Related references
Note: Only part of the references are listed.Micromechanical-based experimental and analytical studies on rate effects and stick-slip instability of smooth quartz surfaces in the presence of plastic and non-plastic gouges
Sathwik S. Kasyap et al.
INTERNATIONAL JOURNAL FOR NUMERICAL AND ANALYTICAL METHODS IN GEOMECHANICS (2021)
Desiccation crack formation beneath the surface
Budi Zhao et al.
GEOTECHNIQUE (2020)
Micromechanical experiments using a new inter-granule loading apparatus on gravel to ballast-sized materials
Chitta Sai Sandeep et al.
FRICTION (2020)
Modeling hydraulic fracturing in jointed shale formation with the use of fully coupled discrete element method
Chung-Yee Kwok et al.
ACTA GEOTECHNICA (2020)
On the initiation, propagation and reorientation of simultaneously-induced multiple hydraulic fractures
Kang Duan et al.
COMPUTERS AND GEOTECHNICS (2020)
A comparative study of fracture surface roughness and flow characteristics between CO2 and water fracturing
C. P. Zhang et al.
JOURNAL OF NATURAL GAS SCIENCE AND ENGINEERING (2020)
Nucleation of Stick-Slip Instability Within a Large-Scale Experimental Fault: Effects of Stress Heterogeneities Due to Loading and Gouge Layer Compaction
L. Buijze et al.
JOURNAL OF GEOPHYSICAL RESEARCH-SOLID EARTH (2020)
DEM numerical simulation study on fracture propagation of synchronous fracturing in a double fracture rock mass
Wei-min Yang et al.
GEOMECHANICS AND GEOPHYSICS FOR GEO-ENERGY AND GEO-RESOURCES (2020)
Dry, damp, or drenched? The effect of water saturation on the frictional properties of clay fault gouges
Steven J. Beynon et al.
JOURNAL OF STRUCTURAL GEOLOGY (2020)
Experimental Study on Shear Behavior and a Revised Shear Strength Model for Infilled Rock Joints
Yanlin Zhao et al.
INTERNATIONAL JOURNAL OF GEOMECHANICS (2020)
Flow-to-Friction Transition in Simulated Calcite Gouge: Experiments and Microphysical Modeling
Jianye Chen et al.
JOURNAL OF GEOPHYSICAL RESEARCH-SOLID EARTH (2020)
Sliding mechanical properties of fault gouge studied from ring shear test-based microscopic morphology characterization
Han Bao et al.
ENGINEERING GEOLOGY (2020)
The physics of fault friction: insights from experiments on simulated gouges at low shearing velocities
Berend A. Verberne et al.
SOLID EARTH (2020)
An Experimental Investigation on the Tribological Behaviour of Nominally Flat Quartz Grains with Gouge Material in Dry, Partial Saturated and Submersed Conditions
S. S. Kasyap et al.
PURE AND APPLIED GEOPHYSICS (2020)
Asperity Failure Control of Stick-Slip Along Brittle Faults
Xiaofeng Chen et al.
PURE AND APPLIED GEOPHYSICS (2020)
An experimental study of two-phase flow behaviour through pipes and hydraulically-fractured rock specimens
W. A. M. Wanniarachchi et al.
EXPERIMENTAL THERMAL AND FLUID SCIENCE (2019)
Simulation of proppant distribution in hydraulically fractured shale network during shut-in periods
Fei Wang et al.
JOURNAL OF PETROLEUM SCIENCE AND ENGINEERING (2019)
Evaluation of injection well patterns for optimum fracture network generation host-rock formations: An application in in-situ leaching
V. R. S. De Silva et al.
MINERALS ENGINEERING (2019)
Stress-dependent fracture porosity and permeability of fractured coal: An in-situ X-ray tomography study
Guanglei Zhang et al.
INTERNATIONAL JOURNAL OF COAL GEOLOGY (2019)
Intermittent and multi-stage fracture stimulation to optimise fracture propagation around a single injection well for enhanced in-situ leaching applications
V. R. S. De Silva et al.
ENGINEERING FRACTURE MECHANICS (2019)
Experimental Investigation of the Coupled Influence of Rate of Loading and Contact Time on the Frictional Behavior of Quartz Grain Interfaces under Varying Normal Load
Sathwik S. Kasyap et al.
INTERNATIONAL JOURNAL OF GEOMECHANICS (2019)
Physical Modeling of Shear Behavior of Infilled Rock Joints Under CNL and CNS Boundary Conditions
Amit Kumar Shrivastava et al.
ROCK MECHANICS AND ROCK ENGINEERING (2018)
Experimental study of residual strength and the index of shear strength characteristics of clay soil
Chengshun Xu et al.
ENGINEERING GEOLOGY (2018)
Geophysical Signatures of Shear-Induced Damage and Frictional Processes on Rock Joints
Ahmadreza Hedayat et al.
JOURNAL OF GEOPHYSICAL RESEARCH-SOLID EARTH (2018)
Frictional behaviour of sandstone: A sample-size dependent triaxial investigation
Hamid Roshan et al.
JOURNAL OF STRUCTURAL GEOLOGY (2017)
The effect of water on strain localization in calcite fault gouge sheared at seismic slip rates
Marieke Rempe et al.
JOURNAL OF STRUCTURAL GEOLOGY (2017)
Horizontal respect distance for hydraulic fracturing in the vicinity of existing faults in deep geological reservoirs: a review and modelling study
Rachel F. Westwood et al.
GEOMECHANICS AND GEOPHYSICS FOR GEO-ENERGY AND GEO-RESOURCES (2017)
Constraints from fault roughness on the scale-dependent strength of rocks
Emily E. Brodsky et al.
GEOLOGY (2016)
Effect of particle shape on the shear strength of fault gouge
Kwang Yeom Kim et al.
GEOSCIENCES JOURNAL (2016)
Distinct element modeling of strength variation in jointed rock masses under uniaxial compression
Tao Wang et al.
GEOMECHANICS AND GEOPHYSICS FOR GEO-ENERGY AND GEO-RESOURCES (2016)
Laboratory Estimation of Rock Joint Stiffness and Frictional Parameters
Pinnaduwa H. S. W. Kulatilake et al.
GEOTECHNICAL AND GEOLOGICAL ENGINEERING (2016)
Shear strength of discontinuities in sedimentary rock masses based on direct shear tests
Manouchehr Sanei et al.
INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES (2015)
Experimental Study on the Shear Strength of Sandy Clay Infilled Regular Rough Rock Joints
Homayoun Jahanian et al.
ROCK MECHANICS AND ROCK ENGINEERING (2015)
Fault reactivation case study for probabilistic assessment of carbon dioxide sequestration
Fernanda L. G. Pereira et al.
INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES (2014)
Effects of Cyclic Loading on the Shear Behaviour of Infilled Rock Joints Under Constant Normal Stiffness Conditions
Ali Mirzaghorbanali et al.
ROCK MECHANICS AND ROCK ENGINEERING (2014)
Experimental study of strain localization in sensitive clays
Anders Samstad Gylland et al.
ACTA GEOTECHNICA (2014)
Evolution of Wear and Friction Along Experimental Faults
Y. Boneh et al.
PURE AND APPLIED GEOPHYSICS (2014)
Measuring Water Retention Curves for Rough Joints with Random Apertures
Y. Wang et al.
GEOTECHNICAL TESTING JOURNAL (2013)
Micro-Macro-Shear-Displacement Behavior of Contacting Rough Solids
Shiping Huang et al.
TRIBOLOGY LETTERS (2013)
Effect of polyurethane on the stability of sand-clay mixtures
Jin Liu et al.
BULLETIN OF ENGINEERING GEOLOGY AND THE ENVIRONMENT (2012)
Roughness of fault surfaces over nine decades of length scales
Thibault Candela et al.
JOURNAL OF GEOPHYSICAL RESEARCH-SOLID EARTH (2012)
Connectivity of a network of random discontinuities
J. H. Li et al.
COMPUTERS AND GEOTECHNICS (2011)
The effects of sub-critical and super-critical carbon dioxide adsorption-induced coal matrix swelling on the permeability of naturally fractured black coal
M. S. A. Perera et al.
ENERGY (2011)
Sub- and super-critical carbon dioxide flow behavior in naturally fractured black coal: An experimental study
M. S. A. Perera et al.
FUEL (2011)
Rock-Joint Micromechanics: Relationship of Roughness to Closure and Wave Propagation
Anil Misra et al.
INTERNATIONAL JOURNAL OF GEOMECHANICS (2011)
Breaking Up: Comminution Mechanisms in Sheared Simulated Fault Gouge
K. Mair et al.
PURE AND APPLIED GEOPHYSICS (2011)
Estimating geometrical and mechanical REV based on synthetic rock mass models at Brunswick Mine
Kamran Esmaieli et al.
INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES (2010)
Frictional strength and strain weakening in simulated fault gouge: Competition between geometrical weakening and chemical strengthening
Andre Niemeijer et al.
JOURNAL OF GEOPHYSICAL RESEARCH-SOLID EARTH (2010)
Comparison of shear strength of sand backfills measured in small-scale and large-scale direct shear tests
Christopher A. Bareither et al.
CANADIAN GEOTECHNICAL JOURNAL (2008)
Shear strength model for overconsolidated clay-infilled idealised rock joints
B. Indraratna et al.
GEOTECHNIQUE (2008)
Estimating the relation between surface roughness and mechanical properties of rock joints
Yujing Jiang et al.
INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES (2006)
Empirical estimation of rock mass modulus
E Hoek et al.
INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES (2006)
Using RQD to estimate the deformation modulus of rock masses
LY Zhang et al.
INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES (2004)
Influence of normal stress and grain shape on granular friction: Results of discrete element simulations
YG Guo et al.
JOURNAL OF GEOPHYSICAL RESEARCH-SOLID EARTH (2004)
Effect of asperity damage on shear behavior of single fracture
A Misra
ENGINEERING FRACTURE MECHANICS (2002)
The scale dependence of rock joint surface roughness
N Fardin et al.
INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES (2001)
Non-linear soil stiffness in routine design
JH Atkinson
GEOTECHNIQUE (2000)
Share Paper
