Related references
Note: Only part of the references are listed.Life Cycle Assessment (LCA) of BEV's environmental benefits for meeting the challenge of ICExit (Internal Combustion Engine Exit)
Ge Zheng et al.
ENERGY REPORTS (2021)
Combustion and emission characteristics of n-butanol-gasoline blends in SI direct injection gasoline engine
Zhi Tian et al.
RENEWABLE ENERGY (2020)
A feasibility study of implementation of oxy-fuel combustion on a practical diesel engine at the economical oxygen-fuel ratios by computer simulation
Xiang Li et al.
ADVANCES IN MECHANICAL ENGINEERING (2020)
Experimental and numerical study on the influence of cooled EGR on knock tendency, performance and emissions of a downsized spark-ignition engine
Cinzia Tornatore et al.
ENERGY (2019)
Combined effect of influence of nano additives, combustion chamber geometry and injection timing in a DI diesel engine fuelled with ternary (diesel-biodiesel-ethanol) blends
Harish Venu et al.
ENERGY (2019)
Experimental and numerical investigation of performance of an ethanol-gasoline dual-injection engine
Yuan Zhuang et al.
ENERGY (2019)
Comparative study of combustion process and cycle-by-cycle variations of spark-ignition engine fueled with pure methanol, ethanol, and n-butanol at various air-fuel ratios
Zhanming Chen et al.
FUEL (2019)
Electric vehicle battery thermal management system with thermoelectric cooling
Y. Lyu et al.
ENERGY REPORTS (2019)
Legal regulations of restrictions of air pollution made by non-road mobile machinery-the case study for Europe: a review
Konrad J. Walus et al.
ENVIRONMENTAL SCIENCE AND POLLUTION RESEARCH (2018)
Effect of ultra-high injection pressure up to 50 MPa on macroscopic spray characteristics of a multi-hole gasoline direct injection injector fueled with ethanol
Xiang Li et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART D-JOURNAL OF AUTOMOBILE ENGINEERING (2018)
Comprehensive study of key operating parameters on combustion characteristics of butanol-gasoline blends in a high speed SI engine
Kaimin Liu et al.
APPLIED ENERGY (2018)
Impact of intake valve strategies on fuel consumption and knock tendency of a spark ignition engine
Luigi Teodosio et al.
APPLIED ENERGY (2018)
Overview of Powertrain Electrification and Future Scenarios for Non-Road Mobile Machinery
Antti Lajunen et al.
ENERGIES (2018)
Improvement of combustion performance and emissions in diesel engines by fueling n-butanol/diesel/PODE3-4 mixtures
Haozhong Huang et al.
APPLIED ENERGY (2018)
Comparative study of effects of pilot injection and fuel properties on low temperature combustion in diesel engine under a medium EGR rate
Haozhong Huang et al.
APPLIED ENERGY (2016)
Experimental investigation of particle emissions under different EGR ratios on a diesel engine fueled by blends of diesel/gasoline/n-butanol
Haozhong Huang et al.
ENERGY CONVERSION AND MANAGEMENT (2016)
Process intensification for post-combustion CO2 capture with chemical absorption: A critical review
Meihong Wang et al.
APPLIED ENERGY (2015)
Comparative study on alcohols-gasoline and gasoline-alcohols dual-fuel spark ignition (DFSI) combustion for high load extension and high fuel efficiency
Zhi Wang et al.
ENERGY (2015)
Dual-Fuel Spark Ignition (DFSI) combustion fuelled with different alcohols and gasoline for fuel efficiency
Hui Liu et al.
FUEL (2015)
Comparative study on alcohol-gasoline and gasoline-alcohol Dual-Fuel Spark Ignition (DFSI) combustion for engine particle number (PN) reduction
Hui Liu et al.
FUEL (2015)
A high efficiency oxyfuel internal combustion engine cycle with water direct injection for waste heat recovery
Zhi-Jun Wu et al.
ENERGY (2014)
Influence of port-inducted ethanol or gasoline on combustion and emission of a closed cycle diesel engine
Horng-Wen Wu et al.
ENERGY (2014)
Effects of direct injection timing of ethanol fuel on engine knock and lean burn in a port injection gasoline engine
Yuan Zhuang et al.
FUEL (2014)
Experimental study of the effect of water injection on the cycle performance of an internal-combustion Rankine cycle engine
Zhi-jun Wu et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART D-JOURNAL OF AUTOMOBILE ENGINEERING (2014)
Gaseous and particulate matter emissions of biofuel blends in dual-injection compared to direct-injection and port injection
Ritchie Daniel et al.
APPLIED ENERGY (2013)
Primary investigation to leveraging effect of using ethanol fuel on reducing gasoline fuel consumption
Yuan Zhuang et al.
FUEL (2013)
Oxy-fuel combustion of pulverized coal: Characterization, fundamentals, stabilization and CFD modeling
Lei Chen et al.
PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2012)
A Critical Review of Thermal Issues in Lithium-Ion Batteries
Todd M. Bandhauer et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2011)
Pre-combustion, post-combustion and oxy-combustion in thermal power plant for CO2 capture
Mohamed Kanniche et al.
APPLIED THERMAL ENGINEERING (2010)
Combustion characteristics of a closed cycle diesel engine with different intake gas contents
Horng-Wen Wu et al.
APPLIED THERMAL ENGINEERING (2009)
An overview on oxyfuel coal combustion-State of the art research and technology development
Terry Wall et al.
CHEMICAL ENGINEERING RESEARCH & DESIGN (2009)
Carbon Capture for Automobiles Using Internal Combustion Rankine Cycle Engines
Robert W. Bilger et al.
JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME (2009)
Effects of operating parameters on steady and transient behaviors of a closed cycle diesel engine
Horng-Wen Wu et al.
ENERGY CONVERSION AND MANAGEMENT (2006)
Share Paper
