced Graphene Oxide
Lixin Liu et al.
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2016)
Raman spectroscopic characterization of the core-rim structure in reaction bonded boron carbide ceramics
Phillip Jannotti et al.
APPLIED PHYSICS LETTERS (2015)
Atomistic Origin of Brittle Failure of Boron Carbide from Large-Scale Reactive Dynamics Simulations: Suggestions toward Improved Ductility
Qi An et al.
PHYSICAL REVIEW LETTERS (2015)
Substitution of silicon within the rhombohedral boron carbide (B4C) crystal lattice through high-energy ball-milling
Manoj K. Kolel-Veetil et al.
JOURNAL OF MATERIALS CHEMISTRY C (2015)
Stabilization of boron carbide via silicon doping
J. E. Proctor et al.
JOURNAL OF PHYSICS-CONDENSED MATTER (2015)
Shock Compression of Boron Carbide: A Quantum Mechanical Analysis
DeCarlos E. Taylor
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2015)
Microalloying Boron Carbide with Silicon to Achieve Dramatically Improved Ductility
Qi An et al.
JOURNAL OF PHYSICAL CHEMISTRY LETTERS (2014)
Atomistic Explanation of Shear-Induced Amorphous Band Formation in Boron Carbide
Qi An et al.
PHYSICAL REVIEW LETTERS (2014)
Preparation of B4C-SiC composite ceramics through hot pressing assisted by mechanical alloying
Zhixiao Zhang et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2013)
Spark Plasma Sintering of Superhard B4CZrB2 Ceramics by Carbide Boronizing
Ji Zou et al.
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2013)
Silicon carbide-titanium diboride ceramic composites
Derek S. King et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2013)
Toughening of super-hard ultra-fine grained B4C densified by spark-plasma sintering via SiC addition
B. Malmal Moshtaghioun et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2013)
Raman spectroscopy investigation of alpha boron at elevated pressures and temperatures
G. Parakhonskiy et al.
SOLID STATE COMMUNICATIONS (2013)
Atomic structure of amorphous shear bands in boron carbide
K. Madhav Reddy et al.
NATURE COMMUNICATIONS (2013)
Influence of stress state and strain rate on structural amorphization in boron carbide
Dipankar Ghosh et al.
JOURNAL OF APPLIED PHYSICS (2012)
Spark plasma sintering of B4C-SiC composites
Filiz Cinar Sahin et al.
SOLID STATE SCIENCES (2012)
Enhanced mechanical properties of nanocrystalline boron carbide by nanoporosity and interface phases
K. Madhav Reddy et al.
NATURE COMMUNICATIONS (2012)
An experimental study on ballistic performance of boron carbide tiles
S. G. Savio et al.
INTERNATIONAL JOURNAL OF IMPACT ENGINEERING (2011)
Boron Carbide: Structure, Properties, and Stability under Stress
Vladislav Domnich et al.
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2011)
In situ synthesis and densification of submicrometer-grained B4C-TiB2 composites by pulsed electric current sintering
S. G. Huang et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2011)
Microstructure and mechanical properties of pulsed electric current sintered B4C-TiB2 composites
S. G. Huang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2011)
Mechanism for amorphization of boron carbide B4C under uniaxial compression
Sitaram Aryal et al.
PHYSICAL REVIEW B (2011)
Effect of TiB2 content on microstructure and mechanical properties of in-situ fabricated TiB2/B4C composites
Wang Yu-jin et al.
TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2011)
Sintering of binderless tungsten carbide
Kuo-Ming Tsai et al.
CERAMICS INTERNATIONAL (2010)
Flexural Strength, Fracture Toughness, and Hardness of Silicon Carbide and Boron Carbide Armor Ceramics
Lionel Vargas-Gonzalez et al.
INTERNATIONAL JOURNAL OF APPLIED CERAMIC TECHNOLOGY (2010)
Synthesis and consolidation of boron carbide: a review
A. K. Suri et al.
INTERNATIONAL MATERIALS REVIEWS (2010)
Microstructural evolution during the infiltration of boron carbide with molten silicon
Shmuel Hayun et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2010)
Review: liquid phase sintering
Randall M. German et al.
JOURNAL OF MATERIALS SCIENCE (2009)
Depressurization Amorphization of Single-Crystal Boron Carbide
X. Q. Yan et al.
PHYSICAL REVIEW LETTERS (2009)
Effect of crack growth dynamics on the rate-sensitive behavior of hot-pressed boron carbide
B. Paliwal et al.
SCRIPTA MATERIALIA (2007)
Mechanical scratching induced phase transitions and reactions of boron carbide
Mingwei Chen et al.
JOURNAL OF APPLIED PHYSICS (2006)
Characterization and evaluation of boron carbide for plate-impact conditions
T. J. Holmquist et al.
JOURNAL OF APPLIED PHYSICS (2006)
Silicon doped boron carbide nanorod growth via a solid-liquid-solid process
WQ Han
APPLIED PHYSICS LETTERS (2006)
Pressureless sintering of boron carbide
TK Roy et al.
CERAMICS INTERNATIONAL (2006)
Erosion wear of boron carbide ceramic nozzles by abrasive air-jets
JX Deng
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2005)
Microstructural characterization of commercial hot-pressed boron carbide ceramics
MW Chen et al.
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2005)
SiC-B4C composites for synergistic enhancement of thermoelectric property
M Uehara et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2004)
Hardness of covalent crystals
FM Gao et al.
PHYSICAL REVIEW LETTERS (2003)
High strength B4C-TiB2 composites fabricated by reaction hot-pressing
S Yamada et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2003)
Shock-induced localized amorphization in boron carbide
MW Chen et al.
SCIENCE (2003)
Nanoindentation and Raman spectroscopy studies of boron carbide single crystals
V Domnich et al.
APPLIED PHYSICS LETTERS (2002)
High strength-high toughness B4C-TiB2 composites
V Skorokhod et al.
JOURNAL OF MATERIALS SCIENCE LETTERS (2000)
Material properties of titanium diboride
RG Munro
JOURNAL OF RESEARCH OF THE NATIONAL INSTITUTE OF STANDARDS AND TECHNOLOGY (2000)