3D-printed B4C collimation for neutron pressure cells

A design for an incident-beam collimator for the Paris-Edinburgh pressure cell is described here. This design can be fabricated from reaction-bonded B4C but also through fast turnaround, inexpensive 3D-printing. 3D-printing thereby also offers the opportunity of composite collimators whereby the tip closest to the sample can exhibit even better neutronic characteristics. Here, we characterize four such collimators: one from reaction-bonded B4C, one 3D-printed and fully infiltrated with cyanoacrylate, a glue, one with a glue-free tip, and one with a tip made from enriched (B4C)-B-10. The collimators are evaluated on the Spallation Neutrons and Pressure Diffractometer of the Spallation Neutron Source and the Wide-Angle Neutron Diffractometer at the High Flux Isotope Reactor, both at Oak Ridge National Laboratory. This work clearly shows that 3D-printed collimators perform well and also that composite collimators improve performance even further. Beyond use in the Paris-Edinburgh cell, these findings also open new avenues for collimator designs as clearly more complex shapes are possible through 3D printing. An example of such is shown here with a collimator made for single-crystal samples measured inside a diamond anvil cell. These developments are expected to be highly advantageous for future experimentation in high pressure and other extreme environments and even for the design and deployment of new neutron scattering instruments. Published under an exclusive license by AIP Publishing.

Automated summary

This article describes the design of an incident-beam collimator for the Paris-Edinburgh pressure cell, which can be fabricated from reaction-bonded B4C or through 3D printing. It also discusses how composite collimators can improve performance and open up new possibilities for collimator design. The study demonstrates that 3D-printed collimators perform well and highlights the potential of 3D printing for creating more complex collimator shapes.