Journal
WATER AIR AND SOIL POLLUTION
Volume 232, Issue 8, Pages -Publisher
SPRINGER INTERNATIONAL PUBLISHING AG
DOI: 10.1007/s11270-021-05267-0
Keywords
Microplastics; Toxicity; Chlorella sp; Growth inhibition
Funding
- Croatian Science Foundation [IP-2019-04-9661]
Ask authors/readers for more resources
Plastic pollution is a global environmental issue and research shows that different plastics have varying effects on the growth of freshwater microalgae, being influenced by both concentration and particle size. Among the tested plastics, PVC had the greatest impact, while PP was mostly affected by concentration.
An extensive use of plastic material, which is a characteristic of modern society, is increasing the amount of plastic waste in the environment. Accordingly, plastic pollution has become a global environmental problem. The problem is particularly related to microsized and nanosized plastic particles which have become environmental contaminants of emerging concern. This research was focused on ecotoxicological aspects of 5 the most common plastic substances: polyethylene (PE), polypropylene (PP), polystyrene (PS), polyvinyl chloride (PVC), and polyethylene terephthalate (PET); all substances were in form of microplastics. The used test organism was freshwater microalgae Chlorella sp. and inhibition of the algal growth after 3-day exposure was measured. The experimental domain included microplastics in range 10-1000 mg/L and sizes 100-700 mu m. Response surface modeling was applied in order to analyze the influence of these two parameters and statistical analysis of the obtained models was performed. The significance level was 95%. The obtained inhibitions were relatively low (< 6.79%) but Chlorella sp. showed sensitivity to changes in both tested parameters. A general behavior that included inhibition increase with higher concentration values and lower particle sizes was observed. The exception was PP where only the concentration proved to be significant parameter; the influence of the particle size remained insignificant for the selected experimental domain. Hormesis appears likely in PE and PP cases at particle sizes and concentrations that are below the experimental domain. Determined adverse influence of the applied plastics followed the order: PVC > PET > PS > PE > PP.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available