Abrasive Waterjet (AWJ) Forces-Potential Indicators of Machining Quality

The necessity of monitoring the abrasive waterjet (AWJ) processes increases with the spreading of this tool into the machining processes. The forces produced on the workpiece during the abrasive waterjet machining can yield some valuable information. Therefore, a special waterjet-force measuring device designed and produced in the past has been used for the presented research. It was tested during the AWJ cutting processes, because they are the most common and the best described up-to-date AWJ applications. Deep studies of both the cutting process and the respective force signals led to the decision that the most appropriate indication factor is the tangential-to-normal force ratio (TNR). Three theorems concerning the TNR were formulated and investigated. The first theorem states that the TNR strongly depends on the actual-to-limit traverse speed ratio. The second theorem claims that the TNR relates to the cutting-to-deformation wear ratio inside the kerf. The third theorem states that the TNR value changes when the cutting head and the respective jet axis are tilted so that a part of the jet velocity vector projects into the traverse speed direction. It is assumed that the cutting-to-deformation wear ratio increases in a certain range of tilting angles of the cutting head. This theorem is supported by measured data and can be utilized in practice for the development of a new method for the monitoring of the abrasive waterjet cutting operations. Comparing the tilted and the non-tilted jet, we detected the increase of the TNR average value from 1.28 +/- 0.16 (determined for the declination angle 20 degrees and the respective tilting angle 10 degrees) up to 2.02 +/- 0.25 (for the declination angle 30 degrees and the respective tilting angle of 15 degrees). This finding supports the previously predicted and published assumptions that the tilting of the cutting head enables an increase of the cutting wear mode inside the forming kerf, making the process more efficient.

Automated summary

Monitoring the abrasive waterjet (AWJ) cutting processes is becoming more necessary as the tool is increasingly used in machining operations. An investigation into the tangential-to-normal force ratio (TNR) in relation to different cutting conditions yielded three theorems, showing the TNR's strong correlation with traverse speed ratio, cutting-to-deformation wear ratio, and cutting head tilting angle. Experimental data supported the assertion that tilting the cutting head increases TNR, making the cutting process more efficient.