Related references
Note: Only part of the references are listed.Comparison of CFD-DEM and TFM approaches for the simulation of the small scale challenge problem 1
Musango Lungu et al.
POWDER TECHNOLOGY (2021)
Modeling the coating layer thickness in a pharmaceutical coating process
S. Madlmeir et al.
EUROPEAN JOURNAL OF PHARMACEUTICAL SCIENCES (2021)
Modeling of inter- and intra-particle coating uniformity in a Wurster fluidized bed by a coupled CFD-DEM-Monte Carlo approach
Zhaochen Jiang et al.
CHEMICAL ENGINEERING SCIENCE (2020)
Validation and application of a multiphase CFD model for hydrodynamics, temperature field and RTD simulation in a pilot -scale biomass pyrolysis vapor phase upgrading reactor
Xi Gao et al.
CHEMICAL ENGINEERING JOURNAL (2020)
Review and implementation of CFD-DEM applied to chemical process systems
Shahab Golshan et al.
CHEMICAL ENGINEERING SCIENCE (2020)
CFD-DEM simulation of gas-solid flow of wet particles in a fluidized bed with immersed tubes
Meng Zhao et al.
CHEMICAL ENGINEERING AND PROCESSING-PROCESS INTENSIFICATION (2020)
Simulation of pellet coating in Wurster coaters
Hamid Reza Norouzi
INTERNATIONAL JOURNAL OF PHARMACEUTICS (2020)
CFD-DEM-PBM coupled model development and validation of a 3D top-spray fluidized bed wet granulation process
Ashutosh Tamrakar et al.
COMPUTERS & CHEMICAL ENGINEERING (2019)
Evaluation of pellet cycle times in a Wurster chamber using a photoluminescence method
Domen Kitak et al.
CHEMICAL ENGINEERING RESEARCH & DESIGN (2018)
Investigation of coating process in Wurster fluidised bed using electrical capacitance tomography
H. Q. Che et al.
CHEMICAL ENGINEERING RESEARCH & DESIGN (2018)
Measurement of moisture content in a fluidized bed dryer using an electrostatic sensor array
Wenbiao Zhang et al.
POWDER TECHNOLOGY (2018)
CFD-DEM study of residence time, droplet deposition, and collision velocity for a binary particle mixture in a Wurster fluidized bed coater
Zhaochen Jiang et al.
DRYING TECHNOLOGY (2018)
CFD-DEM simulation of flow pattern and particle velocity in a fluidized bed with wet particles
Chengxiao Song et al.
POWDER TECHNOLOGY (2017)
DEM-CFD investigation of particle residence time distribution in top-spray fluidised bed granulation
Matthias Boerner et al.
CHEMICAL ENGINEERING SCIENCE (2017)
Improving dissolution kinetics of pharmaceuticals by fluidized bed impregnation of active pharmaceutical ingredients
Plamen I. Grigorov et al.
AICHE JOURNAL (2016)
Bubble Behaviors of Large Cohesive Particles in a 2D Fluidized Bed
Jiliang Ma et al.
INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2016)
Residence time distributions of different size particles in the spray zone of a Wurster fluid bed studied using DEM-CFD
Liang Li et al.
POWDER TECHNOLOGY (2015)
PEPT Study of Particle Cycle and Residence Time Distributions in a Wurster Fluid Bed
Liang Li et al.
AICHE JOURNAL (2015)
Modelling spray coating using a combined CFD-DEM and spherical harmonic formulation
J. E. Hilton et al.
CHEMICAL ENGINEERING SCIENCE (2013)
Estimating coating quality parameters on the basis of pressure drop measurements in a Wurster draft tube
Matjaz Perpar et al.
POWDER TECHNOLOGY (2013)
Open-source MFIX-DEM software for gas-solids flows: Part I-Verification studies
Rahul Garg et al.
POWDER TECHNOLOGY (2012)
Open-source MFIX-DEM software for gas-solids flows: Part II - Validation studies
Tingwen Li et al.
POWDER TECHNOLOGY (2012)
DEM-CFD modeling of a fluidized bed spray granulator
L. Fries et al.
CHEMICAL ENGINEERING SCIENCE (2011)
Application of fluidized bed film coating for membrane encapsulation of catalysts
Maxx Capece et al.
POWDER TECHNOLOGY (2011)
Simulation of char and propane combustion in a fluidized bed by extending DEM-CFD approach
Daoyin Liu et al.
PROCEEDINGS OF THE COMBUSTION INSTITUTE (2011)
Local analysis of the tablet coating process: Impact of operation conditions on film quality
Daniele Suzzi et al.
CHEMICAL ENGINEERING SCIENCE (2010)
The application of modeling techniques to film-coating processes
Richard Turton
DRUG DEVELOPMENT AND INDUSTRIAL PHARMACY (2010)
In-line monitoring of granule moisture in fluidized-bed dryers using microwave resonance technology
Caroline Buschmueller et al.
EUROPEAN JOURNAL OF PHARMACEUTICS AND BIOPHARMACEUTICS (2008)
Measurement of the particle movement in the fountain region of a Wurster type bed
Stina Karlsson et al.
POWDER TECHNOLOGY (2006)
Batch and continuous fluid bed coating - review and state of the art
E Teunou et al.
JOURNAL OF FOOD ENGINEERING (2002)
The prediction of variability occurring in fluidized bed coating equipment. I. The measurement of particle circulation rates in a bottom-spray fluidized bed coater
XX Cheng et al.
PHARMACEUTICAL DEVELOPMENT AND TECHNOLOGY (2000)
Share Paper
