4.7 Article

Aerodynamic reduced-order Volterra model of an ornithopter under high-amplitude flapping

Journal

AEROSPACE SCIENCE AND TECHNOLOGY
Volume 121, Issue -, Pages -

Publisher

ELSEVIER FRANCE-EDITIONS SCIENTIFIQUES MEDICALES ELSEVIER
DOI: 10.1016/j.ast.2022.107331

Keywords

Ornithopter aerodynamics; Large flapping amplitude; Bio-inspired UAV; Volterra model

Funding

  1. European Project GRIFFIN ERC Advanced Grant 2017 [788247]

Ask authors/readers for more resources

The unsteady aerodynamics of flapping low-aspect-ratio ellipsoidal-wings in ornithopters is analyzed and modeled using three-dimensional Computational Fluid Dynamics (CFD) simulations. The results show that analytical models based on absence of viscosity and small perturbations are not appropriate for the range of interest, and a finite memory Volterra model is identified to predict the characteristics of forces and moments produced by the flapping wing.
The unsteady aerodynamics of flapping low-aspect-ratio ellipsoidal-wings in ornithopters is analyzed and modeled by the use of three dimensional Computational Fluid Dynamics (CFD) simulations. The range of interest is high amplitude, moderate frequency flapping, and low to moderate angles of attack at Reynolds around 10(5), where autonomous ornithopters like GRIFFIN are able to perform complex maneuvers such as perching. The results obtained show that the Leading Edge Vortex is produced above a certain Strouhal and angle of attack at downstroke. The frequency response of the aerodynamic loads are compared with the classical analytical models, observing that analytical models based on absence of viscosity and small perturbations are not appropriate for the range of interest. Through the 3D CFD aerodynamic loads database, a finite memory Volterra model is identified in order to predict the characteristics of forces and moments produced by the flapping wing. A good agreement with the 3D CFD simulations has been found by considering a reduced-order model depending on the effective angle of attack of the surrogate airfoil located at 70% of the semi-span at three-quarters chord on the airfoil, in agreement with the literature. Finally, a methodology for validation with a high-accuracy Motion Capture System and without the need of wind tunnel is proposed. As a result the proposed model provides better estimates than classical analytical ones. (C) 2022 The Author(s). Published by Elsevier Masson SAS.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available