4.7 Article

Rotator phases in hexadecane emulsion drops revealed by X-ray synchrotron techniques

Journal

JOURNAL OF COLLOID AND INTERFACE SCIENCE
Volume 604, Issue -, Pages 260-271

Publisher

ACADEMIC PRESS INC ELSEVIER SCIENCE
DOI: 10.1016/j.jcis.2021.06.122

Keywords

Rotator phase; Plastic phase; SAXS; WAXS; Self-shaping drops; Emulsion

Funding

  1. Bulgarian Ministry of Education and Science, under the National Research Program VIHREN
  2. project ROTA-Active [KP-06-DV-4/16.12.2019]
  3. Operational Program Science and Education for Smart Growth, Bulgaria [BG05M2OP001-1.002-0012]
  4. project CALIPSOplus from the EU [730872, 20202101]

Ask authors/readers for more resources

The study found that micrometer sized alkane-in-water emulsion drops, stabilized by appropriate long-chain surfactants, spontaneously transform into regular shapes upon cooling. By combining small-and wide-angle X-ray scattering with optical microscopy and DSC measurements, researchers discovered the formation of intermediate, metastable rotator phases in the alkane drops before crystallization, supporting a mechanism of drop self-shaping.
Hypothesis: Micrometer sized alkane-in-water emulsion drops, stabilized by appropriate long-chain surfactants, spontaneously break symmetry upon cooling and transform consecutively into series of regular shapes (Denkov et al., Nature 2015, 528, 392). Two mechanisms were proposed to explain this phe-nomenon of drop self-shaping. One of these mechanisms assumes that thin layers of plastic rotator phase form at the drop surface around the freezing temperature of the oil. This mechanism has been supported by several indirect experimental findings but direct structural characterization has not been reported so far. Experiments: We combine small-and wide-angle X-ray scattering (SAXS/WAXS) with optical microscopy and DSC measurements of self-shaping drops in emulsions. Findings: In the emulsions exhibiting drop self-shaping, the scattering spectra reveal the formation of intermediate, metastable rotator phases in the alkane drops before their crystallization. In addition, shells of rotator phase were observed to form in hexadecane drops, stabilized by C16EO10 surfactant. This rotator phase melts at ca. 16.6 degrees C which is significantly lower than the melting temperature of crystalline hexadecane, 18 degrees C. The scattering results are in a very good agreement with the complementary optical observations and DSC measurements. (C) 2021 Elsevier Inc. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available