☆ 4.7 Article

Controlled sintering and phase transformation of yttria-doped tetragonal zirconia polycrystal material

CERAMICS INTERNATIONAL (2021)

Related references

Note: Only part of the references are listed.

Article Materials Science, Ceramics

Phase stability and microstructure morphology of microwave-sintered magnesia-partially stabilised zirconia

Guo Chen et al.

Summary: This study introduced microwave heating into the preparation process of zirconia materials to improve stability and microstructure of MgO-partially stabilised zirconia (MgO-PSZ). The effects of microwave heating on phase stability, microstructure, and surface morphology were evaluated, showing that microwave treatment significantly increased the stability rate of MgO-PSZ sample. Additionally, a decrease in m-ZrO2 phase content and improvement in microstructure were observed in the microwave-sintered MgO-PSZ sample. This research provided optimal microwave heating conditions for enhanced performance of MgO-PSZ material and laid a foundation for further research on zirconia materials prepared using microwave heating technology.

CERAMICS INTERNATIONAL (2021)

Add to Collection

Article Agricultural Engineering

Kinetics characteristics and microwave reduction behavior of walnut shell-pyrolusite blends

Kangqiang Li et al.

Summary: The study shows that combining biomass pyrolysis with microwave heating technologies is an efficient way to reduce low-grade pyrolusite. The optimal reduction parameters include a reduction temperature of 650 degrees C, a holding time of 30 min, a M-bio/M-ore ratio of 1.8:10, and a microwave power of 1200 W.

BIORESOURCE TECHNOLOGY (2021)

Add to Collection

Article Materials Science, Ceramics

Optimisation on the stability of CaO-doped partially stabilised zirconia by microwave heating

Yeqing Ling et al.

Summary: The study utilized controllable microwave heating to improve the stability of partially stabilized zirconia, and found that the stability increased with higher heating temperatures. Experimental results indicated that the martensitic transformation temperature of zirconia was reduced under microwave radiation.

CERAMICS INTERNATIONAL (2021)

Add to Collection

Article Materials Science, Ceramics

Effect of doping CeO2 and Sc2O3 on structure, thermal properties and sintering resistance of YSZ

Xiaodong Wei et al.

Summary: This paper investigated the effects of CeO2 and Sc2O3 doping on YSZ, where CeO2 increased cell volume and tetragonal degree while Sc2O3 had the opposite effect. The results showed that co-doping with CeO2 and Sc2O3 improved thermal conductivity and provided stability against phase transformation, making CeScYSZ an ideal material for thermal protection at higher temperatures.

CERAMICS INTERNATIONAL (2021)

Add to Collection

Article Materials Science, Ceramics

Influence of compatibility between sol and intermediate layer on the performance of yttria-stabilized zirconia nanofiltration membrane

Xiaowei Da et al.

Summary: This paper investigates the synergistic effect of the sol and intermediate layer on the performance of YSZ nanofiltration membranes. It was found that the performance of YSZ membranes strongly depends on the sol concentration and the pore size of the intermediate layer. Maintaining compatibility between the sol and intermediate layer is essential for fabricating high-performance NF membranes.

CERAMICS INTERNATIONAL (2021)

Add to Collection

Article Materials Science, Ceramics

One-step preparation of CaO-doped partially stabilized zirconia from fused zirconia

Kangqiang Li et al.

CERAMICS INTERNATIONAL (2020)

Add to Collection

Article Materials Science, Ceramics

X-ray diffraction analysis of the yttria stabilized zirconia powder by mechanical alloying and sintering

Guangdi Zhou et al.

CERAMICS INTERNATIONAL (2020)

Add to Collection

Article Materials Science, Ceramics

Tetragonal phase stability maps of ceria-yttria co-doped zirconia: From powders to sintered ceramics

Peyman Khajavi et al.

CERAMICS INTERNATIONAL (2020)

Add to Collection

Article Materials Science, Multidisciplinary

Effects of chelating agents on the sol-gel synthesis of nano-zirconia: Comparison of the Pechini and sugar-based methods

Faramarz Kazemi et al.

INTERNATIONAL JOURNAL OF MINERALS METALLURGY AND MATERIALS (2020)

Add to Collection

Article Materials Science, Ceramics

Continuous alumina fiber-reinforced yttria-stabilized zirconia composites with high density and toughness

Xuewu Li et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2020)

Add to Collection

Article Materials Science, Multidisciplinary

Crystalline texture evolution, control of the tribocorrosion behavior, and significant enhancement of the abrasion properties of a Ni-P nanocomposite coating enhanced by zirconia nanoparticles

Masoud Sabzi et al.

INTERNATIONAL JOURNAL OF MINERALS METALLURGY AND MATERIALS (2019)

Add to Collection

Article Materials Science, Multidisciplinary

Robocasting of dense yttria-stabilized zirconia structures

Erwin Peng et al.

JOURNAL OF MATERIALS SCIENCE (2018)

Add to Collection

Article Materials Science, Ceramics

Microstructure and mechanical properties of in-situ grown mullite toughened 3Y-TZP zirconia ceramics fabricated by gelcasting

Peng-fei Liu et al.

CERAMICS INTERNATIONAL (2018)

Add to Collection

Article Materials Science, Ceramics

Effect of calcia co-doping on ceria-stabilized zirconia

Miquel Turon-Vinas et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2018)

Add to Collection

Article Materials Science, Multidisciplinary

Analysis and optimization of dry sliding wear characteristics of zirconia reinforced alumina composites formed by conventional sintering using response surface method

S. Renold Elsen et al.

INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2016)

Add to Collection

Article Materials Science, Ceramics

Toughening effect of multiwall carbon nanotubes on 3Y-TZP zirconia ceramics at cryogenic temperatures

Weiwei Wu et al.

CERAMICS INTERNATIONAL (2015)

Add to Collection

Article Materials Science, Ceramics

Fracture toughness of 3 mol% yttria-stabilized zirconia at cryogenic temperatures

Weijiang Xue et al.

CERAMICS INTERNATIONAL (2015)

Add to Collection

Article Materials Science, Ceramics

Change in the phase composition, structure and mechanical properties of directed melt crystallised partially stabilised zirconia crystals depending on the concentration of Y2O3

M. A. Borik et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2015)

Add to Collection

Article Materials Science, Ceramics

Toughening effect of multi-walled boron nitride nanotubes and their influence on the sintering behaviour of 3Y-TZP zirconia ceramics

Peter Tatarko et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2014)

Add to Collection

Article Materials Science, Ceramics

Preparation of fully cubic calcium-stabilized zirconia with 10 mol% calcium oxide dopant concentration by microwave processing

Anirudh P. Singh et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2007)

Add to Collection

Review Materials Science, Multidisciplinary

Toughening of yttria-stabilised tetragonal zirconia ceramics

B Basu

INTERNATIONAL MATERIALS REVIEWS (2005)

Add to Collection

Article Materials Science, Ceramics

Microstructure-toughness-wear relationship of tetragonal zirconia ceramics

B Basu et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2004)

Add to Collection

Article Materials Science, Multidisciplinary

Fracture toughness and hardness of ceria- and yttria-doped tetragonal zirconia ceramics

JD Lin et al.

MATERIALS CHEMISTRY AND PHYSICS (2003)

Add to Collection

Article Materials Science, Ceramics

Toughening of alumina /zirconia ceramic composites with silver particles

J Lalande et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2002)

Add to Collection

© Peeref 2019-2024. All rights reserved.