Related references
Note: Only part of the references are listed.Spark plasma sintering of fine-grained WC hard alloys with ultra-low cobalt content
E. A. Lantsev et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2021)
Grain growth behaviour and mechanical properties of coarse-grained cemented carbides with bimodal grain size distributions
Rengui He et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2021)
Microstructures, properties and in situ preparation of novel VC and Al2O3 co-doped WC-Ni3Al-composites by reactive microwave sintering
Jianjun Zhang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2021)
The enhancement of the microstructure and mechanical performances of ultrafine WC-Co cemented carbides by optimizing Cr2(C,N) addition and WC particle sizes
Ding Li et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2021)
Rapid Consolidation of WC-ZrSiO4 Hard Materials by Spark Plasma Sintering: Microstructure, Densification, and Mechanical Properties
Jeong-Han Lee et al.
METALS AND MATERIALS INTERNATIONAL (2021)
WC-0.5Co-xB4C materials prepared by spark plasma sintering: Formation of WC platelet grains
Longfei Chang et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2020)
Preparation and properties of the VC/Cr3C2/TaC doped ultrafine WC-Co tool material by spark plasma sintering
Boxiang Wang et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2020)
A Review on Binderless Tungsten Carbide: Development and Application
Jialin Sun et al.
NANO-MICRO LETTERS (2020)
Nanocrystalline WC-Co composite with ultrahigh hardness and toughness
Yong Peng et al.
COMPOSITES PART B-ENGINEERING (2020)
Tribological Characterization of Micron-/Nano-Sized WC-9%Co Cemented Carbides Prepared by Spark Plasma Sintering at Elevated Temperatures
Saleh Al Wohaibi et al.
MATERIALS (2019)
Cemented carbide microstructures: a review
Jose Garcia et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2019)
Fabrication of ultrafine and high-purity tungsten carbide powders via a carbothermic reduction-carburization process
Kai-Fei Wang et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2019)
In-situ elongated aluminium borate grains toughening WC-1.87 wt % Al2O3-4.13 wt % ZrO2 composite via spark plasma sintering
Jingmao Li et al.
CERAMICS INTERNATIONAL (2019)
Low-energy grain boundaries in WC-Co cemented carbides
Xingwei Liu et al.
ACTA MATERIALIA (2019)
Size-controlled synthesis of high-purity tungsten carbide powders via a carbothermic reduction-carburization process
Kai-Fei Wang et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2019)
Ultrafine WC-0.5Co-xTaC cemented carbides prepared by spark plasma sintering
Longfei Chang et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2019)
Modelling of prismatic grain growth in cemented carbides
M. Bonvalet et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2019)
A new insight into the Sigma=2 grain boundary characteristics in WC powder and in WC-Co sintered materials
Maxime Pellan et al.
ACTA MATERIALIA (2018)
Effect of Co content on microstructure and mechanical properties of ultrafine grained WC-Co cemented carbide sintered by spark plasma sintering
Kui Liu et al.
CERAMICS INTERNATIONAL (2018)
Spark plasma sintering of pure TiCN: Densification mechanism, grain growth and mechanical properties
Guanghong Liu et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2017)
Effects of VC/Cr3C2 on WC grain morphologies and mechanical properties of WC-6wt.%Co cemented carbides
Hao Chen et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2017)
Study of processing routes for WC-MgO composites with varying MgO contents consolidated by FAST/SPS
Markus Radajewski et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2017)
Effects of NbC additions on the microstructure and properties of nonuniform structure WC-Co cemented carbides
Yang Gao et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)
Mechanical properties and microstructure of WC-Fe-Ni-Co cemented carbides prepared by vacuum sintering
Yang Gao et al.
VACUUM (2017)
Determination of microstructure and mechanical properties of functionally graded WC-TiC-Al2O3-GNPS micro-nano composite tool materials via two-step sintering
Jialin Sun et al.
CERAMICS INTERNATIONAL (2017)
Microstructure and characterization of WC-2.8 wt% Al2O3-6.8 wt% ZrO2 composites produced by spark plasma sintering
Xiaojian Xia et al.
CERAMICS INTERNATIONAL (2016)
The effects of fine WC contents and temperature on the microstructure and mechanical properties of inhomogeneous WC-(fine WC-Co) cemented carbides
Qiumin Yang et al.
CERAMICS INTERNATIONAL (2016)
Influence of Grain Refinement on Microstructure and Mechanical Properties of Tungsten Carbide/Zirconia Nanocomposites
Ali Nasser et al.
JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE (2016)
Effect of (Cr0.8V0.2)2 (C,N) addition on microstructure and mechanical properties of WC-8Co cemented carbides
Hong Xie et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2014)
The effects of micron WC contents on the microstructure and mechanical properties of ultrafine WC-(micron WC-Co) cemented carbides
Chao Liu et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2014)
Two step hot pressing sintering of dense fine grained WC-Al2O3 composites
Haixia Qu et al.
CERAMICS INTERNATIONAL (2013)
ZrO2 (3Y) toughened WC composites prepared by spark plasma sintering
Donghai Zheng et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2013)
In-situ elongated β-Si3N4 grains toughened WC composites prepared by one/two-step spark plasma sintering
Donghai Zheng et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2013)
Formation of (W,V)C-x layers at the WC/Co interfaces in the VC-doped WC-Co cemented carbide
I. Sugiyama et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2012)
Bulk WC-Al2O3 composites prepared by spark plasma sintering
Donghai Zheng et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2012)
Spark Plasma-Sintered WC-ZrO2-Co Nanocomposites with High Fracture Toughness and Strength
Amartya Mukhopadhyay et al.
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2010)
Review: liquid phase sintering
Randall M. German et al.
JOURNAL OF MATERIALS SCIENCE (2009)
Processing of ultrafine ZrO2 toughened WC composites
Olivier Malek et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2009)
Effect of VC and NbC additions on microstructure and properties of ultrafine WC-10Co cemented carbides
Xiao Dai-hong et al.
TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2009)
Sintering of binderless WC-Mo2C hard materials by rapid sintering process
Hwan-Cheol Kim et al.
CERAMICS INTERNATIONAL (2008)
Failure mechanism of cemented tungsten carbide dies in wet drawing process of steel cord filament
Rudy Lu et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2008)
Consolidation of binderless WC-TiC by high frequency induction heating sintering
Hwan-Cheol Kim et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2008)
VC- and Cr3C2-doped WC-NbC-Co hardmetals
S. G. Huang et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2008)
Structure and hardness of a hard metal alloy prepared with a WC powder synthesized at low temperature
F. A. da Costa et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2008)
Complexion: A new concept for kinetic engineering in materials science
Shen J. Dillon et al.
ACTA MATERIALIA (2007)
Pressureless sintering and tribological properties of WC-ZrO2 composites
B Basu et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2005)
Fabrication and characterizations of new nanocomposite WC/Al2O3 materials by room temperature ball milling and subsequent consolidation
MS El-Eskandarany
JOURNAL OF ALLOYS AND COMPOUNDS (2005)
Novel ultra-coarse hardmetal grades with reinforced binder for mining and construction
I Konyashin et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2005)
Abrasive wear of WC-FeAl-B and WC-Ni3Al-B composites
M Ahmadian et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2005)
Synthesis of WC and dense WC-xvol.%Co hard materials by high-frequency induction heated combustion method
HC Kim et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2004)
Sintering of nanophase WC-15vol.%Co hard metals by rapid sintering process
HC Kim et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2004)
Microstructures of binderless tungsten carbides sintered by spark plasma sintering process
SI Cha et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2003)
Wear mechanism of tungsten carbide dies during wet drawing of steel tyre cords
S Hollinger et al.
WEAR (2003)
Mechanisms of toughening and strengthening in ceramic-based nanocomposites
H Awaji et al.
MECHANICS OF MATERIALS (2002)
Diffraction reflection of light in a cholesteric liquid crystal in the presence of wave irreversibility and bragg formula for media with nonidentical forward and return wavelengths
OS Eritsyan
JOURNAL OF EXPERIMENTAL AND THEORETICAL PHYSICS (2000)
Share Paper
