Related references
Note: Only part of the references are listed.Modeling Study of the Impact of Blending N2, CO2, and H2O on Characteristics of CH4 Laminar Premixed Combustion
Fei Ren et al.
ENERGY & FUELS (2020)
Flashback, burning velocities and hydrogen admixture: Domestic appliance approval, gas regulation and appliance development
Harmen de Vries et al.
APPLIED ENERGY (2020)
Concept of hydrogen fired gas turbine cycle with exhaust gas recirculation: Assessment of process performance
Mario Ditaranto et al.
ENERGY (2020)
CFD and kinetic modelling study of methane MILD combustion in O2/N2, O2/CO2 and O2/H2O atmospheres
Yaojie Tu et al.
APPLIED ENERGY (2019)
Hydrogen enrichment of methane and syngas for MILD combustion
Amir Mardani et al.
INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2019)
A Bayesian approach to calibrating hydrogen flame kinetics using many experiments and parameters
John Bell et al.
COMBUSTION AND FLAME (2019)
Design/off-design performance simulation and discussion for the gas turbine combined cycle with inlet air heating
Yongping Yang et al.
ENERGY (2019)
Numerical study of blended fuel natural gas-hydrogen combustion in rich/quench/lean combustor of a micro gas turbine
Sidahmed Meziane et al.
INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2019)
Combustion and emission characteristics from biojet fuel blends in a gas turbine combustor
Ramraj H. Sundararaj et al.
ENERGY (2019)
Comparative study on humidified gas turbine cycles with different air saturator designs
Guangya Zhu et al.
APPLIED ENERGY (2019)
A one-step reduced mechanism for near-limit hydrogen combustion with general stoichiometry
Daniel Fernandez-Galisteo et al.
COMBUSTION AND FLAME (2019)
Numerical study on auto-ignition characteristics of hydrogen-enriched methane under engine-relevant conditions
Yongxiang Zhang et al.
ENERGY CONVERSION AND MANAGEMENT (2019)
Study on flame structures and emission characteristics according to various swirl combinations and fuel compositions in a CH4/H2/CO syngas swirl-stabilized combustor
Minsung Choi et al.
FUEL (2019)
A novel coolant cooling method for enhancing the performance of the gas turbine combined cycle
Seong Won Moon et al.
ENERGY (2018)
New operating strategy for a combined cycle gas turbine power plant
Zuming Liu et al.
ENERGY CONVERSION AND MANAGEMENT (2018)
Simulating combined cycle gas turbine power plants in Aspen HYSYS
Zuming Liu et al.
ENERGY CONVERSION AND MANAGEMENT (2018)
Combustion characteristics of syngas on scaled gas turbine combustor in pressurized condition: Pressure, H2/CO ratio, and N2 dilution of fuel
Seik Park et al.
FUEL PROCESSING TECHNOLOGY (2018)
Performance improvement of gas turbine combined cycle power plant by dual cooling of the inlet air and turbine coolant using an absorption chiller
Hyun Min Kwon et al.
ENERGY (2018)
Effect of fuel nozzle geometry and airflow swirl on the coherent structures of partially premixed methane flame under flashback conditions
Mahmoud M. A. Ahmed et al.
EXPERIMENTAL THERMAL AND FLUID SCIENCE (2018)
Thermo-environmental and economic analyses of an integrated heat recovery steam-injected gas turbine
Ehsan Amiri Rad et al.
ENERGY (2017)
The comparative and combined effects of hydrogen addition on the laminar burning velocities of methane and its blends with ethane and propane
Elna J. K. Nilsson et al.
FUEL (2017)
Effect of fuel distribution on turbulence and combustion characteristics of a micro gas turbine combustor
Minsung Choi et al.
JOURNAL OF INDUSTRIAL AND ENGINEERING CHEMISTRY (2017)
Influence of a recuperator on the performance of the semi-closed oxy-fuel combustion combined cycle
Byeong Seon Choi et al.
APPLIED THERMAL ENGINEERING (2017)
Thermodynamic analysis of a gas turbine engine with a rotating detonation combustor
Jorge Sousa et al.
APPLIED ENERGY (2017)
Development and application of a thermodynamic-cycle performance analysis method of a three-shaft gas turbine
Chun-wei Gu et al.
ENERGY (2016)
Reduction and validation of a chemical kinetic mechanism including necessity analysis and investigation of CH4/C3H8 oxidation at pressures up to 120 bar using a rapid compression machine
Robert F. Pachler et al.
FUEL (2016)
Characteristics of H2-enriched CH4-O2 diffusion flames in a swirl-stabilized gas turbine combustor: Experimental and numerical study
Mansur Aliyu et al.
INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2016)
A comparative study of different dynamic process simulation codes for combined cycle power plants - Part B: Start-up procedure
Falah Alobaid et al.
FUEL (2015)
A comparative study of different dynamic process simulation codes for combined cycle power plants - Part A: Part loads and off-design operation
Falah Alobaid et al.
FUEL (2015)
Operational issues in premixed combustion of hydrogen-enriched and syngas fuels
Tatiana Garcia-Armingol et al.
INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2015)
Influence of steam dilution on the combustion of natural gas and hydrogen in premixed and rich-quench-lean combustors
Sebastian Goeke et al.
FUEL PROCESSING TECHNOLOGY (2013)
Effect of N2/CO2 dilution on laminar burning velocity of H2-air mixtures at high temperatures
Santosh K. Paidi et al.
INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2013)
Development of a gas turbine performance analysis program and its application
Jong Jun Lee et al.
ENERGY (2011)
Effects of syngas type on the operation and performance of a gas turbine in integrated gasification combined cycle
Young Sik Kim et al.
ENERGY CONVERSION AND MANAGEMENT (2011)
Performance analysis of a syngas-fed gas turbine considering the operating limitations of its components
Young Sik Kim et al.
APPLIED ENERGY (2010)
Variable geometry gas turbines for improving the part-load performance of marine combined cycles - Gas turbine performance
F. Haglind
ENERGY (2010)
ASPEN simulation of cogeneration plants
LG Zheng et al.
ENERGY CONVERSION AND MANAGEMENT (2003)
Modeling the air-cooled gas turbine: Part 2 - Coolant flows and losses
JB Young et al.
JOURNAL OF TURBOMACHINERY-TRANSACTIONS OF THE ASME (2002)
Advanced low NOx combustion using highly preheated air
GM Choi et al.
ENERGY CONVERSION AND MANAGEMENT (2001)
Performance prediction of axial flow compressors using stage characteristics and simultaneous calculation sf interstage parameters
TW Song et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART A-JOURNAL OF POWER AND ENERGY (2001)
Share Paper
