Related references
Note: Only part of the references are listed.On flow boiling of R-1270 in a small horizontal tube: Flow patterns and heat transfer
Jeferson Diehl de Oliveira et al.
APPLIED THERMAL ENGINEERING (2020)
Flow boiling heat transfer characteristics using the modified eulerian and wall heat balance model
C. E. Okon et al.
HEAT AND MASS TRANSFER (2020)
A comparative numerical study on two-phase boiling fluid flow and heat transfer in the microchannel heat sink with different manifold arrangements
Yang Luo et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2020)
Experimental and numerical study of combustion characteristics in a liquid fuel CAN micro-combustor
SeyedMohammadReza SadatAkhavi et al.
AEROSPACE SCIENCE AND TECHNOLOGY (2020)
Effect of inlet subcooling on flow boiling in microchannels
Vivian Y. S. Lee et al.
APPLIED THERMAL ENGINEERING (2020)
Schlieren-based simultaneous mapping of bubble dynamics and temperature gradients in nucleate flow boiling regime: Effect of flow rates and degree of subcooling
Gulshan Kumar Sinha et al.
EXPERIMENTAL THERMAL AND FLUID SCIENCE (2019)
A numerical study of subcooled flow boiling in a manifold microchannel heat sink with varying inlet-to-outlet width ratio
Yang Luo et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2019)
Air-water meniscus shape in superhydrophobic triangular microgroove is dictated by a critical pressure under dynamic conditions
Prasenjit Dey et al.
PHYSICS OF FLUIDS (2019)
Conjugate heat transfer analysis of liquid-vapor two phase flow in a microtube: A numerical investigation
Nishant Tiwari et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2019)
Numerical simulation of flow patterns and the effect on heat flux during R32 condensation in microtube
Chunxu Wu et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2018)
Numerical analysis of slug flow boiling in square microchannels
Andrea Ferrari et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2018)
Simulation of Single Bubble Evaporation in a Microchannel in Zero Gravity With Thermocapillary Effect
Wei Li et al.
JOURNAL OF HEAT TRANSFER-TRANSACTIONS OF THE ASME (2018)
Experimental results and design procedures for minichannel condensers and evaporators using propylene
Davide Del Col et al.
INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID (2017)
Numerical simulation of subcooled flow boiling under conjugate heat transfer and microgravity condition in a vertical mini channel
M. Bahreini et al.
APPLIED THERMAL ENGINEERING (2017)
Evaluation of thermal-hydraulic performance of hydrocarbon refrigerants during flow boiling in a microchannels array heat sink
Cristian A. Chavez et al.
APPLIED THERMAL ENGINEERING (2017)
Investigations of leakage mechanisms and its influences on a micro swing engine considering rarefaction effects
Xiong Zhou et al.
APPLIED THERMAL ENGINEERING (2016)
An empirical study on evaporation heat transfer characteristics and flow pattern visualization in tubes with coiled wire inserts
Maziar Shafaee et al.
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2016)
Heat transfer during convective boiling inside microchannels
Fabio Toshio Kanizawa et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2016)
Numerical and experimental investigation on the effects of diameter and length on high mass flux subcooled flow boiling in horizontal microtubes
Abdolali Khalili Sadaghiani et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2016)
An experimental investigation on flow boiling heat transfer of R-600a in a horizontal small tube
Jeferson Diehl de Oliveira et al.
INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID (2016)
Stability of an evaporating meniscus: Part I - Theoretical analysis
John Polansky et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2016)
Numerical predictions of flow boiling characteristics: Current status, model setup and CFD modeling for different non-uniform heating profiles
M. A. Nemitallah et al.
APPLIED THERMAL ENGINEERING (2015)
Flow Boiling Heat Transfer and Dryout Characteristics of R600a in a Vertical Minichannel
Zahid Anwar et al.
HEAT TRANSFER ENGINEERING (2015)
Flame Dynamics in a Micro-Channeled Combustor
Taaha Hussain et al.
PROCEEDINGS OF THE INTERNATIONAL CONFERENCE OF COMPUTATIONAL METHODS IN SCIENCES AND ENGINEERING 2010 (ICCMSE-2010) (2015)
Numerical analysis of evaporation in microchannel under capillary pumping
Jaroslaw Karwacki et al.
ARCHIVES OF THERMODYNAMICS (2015)
Analysis of two-phase pressure drop fluctuations during micro-channel flow boiling
Yuan Wang et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2014)
Comprehensive experimental investigation of two-phase heat transfer and pressure drop with propane in a minichannel
Davide Del Col et al.
INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID (2014)
Thermal performance of micro-combustors with baffles for thermophotovoltaic system
Dongyue Jiang et al.
APPLIED THERMAL ENGINEERING (2013)
Investigation of two phase heat transfer and pressure drop of propane in a vertical circular minichannel
Muhammad Hamayun Maqbool et al.
EXPERIMENTAL THERMAL AND FLUID SCIENCE (2013)
Experimental study on R-600a boiling in 2.6 mm tube
J. B. Copetti et al.
INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID (2013)
Numerical investigation of an evaporating meniscus in a channel
Hemanth K. Dhavaleswarapu et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2012)
Numerical simulation of bubble behaviors in subcooled flow boiling under swing motion
Jing-hua Wei et al.
NUCLEAR ENGINEERING AND DESIGN (2011)
Microscale combustion: Technology development and fundamental research
Yiguang Ju et al.
PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2011)
Characteristics of liquid ethanol diffusion flames from mini tube nozzles
J. Chen et al.
COMBUSTION AND FLAME (2009)
Two-phase flow instabilities in a silicon microchannels heat sink
D. Bogojevic et al.
INTERNATIONAL JOURNAL OF HEAT AND FLUID FLOW (2009)
Effects of heat flux, mass flux, vapor quality, and saturation temperature on flow boiling heat transfer in microchannels
Stefan S. Bertsch et al.
INTERNATIONAL JOURNAL OF MULTIPHASE FLOW (2009)
Pressure drop and heat transfer during two-phase flow vaporization of propane in horizontal smooth minichannels
Kwang-Il Choi et al.
INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID (2009)
Numerical Simulation of Subcooled Flow Boiling Heat Transfer in Helical Tubes
Jong Chull Jo et al.
JOURNAL OF PRESSURE VESSEL TECHNOLOGY-TRANSACTIONS OF THE ASME (2009)
A 2D numerical simulation of sub-cooled flow boiling at low-pressure and low-flow rates
Said Talebi et al.
NUCLEAR ENGINEERING AND DESIGN (2009)
Transport from a volatile meniscus inside an open microtube
Hao Wang et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2008)
Numerical and experimental investigation of two phase flow during boiling in a coiled tube
Z. Yang et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2008)
Experimental Study of the Relation Between Heat Transfer and Flow Behavior in a Single Microtube
Shih-Che Huang et al.
MICROGRAVITY SCIENCE AND TECHNOLOGY (2008)
Development and scale effects of small Swiss-roll combustors
Nam Il Kim et al.
PROCEEDINGS OF THE COMBUSTION INSTITUTE (2007)
Experimental study of evaporation heat transfer characteristics of refrigerants R-134a and R-407C in horizontal small tubes
YM Lie et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2006)
Pressure drop and heat transfer analysis of flow boiling in a minichannel: influence of the inlet condition on two-phase flow stability
D Brutin et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2004)
Forced convective boiling heat transfer in microtubes at low mass and heat fluxes
TH Yen et al.
INTERNATIONAL JOURNAL OF MULTIPHASE FLOW (2003)
Investigation of two-phase flow pattern, void fraction and pressure drop in a microchannel
A Kawahara et al.
INTERNATIONAL JOURNAL OF MULTIPHASE FLOW (2002)
On numerical modelling of low-pressure subcooled boiling flows
JY Tu et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2002)
Share Paper
